Sanitas SMA 35 User manual

G ? Operating Instructions
Manicure-/Pedicure-Set
SMA 35
G Tel.: [phone]
? Tel.: [phone]
Service:

2
1. Important notes
Read through these instructions for use carefully before first use.
Keep them to hand for later use and ensure that they are acces-
sible to other users.
IMPORTANT:
When in use, there may be an intense heat build-up on the skin or nail.
– Check results regularly during treatment. This is particularly advisable in
the case of diabetics, as they are less sensitive to pain and are liable to
become injured more easily. Attachments 1, 2, 3, 4 and 5 that are provid-
ed are basically suitable for diabetics as they are only used for treatment
of areas rather than specific points. Attachments 6 and 7 are, however,
less suitable for diabetics. Always use with extreme care. If in doubt, ask
your doctor.
– This instrument must be used only for the purpose for which it has been
developed, and in the manner described in the instructions for use. Any
improper use can be dangerous.
– In case of prolonged intensive use (e.g. milling of dead skin from your
feet) the device might get very hot. In order to prevent skin burns in these
situations, there should be longer breaks between each application. For
your own safety, constantly monitor heat build up in the device. This par-
ticularly applies to people who are insensitive to heat.
– The device is only for private use and is not intended for medical or com-
mercial purposes.
– For reasons of hygiene, the device should only be used on one person.
– The manager is not responsible for damage or injury caused by improper
or incorrect use.
– Ensure before use that there is no visible damage to the instrument and
accessories. In the event of doubt, do not use them and contact your
dealer or the customer service address stated.
– Keep children away from the packaging materials. Risk of suffocation.
– The appliance must be checked frequently for signs of wear or damage.
If such signs are present, or if the appliance has been used improperly, it
must be taken to either the manufacturer or the dealer before further use.
!
G ? ENGLISH

3
– Switch off the instrument immediately in the event of defects or malfunc-
tions.
– Repairs may be carried out only by the customer service or authorized
dealers.
– On no account try to repair the instrument yourself!
– Use the instrument only with the accessories provided.
– Never operate the appliance without supervision, particularly when
children are in the vicinity.
– Do not use on small animals/animals.
– Prevent all contact with water (except when cleaning with a slightly mois-
tened cloth!). Water must never enter the inside of the appliance. Never
immerse the appliance in water. On no account use the appliance in the
bath, in a shower, in a swimming pool or over a water-filled wash basin. In
the unlikely event that water gets into the case, disconnect the appliance
immediately from the mains and contact your specialist electrical supplier
or customer service.
– Keep the instrument away from sources of heat.
– Do not use the instrument under blankets, pillows etc.
– The instrument must not be operated continuously for longer than 20
minutes. After this time, wait an interval of at least 15 minutes to prevent
the motor from overheating.
– Ensure your hands are dry before handling either the instrument or the
plug-in power unit.
– Do not pull on the power cord or instrument to unplug the plug-in power
unit from the socket outlet.
– The plug-in power unit must be operated only from a power supply as
specified on it.
– The appliance should only be operated with the power unit provided.
– After use, before cleaning and changing any accessory parts, the power
unit should always be disconnected.
– This device is not intended for use by persons (including children) with
restricted physical, sensory or mental capabilities and/or by persons
lacking the required understanding of the equipment and how it is used,
unless they are supervised by a person who is responsible for their safety
or they are given instructions on how to use the device.
– Children should be supervised to ensure that they do not use the device
as a toy.

4
2. Preparation
This manicure and pedicure instrument is equipped with high-quality attach-
ments. The basic version includes 7 attachments with long-life sapphire
coating or polishing felt.
Together with the 2-level speed control and clockwise/anticlockwise opera-
tion, this ensures a professional pedicure and manicure that would other-
wise only be possible at a podiatrist.
3. Application
3.1 General
– This instrument is intended only for the treatment of hands (manicure) and
feet (pedicure).
– Select an attachment and push it onto the instrument spindle using a
slight pressure. To remove: pull the attachment and instrument apart in
the axial direction (straight).
– Switch the device on by moving the slide switch down (anticlockwise,
LED red) or up (clockwise, LED green).
– All file and cutting attachments are coated with a sapphire grain.
This guarantees extremely long life and almost guarantees freedom from
wear.
– You can select one of two speed settings (Hi and Lo). Press the corre-
sponding button on the device
– Do not exert heavy pressure and always guide the attachments carefully
over the surface to be treated.
– Move the instrument under light pressure in circular movements slowly
over the parts to be treated.
– Note that the cutting attachments will have a reduced effect if the skin is
softened or moist. For this reason, do not carry out any pretreatment in a
bath.
– Do not remove all the callus skin in order to retain the natural protection
of the skin.
– Always ensure that the spindle can rotate freely. It must never be perma-
nently jammed, otherwise the instrument will become too hot and suffer
damage.
– After every use, apply moisturizing cream to the parts treated.

5
Important:
Check the results during treatment. This is particularly important
for diabetics, since their hands and feet are less sensitive.
3.2 Attachments
As these are attachments for use by professionals, we would ask you to
handle them with care as they can cause injury when used incorrectly. Par-
ticular caution is advised at higher speeds.
The following attachments are provided with your appliance:
When filing, always work from the outside of the nail towards the tip!
1 – Sapphire disk, fine
Filing and treatment of the nails, fine grained sapphire
disk. The specific aspect of this sapphire disk is that
only the inner disk rotates, while the outer support is
stationary. This enables precise filing of the nails without
the risk of burning the skin with the fast rotating disk.
2 – Sapphire disk, coarse
Filing and treatment of the nails, coarse grain sapphire
disk. This attachment allows you to shorten even thick
nails by filing. Since it quickly removes large areas of the
nail, you should proceed with caution in this case also.
3 – Sapphire cone
Removal of dry skin or calluses from the soles of the
feet and from the heels and for manicuring the nails.
4 – Felt cone
Smoothing and polishing the edge of the nail after filing
as well as for cleaning the nail surface. Always polish
in circular movements and do not allow the felt cone to
rest in one place, otherwise friction could cause heat to
develop.
!
5 – Sapphire callus rasp
For rapid removal of stubborn calluses and hard skin on
the soles of feet and heels This attachment can be used
on large areas.

6
6 – Cylindrical milling cutter
Grinding of lignified foot nail surfaces as well as
smoothing of these. For this purpose, apply the milling
cutter horizontally to the nail surface and remove the un-
wanted layer of nail using slow circular movements.
7 – Flame milling cutter
For removing ingrowing nails. Carefully guide the flame
cutter up to the part to be treated and remove parts of
the nail as necessary.
Always check results regularly during treatment. As soon as the application
becomes unpleasant, stop the treatment.
4. Cleaning/care
Before cleaning the power unit, always unplug it from the socket outlet!
– Clean the instrument with a slightly moistened cloth. You can also
moisten the cloth with mild soap suds to remove more stubborn dirt.
– If necessary, for reasons of hygiene, the attachments can be cleaned with
a cloth or brush moistened with alcohol. Dry them carefully afterwards.
– Do not drop the instrument.
– Make sure that no water enters the instrument. But if this should happen,
do not use the instrument again until it is completely dry.
– Do not use chemical detergent or scouring agents for cleaning.
– Never immerse the instrument or plug-in power unit in water or other liq-
uids.
5. Technical data
Power unit voltage Input: 100–240 V AC / 50–60 Hz
Output: 30 V DC / 250 mA
Speed: 3.800/4.600 U/min ±14%

7
6. Disposal
Please dispose of the device in accordance with the directive
2002/96/EG – WEEE (Waste Electrical and Electronic Equipment).
If you have any queries, please refer to the local authorities responsi-
ble for waste disposal.
7. Warranty/Service centre
We provide a 3-year warranty covering faults in materials or manufacture of
the product from the purchase date.
The warranty does not cover:
• Damage resulting from improper use.
• Wear parts.
• Defects that were known to the customer at the time of purchase.
• Damage for which the customer was responsible.
This warranty does not affect the customer‘s legal rights.
The customer must provide proof of purchase in order for any warranty
claims within the warranty period to be honoured.
Claims under the warranty within a period of 3 years from the date of pur-
chase are honoured by
Hans Dinslage GmbH, Riedlinger Straße 28, 88524 Uttenweiler, Germany
In the event of a warranty claim, the customer has the right to have the
goods repaired by our own workshop or a workshop authorised by use.
The device must not be opened for any reason. Opening or modifying the
device invalidates the warranty.
This warranty does not grant any additional rights to the customer.
In many cases the reason for complaints is operating errors. They can
be easily corrected by telephone.
Please contact the service hotline.
G Tel.: [phone]
? Tel.: [phone]

8
752.618 - 0111 Subject to error and change