Second Wind 7512 User manual

Second Wind Air Purifier
711 Park Avenue
Medina, NY 14103
Ph: 585-798-5050 Fax: [phone]
MODEL 7512 USER INSTRUCTION’S
Read and Save these instructions
WARNINGS:
1. Always unplug or disconnect the air cleaner/purifier from
the power supply prior to servicing.
2. To reduce the risk of electrical shock or injury to persons,
do not expose unit to water or rain, do not use in a
window.
INSTRUCTIONS:
The casters are located in the plastic bag along with the five (5)
charcoal filter pads. Install the caster by inserting the screws
(included) into the predrilled holes located on the bottom of the
unit.
Plug unit into a three prong grounded outlet. The On/Off dial is
located on the side of the unit. Click the dial knob and the motor
will start. To adjust the speed, rotate the dial clockwise.
As the air enters the unit from the rear it is best to position the unit
6 to 8 inches from the wall. The air will be drawn from the entire
room.

Filter Maintenance:
Always unplug unit before changing the filters.
DO NOT WASH FILTERS. ALL FILTERS ARE DISPOSABLE.
To replace the filters first remove the 4 grille pins.
The 7512 comes with one (1) carbon panel, one (1) HEPA and six
(6) charcoal filter pads. The filter pads are to be replaced every 2
months and the carbon panel along with the HEPA replace once a
year.
Warranty:
Blower motor (#7512-VAR12)– 2 years
UV Lamp (# 1076R) – 1 year
Parts List:
6” HEPA (#7512-6”)
Charcoal filter pad (#7512-CHP)
Carbon Panel (#7512-CP)
Filter Replacement Kit (#7512 Filter Kit)
1 – 6” HEPA
1 - Carbon Panel
6 – Charcoal filter pads