Saito FG-60R3 User manual

1.DetachtheThrottle-extensionbarlooseningsetscrews. 2.DetachtheenginemountofRightsideremovingcapscrews.
Content： ●Conversionmount ●M4x14Capscrewtofixthemountx6pcs
Youwillalsoneed： ●Stand-offmount（mountspacer）ｘ4pcs
●※
1M5boltｘ4pcs (Selectadequatelengthaccordingtothe  
stand-offmountasshownintherightfigure.)
●※
2M5nut (Flangenutisrecommended) x4pcs
●Anti-looseningglue   
3.Detachthecarburetortogetherwiththejointplateremovingthe
capscrewfromthebottomside. 4.DetachtheenginemountofLeftsideremovingcapscrews.
FG-60R3/73R5Conversionmountinstallationmanual
※2Flangenut（Recommended）
4~5mm
Stand-offmount
Firewall
Conversion
mount
※1
-1-

5.AttachtheconversionmountsurelyusingtheM4x14screws.
Tightenallthescrewsinthesequenceasshownintheabovepicture.
6.Attachthecarburetortogetherwiththeplatetighteningthecap
screwfromthebottomside.
7.Attachthethrottleextension
bartothecarburetor. 9.Putontheengineinserting4 boltsinthemountingholes.
①
②
③
④
⑤
⑥
8.Beforehandfix4pcsofM5
bolts※1asstudboltsusingthe
prongedTnutsalreadyplacedon
backsideofthefirewall.
11.Attach4nuts※2tofixtheengine.Flangenutshaveenough
frictionalsurfacewhichhelppreventionfromloosening.
NOTE:Ifthelengthofthe4bolts
arenotadequate,youwouldnot
beabletoattachanutduetoits
thickness.
10.Applyanti-looseningglueto
tipoftheboltsbeforeputting
nuts.
12.Finallytightenthenutswitha
spanner.
-2-