Samsung AZ09A1SEA User manual

ENGLISH
ESPAÑOL
FRANÇAIS
PORTUGUÊS
ITALIANO
OWNER’S INSTRUCTIONS
MANUAL DE INSTRUCCIONES
MANUEL D’UTILISATIO
MANUAL DE INSTRUÇÕES
ISTRUZIONI PER L’USO
AZ09F1SEA
AZ09F1JEA
AZ12F1JEA
AZ18F1MEA
AZ18F1MEB
AZ22F1MEA
AZ22F1MEB
AZ24F1MEA
AZ24F1MEB
AZT18F1MEA
AZT24F1MEA
AZ09A1SEA
AZ09A1JEA
AZ12A1JEA
AZ18A1MEA
AZ18A1MEB
AZ22A1MEA
AZ22A1MEB
AZ24A1MEA
AZ24A1MEB
AZT18A1MEA
AZT24A1MEA
Window-type Room Air Conditioner ( Cool and Heat )
Acondicionador de aire doméstico sistema de tipo ventana ( Refrigeración y Calefacción )
Climatiseur de type Fenêtre ( Refroidissement et Chauffage )
O ar Condicionado de Window-Type ( Refrigeração e Aquecimento )
Condizionatore d’aria per ambienti da finestra ( Raffreddamento e Riscaldamento )
E S F P I
DB68-01692A(6)

The following safety precautions must be taken when installing
and using your air conditioner.
Safety Precautions
1The air conditioner must be plugged into its own specific power source, which must be
installed in compliance with national wiring, earthing and safety regulations.
Depending on national regulations and your specific installation, you may need to install:
◆ A circuit breaker
For further information on electrical requirements, contact a professional electrician.
This air conditioner must be connected by a licenced electrician.
This device must be installed according to the national electrical rules.
2Make sure that the unit is correctly ventilated at all times;
do NOT place clothing or other materials over it.
3NEVER spill liquid of any kind into the unit.
Should this happen, unplug the unit and contact your installation specialist.
4Do NOT insert anything between the air outlet blades, as the inner fan may be damaged
and you may be hurt. Keep children away from the unit.
5ALWAYS ensure that the power cable is in good condition.
Make sure that it is not walked on or damaged by items placed on or against it.
If the power cord is damaged in any way, it must be replaced by an approved
power cord available from the manufacturer or its service agent.
6Do NOT attempt to repair the unit yourself. If it is damaged in any way, contact:
◆ An approved service center
◆ The outlet at which the air conditioner was purchased
7Do NOT place any obstacles in front of the unit.
8The appliance is not intended for use by young children or infirm person without supervision;
young children should be supervised to ensure that they do not play with the appliance.
The manufacturer do not take the responsibility of the accident happened
because the air conditioner is not fixed firmly or installed securely, during
installing or using the product. In case you have difficulty in installation,
you must ask for an installation specialist help. The accident will be hap-
pened in case of installing improperly.
CC
CCAA AAUU UUTT TTII IIOO OONN NN
E-2

◆PREPARING YOUR AIR CONDITIONER
■Safety Precautions ......................................................................................... 2
■Air Conditioning Unit - Main Parts and Control Panel .................................... 4
◆OPERATING YOUR AIR CONDITIONER
■Cooling Your Room ........................................................................................ 5
■Heating Your Room ........................................................................................ 5
■Airing Your Room ........................................................................................... 6
■Switching the Air Conditioner Off .................................................................... 6
■Adjusting the Air Flow Direction Horizontally .................................................. 7
■Adjusting the Air Flow Direction Vertically ...................................................... 7
◆RECOMMENDATIONS FOR USE
■Operating Recommendation ........................................................................... 8
■Temperature and Humidity Ranges ................................................................ 8
■Cleaning Your Air Conditioner ........................................................................ 9
■Solving Common Problems ............................................................................ 11
■Technical Specifications ................................................................................. 11
◆INSTALLATION ....................................................................................................... 12
Contents
E-3
ENGLISH
The illustrations in the step-by-step procedures use four different symbols:
PRESS PUSH IMPORTANT NOTE
☛
➢
CC
CCAA AAUU UUTT TTII IIOO OONN NN
The maximum permissible system impedance at the power junction box is 0.27 ohms.
Usually, the maximum permissible mains impedance will not be exceeded when the
branch to the power outlet is fed from a junction box with a rated current of 32A.
AZ18✴✴
" The high inrush current of the starting compressor motor can have adverse effects to
the operation of other equipment under unfavorable mains conditions. This equipment
does not comply with the relevant technical standards for the limitation of voltage
fluctuations and flicker."
Before connecting this equipment to the power supply system, please report to your
supply authority and obtain the consent.
Do not connect other electric appliances to the same supply lines.

Air Conditioning Unit - Main Parts and Control Panel
Outer air flow blades
(up/down orientation)
Air inlet (Inside)
Air filter
(The air filter is located
in inside.) Ventilation lever
Power plug
◆ The type of power plug
may differ, depending
on the local power supply.
◆ The power plug may be
not supplied depending
on the model.
Air inlet (Outside)
Temperature
control dial
Operating mode
selection dial
Air flow blade
swing switch
Inner air flow blades
(right/left orientation)
❄The design and shape are subject to
change according to the model.
E-4
Air outlet

Cooling Your Room
E-5
ENGLISH
Select the operating mode and fan speed.
Result: ◆ The air conditioner starts up in Cool mode.
◆ The fan starts up at the speed selected.
To adjust the temperature, turn the temperature control dial towards the
right and the blue position.
Possible temperatures: Between 18°C and 25°C inclusive.
Result: The air conditioner starts cooling if the room temperature is
higher than the selected temperature.
You must select the Cool mode if you wish to lower the temperature
in your room. You can also set the fan speed.
1
2
To control the direction of the air flow, refer to page 7.
3
To cool your room with a... Set the operating mode
selection dial to...
High fan speed HI COOL
Low fan speed LOW COOL
You can change modes at any time.
➢
27˚C ~ 23˚C
29˚C ~ 27˚C 23˚C ~ 18˚C
Heating Your Room
Select the operating mode and fan speed.
Result: ◆ The air conditioner starts up in Heat mode.
◆ The fan starts up at the speed selected.
To adjust the temperature, turn the temperature control dial towards
the left and the red position.
Possible temperatures: Between 25°C and 29°C inclusive.
Result: The air conditioner starts heating if the room temperature is
lower then the selected temperature.
You must select the Heat mode if you wish to heat your room
to a specific temperature. You can also select the fan speed.
1
2
To control the direction of the air flow, refer to page 7.
3
To heat your room with a... Set the operating mode
selection dial to...
High fan speed HI HEAT
Low fan speed LOW HEAT
You can change modes at any time.
➢
27˚C ~ 23˚C
29˚C ~ 27˚C 23˚C ~ 18˚C

Airing Your Room
If the atmosphere in your room is stale, you can air it using
the Fan feature and if necessary, evacuate the stale air outside.
To control the direction of the air flow, refer to page 7.
3
Switching the Air Conditioner Off
1
If you wish to evacuate stale air outside, push the ventilation lever on the front
of the unit to the right and the open position ( ).
Result: The air inside the room circulates and stale air is evacuated
outside.
Otherwise, push the ventilation lever to the left and the closed position ( ).
Result: The air simply circulates inside the room.
2Set the operating mode selection dial to the FAN position.
You can switch the air conditioner off whenever you want.
1To switch the unit off, simply set the operating mode selection dial
to the OFF position.
Result: The air conditioner stops operating.
Result: The air conditioner starts up in Fan mode.
Both fan settings(left and right) have the same function.
➢
E-6

Adjusting the Air Flow Direction Horizontally
Adjusting the Air Flow Direction Vertically
Again depending on the position of the unit in your room, you can
adjust the orientation of the outer air flow blades on the right-hand
side of the unit.
1Adjust the air flow blades to the desired position, by pushing them
upwards or downwards.
Depending on the position of the unit in your room, you can adjust the
orientation of the inner air flow blades on the right-hand side of the
unit, thus increasing the efficiency of the air conditioner.
1Set the air flow blade swing switch to the position.
Result: The inner blades swing automatically left and right.
2To stop the blades moving left and right, set the air flow blade swing
switch to the position.
To stop the blades in a specific position and orient the air flow
in the corresponding direction, simply set the switch to the
position when the blades are in the desired position.
➢
If you orient the air flow blades downwards and the unit
operates in Cool mode for long periods of time, dew may:
◆ Form on the surface of the blades
◆ Drip from the blades
➢
RECOMMENDATION When... Adjust the blades to face...
Cooling Upwards.
Heating Downwards.
E-7
ENGLISH

Operating Recommendation
Recommendation
The heat pump inside the air conditioner absorbs heat from outside air
and brings it indoors. If the temperature of the outside air drops, the air
conditioner will heat less. If you find that the room is not warm enough,
use an additional heating appliance.
Topic
Heating performances
The air conditioner circulates warm air to heat your room; as a result,
some time will be required after starting the air conditioner to warm the
entire room. If necessary, set the air conditioner going a short time before
you wish to use the room.
Warm air circulation
When outside temperatures are low and humidity is high, frost may form
in the unit’s condensor when heating with your air conditioner.
If this happens:
◆The unit stops heating
◆The air flow blades stop swinging
◆The Deice mode is triggered automatically for about five minutes
No intervention is required from you; after about five
minutes, the air conditioner starts operating again normally.
Frost
If both the indoor and outdoor temperatures are high and you select the
Heat mode, the fan and compressor in the unit may stop at times.
This is normal; simply wait until the air conditioner switches on again.
High indoor and outdoor
temperatures
If a power failure occurs when the air conditioner is operating, the unit is
switched off. When the power returns, the air conditioner starts up again
automatically
Power failure
Here are a few recommendations that you should follow when using your air conditioner.
If the air conditioner is used at... Then...
Higher temperature The automatic protection feature may be triggered
and the air conditioner stopped.
Lower temperature A water leakage or some other malfunction may happen
if the heat exchanger freezes.
Higher humidity levels Water may condense on and drip from the surface of the unit
if it is used for long periods.
Mode Indoor
Temperature Outdoor Temperature Indoor Humidity
Cooling 21°C to 32°C approx. 21°C to 43°C approx. 80% or less
Heating 28°C or less 0°C to 21°C approx. -
Temperature and Humidity Ranges
The following table indicates the temperature and humidity ranges within which the air
conditioner can be used.
E-8

Cleaning Your Air Conditioner (✴✴✴✴F1✴✴✴ models)
If you...
Will not be using the
air conditioner for a
long period of time
Have not used the air
conditioner for a long
period of time
Then...
◆ Set the operating mode selection dial
to “FAN” and let it run of a few hours
to dry the inside of the air conditioner
thoroughly.
◆ Switch the air conditioner off and
unplug it from the wall socket.
◆ Clean the filter and outer surfaces.
Set the operating mode selection dial
to “FAN” and let it run of a few hours to
dry the inside of the air conditioner
thoroughly.
Hold the air filter handle, slightly pull it to the left side and open the front grille. 1
Pull the air filter to the right side.
2
Remove all dust on the air filter with a vacuum cleaner or brush.3
When you have finished, insert the air filter back into its original position.4
Wipe the surface of the unit with a neutral detergent and then wipe it again
with dry cloth.
(Be sure not to use benzene, solvent or other chemical products.)
5
➢
The removal of the front grille makes it easier to clean the air
conditioner. Open the grille as much as possible.
➢
To get the best possible use out of your air conditioner, you must clean it
regularly by two weeks to remove the dust on the air filter.
Before cleaning your air conditioner, ensure that it is switched off
and unplugged from the wall socket.
Removal and Reassembly of the Front Grille
Grasp the lower part of the
front grille and the air filter
handle, then open the grille.
1
Remove the safety clip and
the front grille.
2
When reassembling the front
grille, you should install the
safety clip again.
3
For user's safety, a safety clip has been installed in the front grille.
Safety clip
CC
CCAA AAUU UUTT TTII IIOO OONN NN
The air conditioner has two or three
grille grooves depending on the model.
☛
E-9
ENGLISH

Cleaning Your Air Conditioner (✴✴✴✴A1✴✴✴ models)
E-10
If you... Then...
Will not be using the ◆ Set the fan going for a few hours
air conditioner for a to dry the inside of the air conditioner
long period of time thoroughly.
◆ Switch the air conditioner off and
unplug it from the wall socket.
◆ Clean the filter and outer surfaces.
Have not used the air Set the fan going for a few hours to
conditioner for a long dry the inside of the air conditioner
period of time thoroughly.
To get the best possible use out of your air conditioner,
you must clean it regularly by two weeks to remove the dust on the air filter.
Before cleaning your air conditioner, ensure that it is
switched off and unplugged from the wall socket.
Open the front grille by pulling on the tabs of the unit.
The removal of the front grille makes it easier to clean the air
conditioner. After opening the front grille, lift it up as much as
possible, then pull down to release it.
1
Grasp the handle on the air filter and lift it slightly and then out to the front.
2
Remove all dust on the air filter with a vacuum cleaner or brush.
3
When you have finished, slide the air filter back into position.
4
Clean the outer surfaces with a damp cloth and mild detergent
(do NOT use benzene, solvents or other chemicals).
Wipe them dry with a clean, soft cloth.
5
☛
➢
➢
Front grille
Grille groove
Body guide
Front grille