Russell Hobbs RHOMF8 Installation instructions manual

1"
"
"
INSTRUCTIONS & WARRANTY
"
"
"
MODEL NO: RHOMF8
RUSSEL HOBBS OUTDOOR MIST FAN
Congratulations on purchasing our Russell Hobbs Outdoor Mist Fan. Each unit is
manufactured to ensure safety and reliability. Before using this appliance for the first time,

2"
"
please read the instruction manual carefully and keep it for future reference.
FEATURES OF RUSSELL HOBBS OUTDOOR MIST FAN
1. 18’’ Outdoor mist fan
2. Suitable for domestic use only
3. Humidifier with 7L water tank
4. Generates mist for up to 5,5 hours
5. 4 Speed settings
6. Oscillating function
7. Castors for ease of movement
8. 3 Large industrial blades
9. Overheat protection
10. 230W
IMPORTANT SAFEGUARDS
When using any electrical appliance, basic safety precautions should always be followed
including the following:
1. Please read the instructions carefully before using any appliance.
2. Use the fan only for purposes described in the instruction manual.
3. Always ensure that the voltage on the rating label corresponds to the mains
voltage in your home.
4. Incorrect operation and improper use can damage the appliance and cause
injury to the user.
5. The appliance is intended for household use only. Commercial use
invalidates the warranty and the supplier cannot be held responsible for injury
or damage caused when using the appliance for any other purpose than that
intended.
6. This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
7. Avoid any contact with moving parts.
8. To reduce the risk of fire or electric shock, do not use this fan with any solid-
state speed control device.

3"
"
9. To protect against electrical shock, do not immerse the fan, plug or cord in
water or any other liquid or spray with liquids.
10. Children should be supervised to ensure that they do not play with the
appliance
11. Close supervision is required when any appliance is used near or by children,
pets and invalids.
12. Check the power cord and plug regularly for any damage. If the cord or the
plug is damaged, it must be replaced by the manufacturer or a qualified
person in order to avoid an electrical hazard.
13. Do not operate the fan in the presence of explosive and/or flammable fumes.
14. Do not use the appliance if it has been dropped or damaged in any way. In
case of damage, take the unit in for examination and/or repair by an
authorised service agent
15. Place the fan on a dry level surface
16. Do not hang or mount fan on a wall or ceiling
17. Remove the plug from the socket by gripping the plug. Do not pull on the cord
to disconnect the appliance from the mains. Always unplug the fan when not
in use, before cleaning or when adding or removing parts.
18. The use of accessory attachments that are not recommended or supplied by
the manufacturer may result in injuries, fire or electric shock.
19. A short cord is provided to reduce the hazards resulting from becoming
entangled in or tripping over a longer cord.
20. Do not allow the cord to touch hot surfaces and do not place on or near a hot
gas or electric burner or in a heated oven.
21. Use of an extension cord with this appliance is not recommended. However, if
it is necessary to use an extension lead, ensure that the lead is suited to the
power consumption of the appliance to avoid overheating of the extension
cord, appliance or plug point. Do not place the extension cord in a position
where it can be pulled on by children or animals or tripped over.
22. This appliance is not suitable for outdoor use. Do not use this appliance for
anything other than its intended use.
23. Do not carry the appliance by the power cord.
24. Do not leave this appliance unattended during use. Always unplug the unit
when not in use or before cleaning.
25. Always operate the appliance on a smooth, even, stable surface. Do not
place the unit on a hot surface.
26. Ensure that the switch is in “Off” position after each use.

4"
"
19"
20"
27. The manufacturer does not accept responsibility for any damage or injury
caused by improper or incorrect use, or for repairs carried out by
unauthorised personnel.
28. In case of technical problems, switch off the appliance and do not attempt to
repair it yourself. Return the appliance to an authorised service facility for
examination, adjustment or repair. Always insist on the use of original spare
parts. Failure to comply with the above mentioned pre-cautions and
instructions, could affect the safe operation of this appliance.
29. Do not touch/ pull out/ put back the water tank when the unit is plugged into
the power source. Make sure it is physically disconnected from the mains
before you do anything with the water tank.
30. When the water level is too low, the safety switch will stop the operation of the
mist function, unplug the unit and refill the water tank for further operation.
31. Do not let dust or other substances collect on the mist plate – if the outlet is
blocked, the mist function will fail to function normally.
32. Before cleaning the unit, make sure that it is completely disconnected from
the plug. Make sure your hands are not wet when unplugging the unit.
33. Do not use hot water in the water tank.
34. Do not add any chemicals, oils or other additives to the water tank.
PARTS DIAGRAM
1. Mist outlet
2. 18 inch front fan guard

5"
"
3. Screw
4. 18 inch AL blades
5. Iron belt
6. M6 screw
7. 18 inch rear fan guard
8. Motor
9. Wire box
10. Wire
11. M5 screw
12. Fan body
13. Base
14. M8 screw
15. Wheel
16. Screw
17. Hose
18. Buckle
19. Screw
20. Tube
ASSEMBLY INSTRUCTIONS
1. Assemble the wheel (15) to the base (13) with the screw.
2. Assemble the fan body (12) and fit it to the base (13) with a screw (14).
3. Connect the internal wires (10) to motor assembly (8). Connect the wire box
(9) to the fan body (12) and then assemble the motor (8) to the fan body (12)
with the screws (11).
4. Assemble the rear fan guard (7) to the motor (8).
5. Assemble the blades (4) onto the motor (8).
6. Fasten the mist outlet (1) on the front fan guard (2) and then fasten the fan
guard (2) and (7) with the iron belt (5) and buckle (18).
7. Insert the hose (17) into the mist outlet (1) and insert the other side to the fan
body (12).
8. Fasten the tube (20) to the body with the screw (19).”
BEFORE FIRST USE
1. First ensure that the body is attached to the base.
2. The fan head must be fixed to the main part of the structure pole.

6"
"
3. Install the back fan guard to the motor housing, slide on aluminum blades and
ensure the screw is tightened.
OPERATING INSTRUCTIONS
Place the water tank on a flat surface and fill with water as per below steps：
1. Remove the mist tank on upper side , the mist function will be cut off automatically
when the water tank is removed from the body
2. Pour the water into the water tank.
3. Ensure that the water level does not reach be beyond the max indication.
4. After filling the water, close the mist cask and connect the mist tube.
Attention: Please check carefully to ensure the tank is not overfilled and there is no water
running down the back side of the tank.
1. Oscillation switch

7"
"
2. Mist button
3. Speed button
4. Angle adjustment lock nut
5. Insert the plug into the socket and turn on the fan, choose the function button to
select the fan speed accordingly.
6. Speed button (3)：Operate this button and choose the fan speed level 1,2,3,4
7. Turn on mist switch (2); the mist will spray out from the mist outlet, “the mist” function
can be used separately or in conjunction with the fan. If the mist function is used
separately, it will increase the humidity in the air.
8. Switch on the oscillation switch (1), to change the wind direction. Switch off again to
stop oscillation.
9. Angle adjustment: Adjust the fan guard direction to move the wind angle of the fan. If
necessary slacken the lock nut (4) with a spanner, change the angle and then tighten
the nut again
CLEANING AND MAINTANACE
1. Screw
2. Overflow gap
3. Water release hole
4. Shell
5. Water tank
6. Mist tank
7. Upper water outlet
8. Lower water outlet
9. Max water level
10. Wind outlet
11. Mist maker
12. Cleanser
13. Mist disk
14. Brush

8"
"
Before cleaning, turn the unit off, unplug from the power supply and wait for the unit to cool
down.
1. To clean the unit use a soft cloth to wipe off any dust.
2. Clean the water tank every two or three weeks, and clean the flume every week.
3. Remove the plastic tube from mist tank and remove the water tank to clean it.
4. Open the tank cover, use dry cloth to clean the mist tank or use mild detergent to
clean the mist tank if it has mineral water residue.
5. Please add a few drops of lubricant to the motor shaft after cleaning it to extend
motor life.
Keep the unit in a cool and dry place when not to be used for a long time.
CAUTION: Unplug fan from the electrical supply source before cleaning. After servicing, any
safety device (including grilles and blades) it must be reinstalled or remounted as previously
installed. Use soft damp cloth then wipe with dry cloth. Do not use harmful detergents. Do
not bend the blades.
STORING THE APPLIANCE
• Unplug the unit from the wall outlet and clean all the parts as instructed above.
Ensure that all parts are dry before storing.
• Store the appliance in its box or in a clean, dry place.
• Never store the appliance while it is still wet or dirty.
SERVICING THE APPLIANCE
There are no user serviceable parts in this appliance. If the unit is not operating correctly,
please check the following:
• You have followed the instructions correctly
• That the unit has been wired correctly and that the wall socket is switched on.
• That the mains power supply is ON.
• That the plug is firmly in the mains socket.
If the appliance still does not work after checking the above:
- Consult the retailer for possible repair or replacement. If the retailer fails to resolve the
problem and you need to return the appliance, make sure that:
• The unit is packed carefully back into its original packaging.

9"
"
• Proof of purchase is attached.
• A reason is provided for why it is being returned.
If the supply cord is damaged, it must be replaced by the manufacturer or an authorised
service agent, in order to avoid any hazard. If service becomes necessary within the
warranty period, the appliance should be returned to an approved Home Of Living Brands
(Pty) Limited service centre. Servicing outside the warranty period is still available, but will,
however, be chargeable.
CHANGING THE PLUG
Should the need arise to change the fitted plug, follow the instructions below.
This unit is designed to operate on the stated current only. Connecting to other power
sources may damage the appliance. Connect a three-pin plug as follows:
The wires in this mains lead are
coloured in accordance with the
following code:
Green/Yellow = Earth
Blue = Neutral
Brown = Live
"
"

10"
"
PLEASE AFFIX YOUR PROOF OF PURCHASE/RECEIPT HERE
IN THE EVENT OF A CLAIM UNDER WARRANTY THIS RECEIPT MUST BE
PRODUCED.
W A R R A N T Y
6. Home Of Living Brands (Pty) Limited warrants to the original purchaser of this
product (“the customer”) that this product will be free of defects in quality and
workmanship which under normal personal, family or household use and purpose
may manifest within a period of 1 (one) year from the date of purchase (“warranty
period”).
7. Where the customer has purchased a product and it breaks, is defective or does
not work properly for the intended purpose, the customer must notify the supplier
from whom the customer bought the product (“the supplier”) thereof within the
warranty period. Any claim in terms of this warranty must be supported by a proof
of purchase. If proof of purchase is not available, then repair, and/or service
charges may be payable by the customer to the supplier.
8. The faulty product must be taken to the supplier's service centre to exercise the
warranty.
9. The supplier will refund, repair or exchange the product in terms of this warranty
subject to legislative requirements. This warranty shall be valid only where the
customer has not broken the product himself, or used the product for something
that it is not supposed to be used for. The warranty does not include and will not
be construed to cover products damaged as a result of disaster, misuse, tamper,
abuse or any unauthorised modification or repair of the product.
10. This warranty will extend only to the product provided at the date of the purchase
and not to any expendables attached or installed by the customer.
11. If the customer requests that the supplier repairs the product and the product
breaks or fails to work properly within 3 (three) months of the repair and not as a
result of misuse, tampering or modification by or on behalf of the customer, then
the supplier may replace the product or pay a refund to the customer.
12. The customer may be responsible for certain costs where products returned are
not in the original packaging, or if the packaging is damaged. This will be
deducted from any refund paid to the customer.
HOME OF LIVING BRANDS (PTY) LTD
www.homeoflivingbrands.co.za
011 490-9600 (Jhb)
031 303-1163 (Dbn)
021 552-5161 (CT)
www.russellhobbs.co.za
www.facebook.com/RussellHobbsSA