Sauder WoodTrac422452 User manual

NOTE: THIS INSTRUCTION BOOKLET CONTAINS
IMPORTANT SAFETY INFORMATION.
PLEASE READ AND KEEP FOR FUTURE REFERENCE.
Call us at 1-855-854-7465
or vist us at
www.woodtrac.com Lot #: 506433 01 / 19 / 18
Purchased: ____________________
Cleat and Shelf Installation
422452 - 422617 - 422618 96" Back Cleat
422619 - 422620 - 422621 12" Side Cleat
422635 - 422636 - 422637 15-1/2" Side Cleat
418849 - 418851 - 419691 12" X 96" Shelf
419353 - 419354 - 419692 15-1/2" X 96" Shelf

Page 2 www.woodtrac.com 422452-422617-422618
Screws are shown actual size. You may receive extra hardware with your unit.
BLACK 2-3/4" FLAT HEAD SCREW (BACK CLEAT to wall)
SILVER 3/4" FLAT HEAD SCREW
(ROD BRACKET to UPRIGHT and
CLEATS)
SILVER 3/4" SELF DRILLING
(ROD to ROD BRACKET)
DRYWALL ANCHOR
ROD BRACKET METAL PIN
BLACK 1-15/16" FLAT HEAD SCREW
(UPRIGHTS to BRACE and SHELVES)
BLACK 9/16" LARGE HEAD SCREW
(ANGLE BRACKET to an UPRIGHT,
SHELF and SIDE CLEAT)
ANGLE BRACKET APPLIQUE CARD
Closet Shelving Components Overview
RIGHT
UPRIGHT
LEFT
UPRIGHT
12" OR 15.5" X
96" SHELF
12" OR 15.5" X
96" SHELF
SHELF BRACKET CLEAT
SHELF BRACKET CLEAT
24" ADJUSTABLE/
FIXED SHELF
24" ADJUSTABLE/
FIXED SHELF
24" Large Drawer
SHELF/ROD BRACKET
SHELF/ROD BRACKET
ANGLE
BRACKET
ROD BRACKET
CLOSET
ROD
CLOSET
ROD
CLOSET
ROD 96" BACK
CLEAT cut to size
96" BACK CLEAT
12" OR 15.5"
SIDE CLEAT
12" OR 15.5"
SIDE CLEAT
12" OR 15.5"
SIDE CLEAT
BRACE

1
1
S
t
e
p
Page 3
www.woodtrac.com422452-422617-422618
DRYWALL ANCHOR
Cut to size a 96" BACK CLEAT and fasten it to the back wall 80-1/8" from the floor using a BLACK 2-3/4" FLAT HEAD SCREW
through the groove of the BACK CLEAT and into all wall studs or a DRYWALL ANCHOR.
NOTE: Screws into wall studs must be 16" apart. If using DRYWALL ANCHORS only, they must be 12" apart.
Use DRYWALL ANCHORS and BLACK 2-3/4" FLAT HEAD SCREWS to fasten SIDE CLEATS to the wall.
BLACK 2-3/4" FLAT HEAD SCREW
(into a wall stud or DRY WALL ANCHOR)
80-1/8"
80-1/8"

2
2
S
t
e
p
Page 4 www.woodtrac.com 422452-422617-422618
Cut to size a 96" SHELF and slide it into the grooves of the SIDE CLEATS and BACK CLEAT as shown in the upper diagram.
Fasten the SHELF to the SIDE CLEATS with two ANGLE BRACKETS and eight BLACK 9/16" LARGE HEAD SCREWS.
NOTE: If you are installing a closet rod, install Rod Support Brackets using the Rod Support Side Bracket Template, before installing
ANGLE BRACKETS.
NOTE: If you purchased the Upright Pack and Adjustable Shelf/Brace Pack and/or the 24" Large Drawer Kit, see those Instruction
booklets on how to install those components.
BLACK 9/16" LARGE HEAD SCREW
(8 used for each ANGLE BRACKET)
12" or 15.5"
deep SHELF
12" OR 15.5"
SIDE CLEAT
12" OR 15.5"
SIDE CLEAT
BACK
CLEAT

3
3
S
t
e
p
Page 5
www.woodtrac.com422452-422617-422618
RECOMMENDED MAXIMUM LOAD:
Installation into wall studs offers a recommended maximum weight capacity of 625 lbs or 78.125 lbs per foot.
Installation into drywall anchors offers a recommended maximum weight capacity of 625 lbs or 78.125 lbs per foot.
BLACK 2-3/4" FLAT HEAD SCREW
(SHELF/ROD BRACKET CLEATS to wall)
SILVER 3/4" FLAT HEAD SCREW
(ROD BRACKET to SIDE CLEATS,
UPRIGHT, and BACK CLEATS)
SILVER 3/4" SELF DRILLING
(ROD to ROD BRACKET) DRYWALL ANCHOR
Use SIDE
CLEATS for shelf
side support
SHELF/ROD
BRACKETS
SHELF/ROD
BRACKETS
Support end of shelves that
end midwall with a SHELF/
ROD BRACKET.
Install ROD
BRACKETS using
Rod Support Side
Bracket template.
NOTE: Bottom screw
is 10.75" from the
BACK CLEAT and
2.5" down from the
bottom of the SHELF.
Install over studs or use
DRYWALL ANCHORS
APPLIQUE CARDS
Fasten SHELF/ROD BRACKET CLEATS over the wall studs using a BLACK 2-3/4" FLAT HEAD SCREW and a DRYWALL
ANCHOR if necessary.
Fasten SHELF/ROD BRACKETS with the SILVER 3/4" FLAT HEAD SCREWS ensuring that the SHELF is level.
Fasten ROD BRACKETS on SIDE CLEATS, UPRIGHTS or BACK CLEATS using the SILVER 3/4" FLAT HEAD SCREWS.
Fasten CLOSET RODS securing them with SILVER 3/4" SELF DRILLING SCREWS through SHELF/ROD BRACKETS.
Peel appliques from the APPLIQUE CARDS to cover screws and edges of SIDE CLEATS.
NOTE: Please read the back pages of the instruction booklet for important safety information.
This completes assembly. Clean with your favorite furniture polish or a damp cloth. Wipe dry.
Bottom of CLEAT 80-1/8"
from the floor
Bottom of CLEAT 38-1/8"
from the floor
32"
32"
32"

WARNING
Please use your furniture correctly and safely. Improper use can cause safety hazards,
or damage to your furniture or household items. Carefully read the following chart.
Look out for: What can happen: How to avoid the problem:
• Loose or unstable closet components.
• Tall closet component structures.
• Closet component structures that are
over five feet tall and placed in an open
area or a walk−in closet.
• Risk of injury
• Closet components that are not
properly connected can easily slide
against each other and cause the
structure to be unstable and tip over.
• A tall closet structure can tip unless it
is properly secured.
• Closet components must be securely
attached to each other from side to side,
and top to bottom.
• Secure the closet structure to a wall
stud whenever possible. If you cannot
use a wall stud, use the supplied wall
anchors into your drywall.
(If attaching the product to a wall made
of concrete, plaster, or other material,
purchase and use the appropriate
mounting hardware. The attachment
hardware must be rated to provide a
minimum of 50 pounds of pull
strength.)
• Overloaded drawers and shelves. • Risk of injury.
• Top−heavy furniture can tip over.
• Overloaded drawers or shelves can
break.
• Never exceed the weight limits shown
in the instructions.
•Work from bottom to top when
loading shelves and drawers. Place the
heavier items on the lower shelves or in
lower drawers.
• Improper use of furniture to support
TVs.
• Setting TVs on furniture items not
intended to support them is hazardous.
• Risk of injury.
• TVs can be very heavy. Plus the
weight and location of the picture tube
tends to make TVs unbalanced and
prone to tipping forward.
• This product is not designed to support
a television.
Page 6 www.woodtrac.com 422452-422617-422618

WoodTrac® by Sauder provides limited lifetime warranty coverage on
WoodTrac® Closet Products (the "Products") to the original first use retail
consumer ("Consumer") as set forth in this limited warranty statement. This
limited warranty gives you specific legal rights, and you may also have other
rights which vary from state to state.
Limited Lifetime Warranty Coverage: WoodTrac® warrants that the Products will
be free from defects in material and workmanship under conditions of normal,
residential use, for the lifetime of the Products. This limited warranty extends only
to the original, first-use retail Consumer, and is not transferable.
Limitations on Warranty Coverage: WoodTrac's® Limited Lifetime Warranty
(described above) is the only warranty coverage provided by WoodTrac®
for the Products, and is in lieu of all other warranties. Under the laws of
certain states, there may be no implied warranties from WoodTrac®, and ALL
IMPLIED WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ARE
DISCLAIMED AND EXCLUDED TO THE FULLEST EXTENT ALLOWED
BY LAW.
Exclusions from Coverage: This limited warranty does not cover defects arising
from (1) the improper installation or use of the Products; (2) abuse or neglect;
(3) any commercial, rental or non-residential use of the Products (including the
installation and use of the Products in a commercial or rental structure); or (4)
normal wear and tear.
Exclusive Remedy: WoodTrac® will (at its option) repair or replace any defective
Products (or components) at no charge, subject to confirmation of the defect and
proof of purchase, as the sole and exclusive remedy under this limited warranty.
This limited warranty does not cover costs for installation, returning any defective
Products to WoodTrac®, for removal or other labor costs in connection with the
repair or replacement of the Products, all of which shall be the responsibility of
the Consumer. WoodTrac's® liability under this limited warranty shall not exceed
the purchase price of the Products. WoodTrac® shall have NO LIABILITY FOR
ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY KIND, and
all such claims and damages are DISCLAIMED AND EXCLUDED FROM THIS
LIMITED WARRANTY. You must notify WoodTrac®, in writing, within 90
days after discovering any defect in order to receive limited warranty coverage.
Some states do not allow limitations on how long an implied warranty lasts, or
the exclusion or limitation of incidental or consequential damages, so the above
limitations may not apply to you.
To Obtain Warranty Service or Information: For warranty inquiries or claims,
contact WoodTrac® at 1-855-854-7465, 502 Middle Street, Archbold, OH (USA)
43502, [e-mail]. Return of any defective Product may be required
by WoodTrac®, or we may elect to examine the product at its location. If we ask
you to ship any Products to us, we will issue you a return authorization number
and provide return instructions. For returned Products to qualify for limited
warranty coverage, they must be returned in the original or equivalent packaging,
in accordance with the shipping instructions you receive from us, and must
prominently display the return authorization number on the return package.
WOODTRAC® CLOSET PRODUCTS LIMITED WARRANTY
Page 7
www.woodtrac.com422452-422617-422618

Certificate of Conformity
1. This certificate applies to the Sauder Woodworking
Product identified by this Instruction Book.
2. This certificate applies to compliance of this
product with the CPSC Ban on Lead-Containing
Paint (16 CFR 1303).
3. This product is manufactured by:
Sauder Woodworking Company
502 Middle Street
Archbold, Ohio 43502
[phone]
4. Date of Manufacture: __________________________
register your new
product online
For immediate service, our website is available
24 hours a day, 7 days a week to order replacement
parts, register your product, and view Woodtrac
products. www.woodtrac.com
Consumer Services in United States and Canada
Mon.-Fri. – 9am-5:30pm ET(except holidays)
1-855-854-7465
Trust Sauder
Sauder has been making wood products since 1934.
Today we offer a wide range of products, mostly made
right here in Archbold, Ohio, and supported by our
award-winning customer service.
WoodTrac®Closets by Sauder are supported by our
Limited Lifetime Warranty and offers the same
made-in-the-USA advantages as the rest of our
product line.