RP LIGHTING 1070 User manual

4
5. HANGING THE FAN
REMEMBER to turn off the power. Follow the steps
below to hang your fan properly. NOTE: This ceiling
fan is supplied with the hanging assemblies;
the standard ceiling installation using the downrod
with ball and hanger bracket mounting
installation.
STANDARD CEILING INSTALLATION
Step 1. Pass the 120-volt supply wires through the
center hole in the ceiling hanger bracket as shown in
Fig. 5.
Step 2. Secure the hanger bracket to the ceiling
outlet box with the screws and washers included
with mounting hardware (Fig.5).
Step 3. Remove the hanger pin, lock pin and set
screws from the top of the motor assembly.
Step 4. Route wires and safety cable exiting from the
top of the fan motor through the canopy, coupling
cover and then through the ball/downrod. (Fig. 6)
Step 5. Align the holes at the bottom of the downrod
with the holes in the collar on top of the motor
housing. Carefully insert the hitch pin through the
holes in the collar and downrod. Be careful not to
jam the pin against the wiring inside the downrod.
Insert the locking pin through the hole near the end
of the hitch pin until it snaps into its locked position.
(Fig. 6)
Step 6. Tighten two set screws on top of the fan
motor firmly.
Figure 6
Downrod
Canopy
Set screws
Hitch
pin
Lock
pin
Figure 7
Registration slot
Coupling cover
Safety Cable
Safety cable
“J” hook
Collar
Motor
Step 7. Install the “J ” hook (not provided) to the Ceiling
near the hanger bracket. Place the downrod ball into
the hanger bracket socket. Tie the safety cable to the
“J” hook (not provided). Then will allow you to make the
electrical connections. (Fig. 7)