SCULPTO BuildPlate Pro User manual

BUILDPLATE PRO WITH FLEX-FUNCTION
HOW TO INSTALL AND TAKE CARE OF YOUR NEW BUILDPLATE:
Place your new BuildPlate on the Printer’s Base. Check that the Buildplate can rotate 360 de-
grees when you attach it to the printer.
Product 45030005
2After printing is done, it’s time to remove the print from the BUILDTAK. Start by removing the
entire BuildPlate from the printer’s base.
INSTALLATION:
MAINTENANCE:
The surface of your BuildPlate –the BUILDTAK– should be cleaned before every print with an
Isopropyl Alcohol and a cloth.It prevents your prints from falling off the buildplate during printing.
USAGE:
1
A) B) C)
Adjust the nozzle height by ‘calibration of Z-axis’ OR turning the threaded rod manually while
rst layer is being printed. Like this:
Start printing. Every time you start to print, check how the rst layer of your print looks like:
Picture A: It’s all good - the nozzle squeezes the lament onto the Buildplate in ne coherent
layers and the lament can ow freely.
Picture B: The nozzle is too close to the Buildplate and the lament cannot go through the nozzle.
Picture C: The nozzle is too far away from the Buildplate. The print will fall off during printing.

4Flex the BUILDTAK with your hands to make the object loosen from the surface (when printing
smaller objects, a spatula can be used to help with the process).
5Now it’s time to place the BUILDTAK back on the BuildPlate – precision is required! Help
yourself by placing the BuildPlate between the 2 metal axises on the printer. Make sure that the
BulidPlate touches both axises.
Now, do the same with the BUILDTAK and bring the 2 parts together – be careful your ngers
can get squeezed!
6Check if the BUILDTAK and BuildPlate are perfectly aligned by placing the BuildPlate on the
Printer Base and rotating it 360 degrees.
If it rotates freely – great job! If not, you need to try to merge the BUILDTAK and the BuildPlate
again (don’t worry if it takes a few attempts to master the technique).
3Afterwards, detach the BUILDTAK from the base of the BuildPlate.