Seconique CHARISMA LAMP TABLE User manual

CHARISMA LAMP TABLE
ASSEMBLY INSTRUCTIONS
IMPORTANT
FOR DOMESTIC USE ONLY
CARE AND MAINTENANCE
PLEASE READ BEFORE YOU CONTINUE FURTHER
PAGE 1
SEC/SH/03/19/CA1

* Use power tools to assemble this product will invalidate any
claim and damage this product making it unsafe !!!
* Please assemble on a clean soft surface to avoid damage.
* Please check contents and read the instructions before commercing assembly.
* Assemble this product folowing the enclosed instructions carefully.
* Please take care to avoid damaging panels during assembly.
PARTS LIST
PAGE 2
FITTINGS LIST
Please Note:
The below parts have all been stamped with the
part number to help identify them during assembly.
TOOLS REQUIRED SEC/SH/03/19/CA1
No. Part Name Qty.
01 Table Leg x4
02 Support Bar x4
03 Top Panel x1
01
01
01
01
02
02
02
02
03
Flat Head Screw
Ø4,0 x 30mm (4x)
A
Flat Head Screw
Ø5,0 x 55mm (8x)
B
Half Moon Bracket (4x)
C
Angled Bracket (4x)
D
Plastic Foot (4x)
E
Washer (4x)
F
Allen Key 3mm (1x)
G

PAGE 3
SEC/SH/03/19/CA1
Detail 1.1
E-Plastic Foot (4x)
2
1
C-Half Moon Bracket (4x)
A-Flat Head Screw
Ø4,0 x 30mm (4x)
Detail 1
CAUTION: DO NOT OVERTIGHTEN
1º INSERT HARDWARE "D" INTO THE GROOVES ON THE SUPPORT BARS.
2º LOOSELY TIGHTEN THE BOLTS, DO NOT OVERTIGHTEN.
Detail 2
Detail 2.1
01 4X
01 4X
02
02
F-Washer (4x)D-Angled Bracket (4x)
Detail 1 + 1.1
Detail 2 + 2.1
A
F
D
C
G-Allen Key 3mm (1x)
E
G
G-Allen Key 3mm (1x)
G
DD
ATTENTION: DO NOT PLACE
THE PLASTIC FOOT ON THE
SIDE WITH THIS HOLE
!
ALIGN THE TWO HOLES
AND LOOSELY TIGHTEN
C

PAGE 4
SEC/SH/03/19/CA1
4
3
01
02
Detail 2 + 2.1
Detail 2 + 2.1
01
02
CAUTION: DO NOT OVERTIGHTEN
CAUTION: DO NOT OVERTIGHTEN

PAGE 5
SEC/SH/03/19/CA1
6
5
B-Flat Head Screw
Ø5,0 x 55mm (8x)
01
03
Detail 2 + 2.1
Detail 3
Detail 3
Detail 3
Detail 3
Detail 3
Detail 3
Detail 3
Detail 3
Detail 3
G
B
G-Allen Key 3mm (1x)
For your future reference
Order number should be here
CAUTION: DO NOT OVERTIGHTEN
FIX THE FRAME TO THE TOP PANEL.
!! NOW FULLY TIGHTEN EACH LEG BOLT !!