Scanstrut Scanpod SPR-1u-AM User manual

IMPORTANT
Pods are only compatible with marine electronics devices as stated in the latest Scanstrut Product guide – subject to change without
prior notice.
Use with unapproved products, or overloading, invalidates any warranty.
No liability is accepted for damage caused by incorrect installation.
The installation and assembly must be regularly inspected for evidence of damage or loose parts.
Product has been designed specically for the mounting of approved marine electronics devices and used under normal boating
conditions.
For installations that dier from those stated here, please consult Scanstrut head oce.
Scanstrut Scanpod Installation Instructions
SPR-1u-AM
Uncut Instrument Arm Mount Helm Pod

Parts List
60073
Tools Required
1For ø25mm (1“) tube: ø20mm (25/32”) hole saw
For ø32mm (1 1/4”) tube:ø25mm (1”) hole saw
4
2
6
x1
x1 x1
x1
x1
x1
x1
10SP-ARM
60535 60536
190SPR-1
620526
190SPR-1
4 x 620526
1 x 190SPH-3
190SPH-3
60535
Hole Saw ø20 or
25mm (25/23" or 1”)
Power drill
2.5mm Allen
Key
Posidriv No. 3
Screwdriver
Drill Bit to suit
instrument xings
x1
x1
Blank front with seal
tted
60087
x2
x2
x4
Back
60414
60416
x1
118111
619001
619000
x1
60702
1 x 60073
1 x 60702
1 x 619000
1 x 10SP-ARM
178113
1 x 178113
1 x 118111
1 x 619001
Fully Tighten to lock 60535
& 60536 together 60536
5
4 x 60087
2 x 60416
2 x 60414
3
Jigsaw/Spiral
Saw
Refer to electronics manufacturer’s instructions
Refer to electronics manufacturer’s instructions
23mm (0.9”) ø Cable Routing Clearance
Learn more about marine electronics and navigation on our website.