schmersal AZ15-B1 Operation and maintenance manual

INSTRUCTIONS FOR OPERATION AND
ASSEMBLY
ACTUATOR AZ15/16-B1 TEST
Table of Contents
0.1 Purpose
0.2 Mounting instructions
0.1 Purpose
The actuators are preferably used on safety guards in conjunction with the AZ 15 or AZ 16 safety switches.
There are different actuator types available.
The actuators AZ 15/16-B1 are preferably used for sliding and removable safety guards.
For hinged guards, the AZ 15/16-B2, -B3 and -B6 actuator.
0.2 Mounting instructions
When the switch is fitted on a hinged safety guard, please ensure that the point of rotation is located within the range
of the upper surface of the safety switch, in which the actuator hook is inserted (refer to table).
FUse tamper-proof screws to prevent unauthorised removal of the switch; these screws are available as an accessory. Please
observe that, when fixing the switch e.g. by means of rivetting or welding, the insertion depth of the actuator is not modified.
Actuating radii [mm]
 
over the small edge of the actuator over the wide edge of the actuator
Rmin d Rmin d
AZ 15/16-B2 - - 45 11
AZ 15/16-B2-1747 - - 45 11
AZ 15/16-B3 32 11 - -
AZ 15/16-B3-1747 32 11 - -
AZ 15/16-B6 25 11 38 11

FSetting screw
For larger radius, the angle has to be adjusted correspondingly by turning the set screws a (AZ 15/16-B2), b (AZ 15/16-B3) and
a+b (AZ 15/16-B6), using an hexagonal key wrench 2.0 mm A/F. The basis setting provides a minimum radius.
Setting screw
FAZ 15/16-B1-2245 with rubber mountings
Max. 200 Ncm tightening torque for mounting the actuator.