salav GS60-BJ User manual

GS60-BJ
www.salavusa.com

Thank you for purchasing this SALAV product. Please read this manual prior to using your SALAV
appliance. For more product information, FAQ and customer support please visit our website at
www.salavusa.com.
1. The voltage of your electrical source must correspond to that of the appliance (110-
120V~60Hz). Connecting to the incorrect voltage may cause unrepairable damage
to the appliance and will invalidate the warranty.
2. Do not share the power supply with other high-powered electric appliances.
3. To reduce the risk of electric shock, do not immerse the appliance, plug, or power cord
in water or other liquids.
4. Do not leave this appliance unattended while it is in operation.
5. Fill in water before using and observe the water level during use.
6. Do not lay hose on the ground. Do not wind hose. Do not operate the appliance if cord
is damaged.
7. Always keep the hose and nozzle elevated above the water tank. Never insert any
object into any opening or hose.
8. Do not cut or attempt to extend the steam hose or power cord.
9. Do not place the nozzle directly on any surface or the appliance power cord while it is
hot or plugged in.
10.Be cautious about steam spraying out from the nozzle. Do not direct steam at people
or animals, or use steamer on garments while they are being worn.
11.Steam only in a vertical motion. Never use steamer in a horizontal position or tilt
backwards – doing so may result in hot water discharge.
12.Move the appliance by firmly grasping the pole. Drain the water tank and water reservoir
before moving.
13.Turn off, unplug and allow the appliance to cool completely for at least 30 minutes
prior to draining the water tank and water reservoir and storing.
14.Always turn off and unplug unit before refilling, draining, cleaning, moving, or when
not in use.
15.For indoor use only.
16.Keep the appliance away from flammable materials and chemicals.
17.Do not fill the water tank with hot water or corrosive cleaning agents which could
cause damage. Distilled or filtered water is strongly recommended.
18.When in use, this appliance will spray hot steam from its steam nozzle. To avoid injury
from hot steam, do not aim the steam nozzle at people or pets.
19.Only use SALAV accessories on your SALAV appliance. The use of accessory attachments
other than those provided by SALAV may result in fire, electric shock or irreversible
damage to the appliance.
20.This appliance is not intended for use by children or near children and other persons
whose physical, sensory or mental capabilities or lack of experience and knowledge
prevents them from using the appliance safely without supervision or instruction by
a responsible person to ensure that they can use the appliance safely.

Wide
Telescopic Pole
Drain Plug
GS60-BJ
1.7L
45 seconds
110 - 120V , 60Hz
1260 - 1500W
360°Swivel Hanger Steam Hose
Water Tank
with Cap
Steam Nozzle
Fabric Brush
Pants Press Hanger Clips
o
l



C
o
o
W

t

t

o
k
n
l
i

S




L

i
F
n
F
e
n
O
4 steam settings for
various fabric types

Insert the Telescopic Poles (The side
with triggers) into the
Multifunctional Hanger, insert the
other side into the main body, and
lock in place.
Extend the Telescopic Poles to desired height
and lock in place. Attach the 360 Swivel °
Hanger to the top and lock in place.
Insert
1
2
Press the Hose Connector upwards
and connect the hose with the Hose
Connector Base, let the hose
connector lock in place.
Hang steamer nozzle handle to the 360°
Swivel Hanger.
Insert
Press
Pull out
Unlock
Insert
Lock
Hose Connector
Hose Connector Base
1
2
2
1
3

ON
Fill in the Water Tank and
replace & tighten its cap.
Plug in & Turn on.
1
2
2
1
45-80 Seconds steam ready time
depending on the steam setting. Ready for garment steaming.

OFF
Vinegar
F
Turn off the unit and unplug it. Wait for at
least 30mins until the unit cools down
completely.
Unscrew the Drain Plug and empty
the water reservoir. Collapse and
remove the Wide Telescopic Pole &
Steam Nozzle.
Attention: Screw
the Drain Plug after
the water reservoir
is empty. Make sure
the Drain Plug is
screwed each time
before use.
Turn off and unplug the unit and cool
for at least 30mins. Remove water
tank. Mix water & vinegar solution
and pour into water reservoir.
Wait for 40mins, unscrew the Drain Plug and
drain the water reservoir. Pour clean water into
reservoir and let it drain. After the reservoir is
empty, replace and tighten the Drain Plug.
1
2
1
2

PULL PULL 360°
Hanger Hook
Fabric Brush
1 2
Pants Press
2
1
Hanger Clips

Vinegar
Vinegar
Unit fails to steam
Indicating lamp does
not illuminate.
Unit fails to steam
Indicating lamp
illuminates.
Noise in Steam
Hose. Steam hose
stops spraying
steam.
Steam is
intermittent.
The unit is
not
plugged in.
House hold
power system
problem/fuse is
blown.
Mineral build-up.
Water Tank is empty.
Water drops
gather in the
Steam Hose.
Mineral build-up in
Water Tank.
Plug in the unit.
Call a qualified
electrician for help.
Follow the
removal mineral
build-up
procedure.
Refill the Water Tank.
Straighten the
Steam Hose.
Follow the removal mineral
build-up procedure.

Visit our website to find product tips, customer support and learn about
SALAV patented steam technology.
www.salavusa.com