Samsung SR10J50 Series User manual

Robot vacuum cleaner
User manual
SR10J50✴✴✴ Series
• Beforeoperatingthisunit,pleasereadtheinstructionscarefully.
• Forindooruseonly.
VR5000_EN_00734A-00.indd 1 2015-02-27 오후 5:53:56

12
Installation
Installation
Powerofthechargermustbeonatalltimes.
Installitinaplacewithout
obstaclesanddangeroffalling.
NOTE
• Installthechargerinaplacewheretheoorandwallarelevel.
• Installthechargeralongthegrainofwoodenoors.
• Ifthepowerswitchisoff,therobotvacuumcleanerwillnotchargeevenifitisdocked
onthecharger.
• Alwaysturnonthepowerofthecharger.
–Ifpowerisnotsuppliedtothecharger,therobotvacuumcleanercannotnditand
cannotautomaticallyrecharge.
–Iftherobotvacuumcleanerisleftdetachedfromthecharger,thebatterywilldrain
naturally.
• Iftherobotvacuumcleanerisinenergy-savingmode,powerwillnotcomeonevenif
thepowerswitchisturnedoffandthenon.PressandholdtheStart/Stopbuttononthe
robotvacuumcleaner.
Powerlamp
(Red)
About1m
About0.5m
About0.5m
Installation
VR5000_EN_00734A-00.indd 12 2015-02-27 오후 5:53:57

13
Installation
Accessories
Remotecontrol(Option) Batteries
[AAAtype(Option)]Usermanual
Sparelter(Option) CleaningbrushVirtualguard(Option)
VR5000_EN_00734A-00.indd 13 2015-02-27 오후 5:53:58

14
Installation
Charging
Ittakesapproximately120minutestocompletelychargewhenchargingforthersttime
afterpurchaseandcanbeusedforapproximately90minutes.
WARNING
Ratedinputvoltageofthis
productis220-240V~.
Charginglampduringcharging(green)
1 Turn on the power switch on the
bottom.
Youmustturnonthepowerswitchtoturn
ontherobotvacuumcleaner.
2 Manually charge the robot vacuum
cleaner by placing it on the charger.
Makesurethechargepinsoftherobot
vacuumcleanerandthechargerisaligned.
3 Check the charging status.
“”willturnonaccordingtocharging
progressand“FULL”willturnonwhen
chargingiscomplete.
VR5000_EN_00734A-00.indd 14 2015-02-27 오후 5:53:58

15
Installation
Automatic charging
Whenthebatteryindicatorblinksduring
cleaning,therobotvacuumcleanerwill
returntothechargertochargeitself
automatically.
Recharge
Youcancommandtherobotvacuum
cleanertorechargeatthechargerwhileit
isincleaningprocess.
Low battery (Lo)
Manuallychargetherobotvacuumcleaner
byplacingitonthecharger.
Steps to take if recharging is not being executed.
Check the installation status of the charger when:
• thechargerislocatedinaplacewheretherobotvacuumcleanercannoteasilyaccess.
• distancebetweenthechargerandrobotvacuumcleanerisover5mapart.
–Itmaytakealongtimefortherobotvacuumcleanertoreturntothechargerfor
recharging.
Manually charge the robot vacuum cleaner when:
• thechargerislocatedinacorner.
• batteryisfullyexhausted.
• therobotvacuumcleanerisstuckbyobstacles(furnitureetc.).
• therobotvacuumcleanercan’tclimbthresholdnearcharge.(Heightofthethreshold
thattherobotvacuumcleanercanclimb:about1.5cmandbelow)
• whenthebatteryindicatorblinksand“Lo”isdisplayed.
• whentherobotvacuumcleanerissetonSpotcleanorManualcleanmode.
VR5000_EN_00734A-00.indd 15 2015-02-27 오후 5:53:59