SC&T DP02U User manual

Smart Cabling & Transmission Corp. V1.0_2007171
DisplayPort Extender Series
User Manual
Model : DP02U
4K DisplayPort KVM with USB CAT5e Extender 150M

1
User Manual
DP02U
Introduction
DP02U is a DisplayPort over HDBaseT™ Extender that uses cost-effective Ethernet cable to send
uncompressed video & audio, USB, bi-directional IR, RS232 signals, with the resolution up to 4K@30Hz 4:4:4
and the transmission distance up to 150M. The 4 built-in USB ports at RX unit can connect multiple USB
devices, such as keyboards, mouse, and flash drives. It is an ideal solution to show video from a
PC/laptop on a projector/monitor.
Features
Resolution up to 4K@30Hz 4:4:4.
Signal extension up to 150M over CAT5e or greater.
Built-in 4 ports USB at RX unit.
Supports bi-directional RS232 transmission.
Installation View
Panel View
DP02UT
No.
Interface
Functionality
1
Power Jack
To connect with 5V 2A power adapter
2
Power Indication
To indicate power status (Refer to Description 1)
3
Link Indication
To indicate link status (Refer to Description 1)
4
3.5 mm Phone Jack
To connect with RS232 cable (Refer to Description 2)
5
RJ45 Connector
To connect with Ethernet cable (Refer to Description 3)
6
DisplayPort Connector
To connect with DisplayPort cable
7
USB-Type A Connector
To connect with USB cable

2
User Manual
DP02U
DP02UR
No.
Interface
Functionality
1
Power Jack
To connect with 5V 2A power adapter
2
Power Indication
To indicate power status (Refer to Description 1)
3
Link Indication
To indicate link status (Refer to Description 1)
4
3.5 mm Phone Jack
To connect with RS232 cable (Refer to Description 2)
5
USB-Type B Connector
To connect with USB cables
6
RJ45 Connector
To connect with Ethernet cable (Refer to Description 3)
7
DisplayPort Connector
To connect with DisplayPort cable
Transmission Distance Chart
Cable Type
Max Distance
Max Resolution
CAT5e / CAT6/CAT6a/CAT7
150M
Long Reach Mode
1080p 60Hz 8bit
CAT5e / CAT6
100M
1080p 60Hz 12bit
CAT5e
90M
1080p 60Hz 16bit
4096x2160@30Hz 4:4:4
4096x2160@60Hz 4:2:0
CAT6/ CAT6a/ CAT7
100M
If the Ethernet cable passes through the wall socket, the length of the cable between DP02U and Wall
Jack must be fewer than 3 meters as connection diagram shown below:
MAX 150M
Cable
We recommend using high-quality CAT5e, CAT6, CAT6a, CAT7 UTP/STP, or FTP cables to connect DP02UT
and DP02UR. Poor quality cables and any improper connection will cause video or audio disruptions and
picture noise.
Tx
Wall Jack
Rx
Wall Jack
3M
3M

3
User Manual
DP02U
LED Indication
Color
Status
DP02UT
DP02UR
GREEN
ON
Power on
BLUE
ON
Linked
Flash
Power Saving Mode
Power Saving Mode
No video displaying or no connecting with any devices, DP02U will automatically activate Power Saving
Mode to save power. When power saving mode enabled, RS232 and USB transmission are not able to
function.
RS232 Define
DB9(F)/3.5mm STEREO PHONE JACK DB9(M)/3.5mm STEREO PHONE JACK
RS232
3.5 mm Phone Jack
RS232
3.5 mm Phone Jack
Footprint
Define
Footprint
Define
Footprint
Define
Footprint
Define
Pin 2
TX
Pin 1
RX
Pin 2
RX
Pin 1
RX
Pin 3
RX
Pin 2
TX
Pin 3
TX
Pin 2
TX
Pin 5
GND
Pin 3
GND
Pin 5
GND
Pin 3
GND
RJ45 Pinout
(PIN TIA/EIA-568B)
PIN
Wire Color
1
Orange-white
2
Orange
3
Green-white
4
Blue
5
Blue-white
6
Green
7
Brown-white
8
Brown
DP02UR
DB9(F)/3.5mm STEREO PHONE JACK
DB9(M)/3.5mm STEREO PHONE JACK
DP02UT

4
User Manual
DP02U
Switch Function
Switch
Position
Function
SW1
ON
Long Reach Mode 1080p
OFF
4K Resolution
SW2
ON
Firmware Update
OFF
RS232 Extension
SW3
ON
Firmware Update
OFF
Firmware Update
SW4
Reserve
Caution
This device does not support MST (Multi Stream Transport) hub function based on DP1.2
Trouble Shooting
1. The connection cables must keep a distance from any equipment with an electromagnetic wave,
i.e., mobile phone, microwave, radio equipment, fluorescent lamp, high voltage power lines.
2. The cable must remain straight to avoid any crosstalk interference and to maintain good stability of
the transmission.
3. The HDBaseT technology does not communicate through the general Ethernet signal. Therefore,
using the HDBaseT port to connect with network devices may cause damage to the extender.
4. If there is interference or multiple DP02U used in the environment, using STP or FTP cable is highly
recommended.
Package Include
1 x DP02UT Transmitter
1 x DP02UR Receiver
1 x USB A/B cable
1 x DB9 (M)/3.5mm STEREO PHONE JACK
1 x DB9 (F)/3.5mm STEREO PHONE JACK
2 x Mounting Screw pack
2 x DC5V 2Amp Power Adapter

5
User Manual
DP02U
LED Indication
Color
Status
DP02ET
DP02ER
GREEN
ON
Power on
BLUE
LINK
ON：LINK Normal,
Flash：Low Power Mode
*Low Power Mode:
When DP02ET no video input or DP02ER not connect any
devices, DP02E will enter a low power mode to save power
consumption.
Cable
Link cable recommend use high quality Cat.5e、Cat.6、Cat.6a、Cat.7 UTP / STP or FTP cable. Poor quality
cable or network connection or improper construction will cause unstable connection, video or sound
disruptions, picture noise appears.
Distance Chart by Different Cable
Cable Type
Range
Supported Video
CAT5e / CAT6
60M
1080p 60Hz 12bit
CAT6a / CAT7
70M
CAT5e / CAT6
35M
1080p 60Hz 16bit
Up to 4096x2160@30Hz 4:4:4(9Gbps)
CAT6a / CAT7
40M
If connection through the wall socket, the cable length must less 5 meters between HDMI extender and
wall jack, as below drawing:
10/100Mbps network connection using general CAT5e cable and working distance up to 60M.
Transmitter
Wall Jack
Wall Jack
Receiver
CAT6a 70M
<5M
< 5M

6
User Manual
DP02U
RJ45 Define
Video Link (TIA/EIA-568-B)
1. Orange-white DATA0 +
2. Orange DATA0 -
3. Green-white DATA1 +
4. Blue DATA2 +
5. Blue-white DATA2 -
6. Green DATA1 -
7. Brown-white DATA3 +
8. Brown DATA3 -
Caution
This device not support MST (Multi Stream Transport) hub function based on DP1.2
Trouble Shooting
1. The wiring must away from any equipment with electromagnetic wave, i.e.: mobile phone, microwave,
radio equipment, fluorescent lamp, high voltage power lines.
2. The cable must pull in straight to avoid any crosstalk interference and the transmission stability.
3. This device HDBaseT port is not general Ethernet signal; do not connect with Network devices to avoid
damage.
4. The receiver unit working temperature is higher which is in normal condition.
5. The bottom dip switch was no function which is reserve.
Package Include
DP02ET DVI Transmitter x 1 pcs
DP02ER DVI Receiver x 1 pcs
Mounting Screw pack x 1 bags
Power Adapter x 2 pcs

7
User Manual
DP02U
Specification
ITEM NO.
DP02UT
DP02UR
Support
Compliance
DP 1.2a, HDCP, USB 2.0, 1.1, 1.0
Max. DisplayPort Resolution
4K@30Hz 4:4:4
Max. Transmission Distance
150M at 1080p@60Hz, 100M at 4K@30Hz 4:4:4
Audio Format
LPCM 7.1 @ 192KHz, Dolby TrueHD, DTS-HD MA
RS232 Baud Rate
115200 bps/ Full Duplex
Ports & Interfaces
Video Input
1 x DisplayPort
1 x HDBaseT
Video Output
1 x HDBaseT
1 x DisplayPort
USB Interface
1 x USB-Type B
4 x USB-Type A
RS232 Interface
1 x DB9(F)/3.5mm Stereo Phone Jack
1 x DB9(M)/3.5mm Stereo Phone Jack
Power
Power Supply
DC 5V 2A Regulated
DC 5V 2A Regulated
Power Consumption
5W (Max), 1W (Power Saving)
6W (Max), 1W (Power Saving)
Ambient Temperature
Operation
-10 to 45℃
Storage
-30 to 70℃
Humidity
up to 90%
Physical Characteristics
Dimensions
109.6 x 108 x 30mm
109.6 x 108 x 30mm
Weight
265
265