Royal HT700X Quick start guide

379 Campus Dr.
Somerset, NJ. 08873-1125
HT700XIM903JH rev2
ROYAL®HT700X
crosscut shredder
HT700 crosscut shredder
OPERATIONAL
MANUAL
ROYAL PAPER SHREDDERWARRANTY Continued
LABOR: Royal provides labor warranty forONE YEAR
from date of end-user purchase.Product must be sent postage
prepaid and insured to Royal. At completion of the repair, the
consumer will be responsible for return shipping charges from
Royal, and for any parts or services no longer covered under warranty.
This warranty does not apply to persons who purchased this product second hand or used.
This warranty does not include adjustments, parts and repair by circumstances beyond
the control of Royal, including but not limited to, fire, or other casualty, accident, neglect, abuse,
abnormal use or battery leakage damage.
THERE ARE NO OTHER EXPRESSED WARRANTIES EXCEPT AS STATED HEREIN.AFTER
THE PERIOD OF EXPRESSED WARRANTY SET FORTH HEREIN, THERE ARE NO
EXPRESSED OR IMPLIED WARRANTIES AND THOSE EXCLUDED INCLUDETHOSE OF
MERCHANTABILITY AND FITNESS FOR PARTICULAR PURPOSE.Royal shall NOT be held
liable for CONSEQUENTIAL DAMAGES resulting from any failure, defect or malfunction of this
product. Some States do not allow limitations on how long an implied warranty lasts and some
States do not allow the exclusion or limitation of incidental or consequential damages, so the
above limitations may not apply to you.
WARRANTY PROCEDURES:
Royal has taken great care to insure the product you have purchased will provide years of
trouble-free service. Should the product require service within the first 30 days after purchase,
Royal strongly recommends you return the product to the place of
purchase for replacement.Please note this 30-day replacement period may be subject to the
limitations of the return policy that has been established by your retailer, may not be available
at your retailer, or may be for a different period of time as
established by your retailer.Your retailer may allow exchanges past this 30-day period.Should
this be the case, Royal strongly recommends you return the product to the place of purchase
for replacement.
TO OBTAIN SERVICE UNDERTHETERMS OFTHIS WARRANTY:
In the event you are unable to obtain a replacement product from your retailer, please do the
following:
1. Send a copy of your original sales receipt showing
original purchase date along with your mailing address
and a note describing the nature of the problem to:
Royal Consumer Information Products, Inc.
Warranty Processing
PO Box 161
Jamison, PA 18929-0161
DO NOT RETURN THE PRODUCT TOTHIS ADDRESS!
2. You will receive a return authorization number within 7-10 business days from the date your
return request is received if it is determined that there is a basis for a replacement product.
The return authorization form you receive will list the return procedures, applicable charges,
if any, and the correct shipping address for the returned product. Product must be sent
posta
g
e
and insured
to Royal or the nearest Authorized Service Center.The Service
Center or Royal cannot be held responsible for any loss or damaged machines in transit.
To contact an Authorized Service Center in you area, call toll free 1 [phone].
PRODUCT SUPPORT HOTLINE:
For questions on use of this product call 732-563-9944 Monday through Friday between the
hours of 8:30AM and 5:00PM
ROYAL®
Consumer Information Products, Inc.
HT700 crosscut shredder
7 sheet maximun

12
ROYAL HT700X PAPER SHREDDER
Setup:
1. Place the shredder securely on top of the wastebasket. Be sure not to
allow your fingers to get between the basket and the shredder as you
are placing the shredder in place.
2. Plug the power cord into any standard 115-volt AC outlet.
3. Place the Main Switch in the AUTO position. The green LED should
illuminate. If the LED does not light up, lift the shredder out of the
wastebasket and place it back in so that it sits flush inside of the
wastebasket.
Operating the shredder:
The Main Switch is located on the top of the shredder. The Main Switch
has three (3) settings.
1. When AUTO is selected, the shredding process is started automatically
by inserting the paper into the feed opening. The shredder will stop
automatically when the paper has completed its travel through the feed
opening.
2. REV is used to assist in the removal of a paper jam, which reverses the
shredding process prior to a completed cycle, thus clearing the cutters.
3. OFF position is recommended when emptying the wastebasket or when
the shredder is not in use for a prolonged period of time.
O position only
.
Shredder capacity:
HT700X will shred seven (7) sheets of 20-lb. bond paper and will accept paper
widths up to 8 3/4". When shredding small material like envelopes or credit
cards and receipts, insert them through the middle of the feed opening.
Cautions:
1. Keep all loose articles of clothing, ties, jewelry, hair or other small items
away from the feed opening to prevent injury.
2. Keep in the OFF position when the shredder is not in use for prolonged
periods of time.
3. Remove all paper clips from paper before shredding. Unit will cut small
paper clips however it is not recommended.
4. Do not place hands or fingers into the shredder throat as serious injury
could result.
5. Continuous shredding of computer paper should not exceed 2 minutes.
If continuous use is required, it is recommend that the shredding time
should be 2 minute on and 4 minute off to allow for proper cooling of
the motor.
6. Always turn off or unplug the shredder prior to moving, cleaning or
emptying the wastebasket.
7. Empty wastebasket frequently.
1.Operating the shredder at the maximum capacity continuously for a
prolonged period of time, eg. more than 2 minutes without stopping.
2.Exceeding the shredding capacity, eg. inserting more than seven (7) sheets
of 20-lb. paper at one pass, or if the paper is not fed squarely into the
feed opening.
Both abnormal operations may result in the activation of the automatic motor
overload protection, which terminates the power to the unit. If this occurs you
should:
1. Unplug the power cord from the AC outlet and wait at least 4 minutes
for the overload protection to reset. Tear or cut off any excess paper from
the top of the shredder.
2. Plug the power cord back into the AC outlet and place the Main Switch in
REV. Pull the remaining paper out of the cutters. Place the Main Switch
back to the Auto position and if neccessary
clear the feed opening of any remaining shredded pieces of paper. Keep
fingers away from feed opening to avoid harm.
3.With the Main Switch in the AUTO position and the feed opening clear, you
are now ready to resume normal shredding.
Specifications:
Shred Type: Cross-Cut
Shred Width: 5/32" X 1 5/8" or 4m x 42mm
Shredding Capacity: 7 Sheets or 1 Credit Card
Feed Opening: 8 3/4" or 222mm
Input:115 volt AC, 1.85 amp.
ROYAL HT700X PAPER SHREDDER
Paper jams and overload protection:
HT700X is equipped with a motor overload protection device. The normal short
duty cycle for continuous shredding at maximum capacity is 2 minutes on and
4 minutes off. The power may terminate automatically in case of the following
abnormal situations:
ROYAL PAPER SHREDDERWARRANTY
PLEASE FILL OUT AND RETURNTHE WARRANTY CARD INCLUDED WITHYOUR NEW ROYAL
PRODUCT OR FILL OUTTHE WARRANTY REGISTRATIONFORM ONTHE ROYAL WEB PAGE
ATWWW.ROYAL.COM.IT ENTITLESYOUTO PRODUCT WARRANTY AND TECHNICAL SUPPORT
UNDER THE TERMS AND CONDITIONS DESCRIBED HEREIN.
BE SURETO KEEP A COPY OFYOUR SALES RECEIPT!
STANDARDWARRANTY:
OLIVETTI OFFICE USA, Inc. d/b/a ROYAL CONSUMER INFORMATION PRODUCTS ("Royal"),
765 US Highway 202, Bridgewater, NJ, 08807 WARRANTS that your NEW Royal product is free
of defects of workmanship and materials. If there is a defect or malfunction of this product, Royal
will repair it free of charge as follows:
PARTS: New or comparable rebuilt parts in exchange for defective parts for ONEYEAR from date
of customer purchase