Russell Hobbs RHFH505 Installation guide

INSTRUCTIONS AND WARRANTY
MODEL NO. RHFH505
DESCRIPTION: CERAMIC FAN HEATER

2
Congratulations on purchasing our Elegant Tower fan Heater. Each unit is manufactured
to ensure safety and reliability. Before using this appliance for the first time, please read
the instruction manual carefully and keep it for future reference.
FEATURES OF THE RUSSELL HOBBS ELEGANT TOWER FAN
HEATER
IMPORTANT SAFEGUARDS
When using any electrical appliance, basic safety precautions should always be followed
including the following:
1. Please read the instructions carefully before using any appliance.
2. Always ensure that the voltage on the rating label corresponds to the mains
voltage in your home.
3. Incorrect operation and improper use can damage the fan heater and cause
injury to the user.
4. The fan heater is intended for household use only. Commercial use invalids the
warranty and the supplier cannot be held responsible for injury or damage
caused when using the fan heater for any other purpose than that intended.
5. Avoid any contact with moving parts.
6. This fan heater is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
7. Children should be supervised to ensure that they do not play with the heater.
8. Check the power cord and plug regularly for any damage. If the cord or the plug
is damaged, the manufacturer or a qualified person must replace it in order to
avoid an electrical hazard.
9. Do not use the fan heater if it has been dropped or damaged in any way. In case
of damage, take the unit in for examination and/or repair by an authorised service
agent
10. To reduce the risk of electric shock, do not immerse or expose the motor
assembly, plug or the power cord to water or any other liquid.

3
11. Never immerse the unit in water or any other liquid for cleaning purposes.
12. Remove the plug from the socket by gripping the plug. Do not pull on the cord to
disconnect the fan heater from the mains. Always unplug the unit when not in
use, before cleaning or when adding or removing parts.
13. The use of accessory attachments that are not recommended or supplied by the
manufacturer may result in injuries, fire or electric shock.
14. A short cord is provided to reduce the hazards resulting from becoming
entangled in or tripping over a longer cord.
15. Do not let the cord hang over the edge of a table or counter. Ensure that the cord
is not in a position where it can be pulled on inadvertently.
16. Do not allow the cord to touch hot surfaces and do not place on or near a hot gas
or electric burner or in a heated oven.
17. Do not use the fan heater on a gas or electric cooking top or over or near an
open flame.
18. Use of an extension cord with this appliance is not recommended. However, if it
is necessary to use an extension lead, ensure that the lead is suited to the power
consumption of the fan heater to avoid overheating of the extension cord,
appliance or plug point. Do not place the extension cord in a position where it can
be pulled on by children or animals or tripped over.
19. This fan heater is not suitable for outdoor use. Do not use this appliance for
anything other than its intended use.
20. DO NOT carry the fan heater by the power cord.
21. Do not leave this fan heater unattended during use. Always unplug the unit when
not in use or before cleaning.
22. Always operate the fan heater on a smooth, even, stable surface. Do not place
the unit on a hot surface.
23. Do not insert or allow foreign objects to enter any ventilation or exhaust opening
as this may cause an electric shock or fire, or damage the heater.
24. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do
not use on soft surface, such as a bed, where openings may become blocked.
25. Do not remove grille guard or allow heater to be operated without grille guard in
place.
26. Ensure that the switch is in the “Off” position after each use.

4
27. The manufacturer does not accept responsibility for any damage or injury caused
by improper or incorrect use, or for repairs carried out by unauthorised
personnel.
28. In case of technical problems, switch off the machine and do not attempt to repair
it yourself. Return the fan heater to an authorised service facility for examination,
adjustment or repair. Always insist on the use of original spare parts. Failure to
comply with the above mentioned pre-cautions and instructions, could affect the
safe operation of this machine.
PARTS DIAGRAM
OPERATING INSTRUCTIONS
Place the heater on a firm level surface free from obstructions, and at least 3 ft. (0.9m)
away from any wall or combustible material.
Control knob:

5
1. Thermostat knob:
Turn the thermostat knob to select your desired temperature.
。When the temperature reaches the selected comfort level, the heater will switch off.
。When the room temperature drops below your selected comfort level, the heater will
start operating again.
2. Power shift knob (model knob).
Turn this knob from middle-“OFF”rightwards to select low (1000W) or high (2000W), and
the appliance will work.
Turn this knob from the middle leftwards to select low (1000W) or high (2000W) and the
appliance will work, and at same time it will oscillate.
3. The heater must be placed flat on the floor or the tip-over switch will shut it off
automatically.
This heater is equipped with an internal thermal protector, which causes the unit to stop
operating in the event the internal temperature exceeds normal operating temperatures.
If the unit shuts down:
1) Unplug the unit and wait 10 minutes
2) Plug in and turn the unit on again
CLEANING AND MAINTENANCE
The fan heater is for household use only and is not user-serviceable.
Do not open or change any parts by yourself. Please refer to a qualified electrical
service department or return to the supplier if servicing is necessary.
Always remember to unplug the unit from the electrical outlet when not in use
and before cleaning. Ensure that the speed control is set to “0”.
The body of the fan heater and the stand should be cleaned with a damp cloth.
Do not let water enter the appliance or the stand.
Do not use bleach or other abrasive substance or solvents to clean your fan
heater as it can be damaging to the finish.
Do not immerse the mixer in water or any other liquid, or hold it under a running
tap to clean.

6
To remove stubborn spots/marks, wipe the surfaces with a cloth slightly
dampened in soapy water or mild non-abrasive cleaner. Rinse and dry a clean,
dry, soft cloth.
STORING THE APPLIANCE
Unplug the unit from the wall outlet and clean all the parts as instructed above.
Ensure that all parts are dry before storing.
Store the fan heater in its box or in a clean, dry place.
Never store the fan heater while it is still wet or dirty.
Never wrap the power cord around the fan heater.
SERVICING THE APPLIANCE
There are no user serviceable parts in this fan heater. If the unit is not operating
correctly, please check the following:
You have followed the instructions correctly
That the unit has been wired correctly and that the wall socket is switched on.
That the mains power supply is ON.
That the plug is firmly in the mains socket.
If the fan heater still does not work after checking the above:
- Consult the retailer for possible repair or replacement. If the retailer fails to resolve the
problem and you need to return the appliance, make sure that:
The unit is packed carefully back into its original packaging.
Proof of purchase is attached.
A reason is provided for why it is being returned.
If the supply cord is damaged, the manufacturer or an authorised service agent must
replace it, in order to avoid any hazard. If service becomes necessary within the
warranty period, the appliance should be returned to an approved Amalgamated
Appliance (Pty) Ltd service centre. Servicing outside the warranty period is still available,
but will, however, be chargeable.

7
CHANGING THE PLUG
Should the need arise to change the fitted plug, follow the instructions below.
This unit is designed to operate on 230V-240V current only. Connecting to other
power sources may damage the appliance. Connect a three-pin plug as follows:
The wires in this mains lead are coloured in accordance with the following code:
Green/Yellow = Earth
Blue = Neutral
Brown = Live

8
PLEASE AFFIX YOUR PROOF OF PURCHASE/RECEIPT HERE
IN THE EVENT OF A CLAIM UNDER WARRANTY THIS RECEIPT MUST BE PRODUCED.
W A R R A N T Y
Home of Living Brands (Pty) Limited (“Home of Living Brands”) warrants to the original purchaser of this
product (“the customer”) that this product will be free of defects in quality and workmanship which
under normal personal, family or household use and purpose may manifest within a period of 1
(one) year from the date of purchase (“warranty period”).
Where the customer has purchased a product and it breaks, is defective or does not work properly for the
intended purpose, the customer must notify the supplier from whom the customer bought the
product (“the supplier”) thereof within the warranty period. Any claim in terms of this warranty
must be supported by a proof of purchase. If proof of purchase is not available, then repair,
and/or service charges may be payable by the customer to the supplier.
The faulty product must be taken to the supplier's service centre to exercise the warranty.
The supplier will refund, repair or exchange the product in terms of this warranty subject to legislative
requirements. This warranty shall be valid only where the customer has not broken the product
himself, or used the product for something that it is not supposed to be used for. The warranty
does not include and will not be construed to cover products damaged as a result of disaster,
misuse, tamper, abuse or any unauthorised modification or repair of the product.
This warranty will extend only to the product provided at the date of the purchase and not to any
expendables attached or installed by the customer.
If the customer requests that the supplier repairs the product and the product breaks or fails to work properly
within 3 (three) months of the repair and not as a result of misuse, tampering or modification by or
on behalf of the customer, then the supplier may replace the product or pay a refund to the
customer.
The customer may be responsible for certain costs where products returned are not in the original
packaging, or if the packaging is damaged. This will be deducted from any refund paid to the
customer.
HOME OF LIVING BRANDS (PTY) LTD (JOHANNESBURG)
JOHANNESBURG TEL NO. [phone]
CAPE TOWN TEL NO. [phone]
DURBAN TEL NO. [phone]