Schletter ALUTILE User manual
ALUTILE
MOUNTING INSTRUCTION
ALUTILE | V1 | MOUNTING INSTRUCTION | 202112 2
SCHLETTER SOLAR GMBH | SUBJECT TO CHANGES
MOUNTING INSTRUCTION AluTile
TOOLS NEEDED
Drill
Drill bit 8 mm, 5.6 mm
Screwdriver with bit insert
Bit T40
TIGHTENING TORQUES
Screw connections M8: 15 Nm
Exception: wood screws: depth stop
SAFETY INSTRUCTIONS
Planning, installation and commissioning of the solar power system must only be performed by
qualified technical personnel. Improper execution can result in damage to the system and
endanger persons.
Falling hazard! Working on the roof as well as ascending and descending poses a risk of falling.
It is vital to observe accident prevention regulations and use appropriate fall protection
equipment. PV mounting systems are not suitable as climbing aids or fall protection.
Injury hazard! Falling objects pose a risk of injury to people. Prior to installation, set up
barriers in the hazard area to warn people nearby.
ALUTILE | V1 | MOUNTING INSTRUCTION | 202112 3
SCHLETTER SOLAR GMBH | SUBJECT TO CHANGES
1. Uncover roof tile & mount load support Flex
•Select mounting position along the rafter
•Cover the tile that is to be replaced with the AluTile replacement tile
•Push bricks lying above or next to, the AluTile up or aside respectively
Remove more bricks if necessary
•Preassemble load support Flex
•Place the load support between the roof batten and the roof tile on the rafter and fix it
in place
•Adjust to suitable height
! The supplied M10x30 screw is suitable for roof batten thicknesses of 25 - 40 mm.
Longer set screws must be provided by the customer if required.
ALUTILE | V1 | MOUNTING INSTRUCTION | 202112 4
SCHLETTER SOLAR GMBH | SUBJECT TO CHANGES
2. Covering sheet metal replacement tile
•Slightly lift the upper shingle
•Hook sheet metal replacement tile to battens
•Apply waterproofing plate to underlying brick
ALUTILE | V1 | MOUNTING INSTRUCTION | 202112 5
SCHLETTER SOLAR GMBH | SUBJECT TO CHANGES
3. Position mounting plate and install AluTile system hooks
•Position mounting plate in the guide integrated in the sheet metal set tile above the rafter
•Drill through the existing holes of the mounting plate into the sheet metal replacement tile
– 2 holes diagonally
•Fasten mounting plate using two 8mm flat plate head screws and sealing washers
Special care must be taken to ensure that the screws are screwed in at right angles to the
mounting plate. The screw must press the seal onto the mounting plate all the way around.
•Insert system hook with adapter laterally into mounting plate
•Push surrounding bricks back into place
ALUTILE | V1 | MOUNTING INSTRUCTION | 202112 6
SCHLETTER SOLAR GMBH | SUBJECT TO CHANGES
More information on our systems can be found at our website: www.schlettergroup.com
in the Downloads area.
Table of contents
Other Schletter Inverter manuals
