Sencor SFH 7020WH Operation instructions

10/2019
- 1 -
Copyright © 2019, Fast ČR, a.s.
EN Hot Air Fan Heater
Translation of the original manual
This product is only suitable for well insulated spaces or occasional use!
SFH 7020WH
SFH 7021BK

10/2019
- 2 -
Copyright © 2019, Fast ČR, a.s.
EN Hot Air Fan Heater
Important safety instructions
READ CAREFULLY AND STORE FOR FUTURE USE.
■This appliance may be used by children older than 8 years of age and by persons with
physical or mental impairments or by inexperienced persons, if they are properly
supervised or have been informed about how to use the product in asafe manner and
understand the potential dangers.
■Children must not play with the appliance. Cleaning and maintenance performed by the
user must not be performed by unsupervised children.
■In the event that the power cord is damaged, have it repaired at aprofessional service
centre to prevent causing adangerous situation. It is forbidden to use the appliance if it
has adamaged power cord.
■Children younger than 3 years of age should be prevented from accessing the appliance
unless they are under constant supervision.
■Children from 3 to 8 years of age may only turn this appliance on and off under the
condition that it is located or installed in its intended normal operating position and that
they are under supervision or were informed about the safe operation of the appliance
and understand the potential hazards. Children from 3 to 8 years of age must not
insert the plug into the power socket or clean the appliance or carry out maintenance
performed by the user.
Attention:
While it is running, certain parts of this appliance may become very hot and
cause burns. Special attention should be paid when children and handicapped
people are present.
Attention:
Do not cover the appliance as this could result in it overheating.
■Do not locate the appliance directly under an electrical power socket.
■Do not use the appliance in the near vicinity of abath, shower or swimming pool.
■This appliance is not intended to be mounted on awall.
■Do not subject people or animals to the direct flow of hot or cold air for an extended
period of time. This could negatively affect their health.

10/2019
- 3 -
Copyright © 2019, Fast ČR, a.s.
■Before connecting the appliance to apower socket, check that the rated voltage on its
rating label matches the electrical voltage in the power socket.
■Do not connect the appliance to an extension cord or two way adapter.
Attention:
Do not use this appliance with aprogrammer, timer switch, aremote control
system or any other device which would switch the appliance on automatically,
because there is a danger of a fire if the appliance is covered or incorrectly
located.
■The appliance is designed for use in households, offices and similar types of areas.
■Do not use the appliance in very dusty or humid rooms such as laundries or bathrooms,
in areas where chemicals are stored, in industrial surroundings or outdoors.
■When the appliance is in operation, it must not be located on an unstable surface, e.g.
sofa, carpets with very long and thick fibres, etc. The appliance must always be located
on an even, dry and stable surface.
■Free space of at least 50 cm in front of the appliance and 30 cm behind the appliance
must be maintained while it is running to ensure sufficient air circulation. Do not use the
appliance in the near vicinity of curtains, drapes or other flammable materials.
■Do not insert any objects through the front air outflow grill or the back air inflow grill.
This could lead to an electrical short circuit or damage the appliance.
■To avoid potential injury by electrical shock, do not submerge any part of this appliance
under water or any other liquid.
■Do not touch the appliance with wet or damp hands when it is connected to apower
socket.
■Do not leave the appliance in operation while sleeping.
■Always turn off the appliance and disconnect it from the power socket when not using
it or before cleaning it.
■To avoid damaging the power cord, do not bend or twist it. Make sure that it does not
come into contact with hot surfaces or sharp objects.
■Do not disconnect the appliance from the power socket by pulling on the power cord.
This could damage the power cord or the socket. Disconnect the cord from the power
socket by gently pulling the plug of the power cord.
■If the power cord is damaged, it must be replaced by an authorised service centre or by
another similarly qualified person, this will prevent the creation of adangerous situation.
■Do not use the appliance if it is not working correctly, if it has been damaged or has
been submerged in water.To avoid the danger of injury by electrical shock, do not repair
the appliance yourself or make any adjustments to it. Have all repairs of the appliance

10/2019
- 4 -
Copyright © 2019, Fast ČR, a.s.
performed at an authorised service centre. By tampering with the appliance, you risk
voiding your legal rights arising from unsatisfactory performance or quality warranty.
■The manufacturer is not responsible for any damages caused by the incorrect use of this
appliance.

10/2019
- 5 -
Copyright © 2019, Fast ČR, a.s.
SFH 7020WH
SFH 7021BK
MIN MAX
MIN MAX
OFF
A
5
4
2
6
7
1
3

- 6 - 10/2019 Copyright © 2019, Fast ČR, a.s.
EN Hot Air Fan Heater
User'smanual
■ Prior to using this appliance, please read the user’smanual
thoroughly, even in cases where you have previously
familiarised yourself with the operation of similar types of
appliances. Only use the appliance in the manner described
in this user’smanual. Keep this user’smanual in asafe place
where it can be easily retrieved for future use.
■ We recommend saving the original cardboard box,
packaging material, purchase receipt and responsibility
statement of the vendor or warranty card for at least the
duration of the legal liability for unsatisfactory performance
or quality. In the event of transportation, we recommend
that you pack the appliance in the original box from the
manufacturer.
DESCRIPTION OF THE APPLIANCE
A1 Power indicator light
A2 Temperature control knob
A3 Turn switch for starting
just the fan,
for setting the power
level Ior II
and for turning off the
appliance.
A4 Air outlet grill
A5 Fan and heating elements
These parts are hidden
underneath the grill.
A6 Integrated carry handle
(not shown)
it is located at the rear of
the appliance.
A7 Air inlet grill
(not shown)
it is located at the rear of
the appliance.
OPERATING THE APPLIANCE
■ Before first use, remove all packaging materials including
promotional stickers and labels from the appliance.
■ Locate the appliance in a suitable location in accordance
with the safety instructions. Make sure that the inflow or
outflow vents A7 or A4 are not blocked, that the temperature
control knob A2 is set to minimum and the switch A3 is in
position 0 (off). Connect the appliance to a power socket.
After connecting the appliance to apower socket, indicator
light A1 will be lit.
1. SETTING AN OPERATING MODE
■ Set the temperature control knob A2 to maximum and select
the desired operating mode using switch A3.
Setting switch A3 Description of operating mode
0O
Air ventilation without heating.
Only the fan is running. Heating
elements are turned o.
I
Power is set to alow level (1200 W).
The fan and one of the two heating
elements are running.
The heating element heats the air
and the fan ensures its ow into
the room.
II
Power is set to ahigh level (2000
W). The fan and both the heating
elements are running. The heating
elements heat the air and the fan
ensures its ow into the room.
Note:
Upon first use or after it has not been used for an
extended period of time, aslight odour may be sensed
from the appliance. This is completely normal and will
quickly disappear.
2. TEMPERATURE CONTROL KNOB SETTING
■ The appliance is equipped with athermostat that serves to
maintain the desired temperature in the room.
■ To heat up the air in the room as fast as possible, set switch
A3 to the high power level and the temperature control
knob A2 to maximum. When the desired temperature has
been reached, slowly turn the temperature control knob A2
anticlockwise until you hear aclick. The set thermostat will
automatically switch the fan and heating elements A5 on
and off to maintain the desired temperature.
3. TURNING OFF
■ When you have finished using it, set the temperature
control knob A2 to minimum, set switch A3 to position 0
(off) and disconnect the power cord from the power socket.
After disconnecting the appliance from the power socket,
indicator light A1 will turn off. Allow the appliance to cool
down.
AUTOMATIC SHUT-OFF FUNCTION
■ The appliance is equipped with a safety mechanism that
automatically turns it off when it is accidentally knocked
over. After returning the appliance back to the operating
position, it will start running again.
THERMAL PROTECTION
■ The appliance is equipped with athermal fuse that turns it
off upon overheating. Should such a situation occur, turn
the appliance off and disconnect it from the power socket.
Make sure that the air inlet and outlet openings A7 or A4
are not blocked. Allow the appliance to cool down before
attempting to put it back into operation as this will give the
thermal fuse time to reset.
■ If you are unable to put the appliance back into operation,
contact an authorised service centre.
CLEANING AND MAINTENANCE
■ Before cleaning it, make sure that the appliance is turned off
and disconnected from the power socket. If the surface of
the appliance is hot, allow it to cool down.
■ Use a dry or lightly dampened wiping cloth to clean the
surface of the appliance. Then thoroughly wipe everything
dry. Dust that has settled inside the appliance can be
vacuumed out using avacuum cleaner through the air inlet
and outlet grills A7 and A4.
■ For cleaning, do not use cleaning products with an abrasive
effect, solvents, etc. Otherwise, outer surface of the
appliance may be damaged. Do not submerge the appliance
or its power cord in water or any other liquids.

- 7 - 10/2019 Copyright © 2019, Fast ČR, a.s.
TECHNICAL SPECIFICATIONS
Rated voltage range ........................................................220 - 240 V~
Rated frequency ............................................................................. 50 Hz
Rated power ................................................................................2000 W
Power input settings ..............................................1 200 W/ 2 000 W
Electrical shock protection class........................................................ II
Noise level ...................................................................................55 dB(A)
The declared noise emission level is 55 dB(A), which represents
alevel Aof sound power with respect to areference sound
power of 1 pW.
We reserve the right to change text and technical
specifications.
Explanation of technical terminology
Safety class for electrical shock protection:
Class II – Electrical shock protection is provided by double or
heavy-duty insulation.
Changes to text and technical parameters are reserved.
INSTRUCTIONS AND INFORMATION REGARDING THE
DISPOSAL OF USED PACKAGING MATERIALS
Dispose of used packaging material at a site designated for
waste in your municipality.
DISPOSAL OF USED ELECTRICAL AND ELECTRONIC
EQUIPMENT
This symbol on products or original documents
means that used electric or electronic products
must not be added to ordinary municipal waste.
For proper disposal, renewal and recycling hand
over these appliances to determined collection
points. Alternatively, in some European Union
states or other European countries you may return
your appliances to the local retailer when buying an equivalent
new appliance.
Correct disposal of this product helps save valuable natural
resources and prevents potential negative effects on the
environment and human health, which could result from
improper waste disposal. Ask your local authorities or
collection facility for more details.
In accordance with national regulations penalties may be
imposed for the incorrect disposal of this type of waste.
For business entities in European Union states
If you want to dispose of electric or electronic appliances, ask
your retailer or supplier for the necessary information.
Disposal in other countries outside the European Union
This symbol is valid in the European Union. If you wish to
dispose of this product, request the necessary information
about the correct disposal method from the local council or
from your retailer.
This product meets all the basic requirements of EU
directives related to it.