SENKO SCK-SS-M-200 User manual

1 2.0mm SMART CLEANER Fiber Optic Cleaner
www.senko.com
Key Features For Cleaning SMPTE 304M Connectors
2.0mm SMART CLEANER
Fiber Optic Cleaner
Best Practices
120mm
Short housing for access connectors in conned spaces
Rotating cleaning tip uses a sweep
& lift motion for eectively wiping
away residues and dust particles
No need for sleeve removal tools since cleaning
tip works for cleaning both Jack and Plug ends
Dissipative barrel prevents static charge
generation during cleaning process
Cleans 400+ endfaces with no
need for cleaning solvents
P/N SCK-SS-M-200

2 2.0mm SMART CLEANER Fiber Optic Cleaner
www.senko.com
Best Cleaning Results For Plugs:
Best Cleaning Results For Jacks:
1
1
1
2
2
2
3
4
3
3
Open cover on red end cap
Hold cleaner towards the rear keeping
nger tips located on the ridges
Push forward until audible click
1
2
3
4
Place red end cap on back of handle
Hold cleaner towards the rear keeping
nger tips located on the ridges
Insert cleaning tip into the jack
Push forward until audible click
Cleaning Plug & Jack

3 2.0mm SMART CLEANER Fiber Optic Cleaner
www.senko.com
Demonstration Of Typical Cleaning Performance
After one engagement
Fine dust particles
After one engagement
Skin oil residue
After one engagement
Moisture residue
from duster
Step 1:
Apply contaminate
Step 2:
Engage cleaner one time
Step 3:
Check and record image
1 2 3
Test Setup For Cleaning Demonstration

4 2.0mm SMART CLEANER Fiber Optic Cleaner
www.senko.com
America
USA EAST 1-888-32-SENKO
USA WEST 1-858-623-3300
TEXAS 1-972-661-9080
[e-mail]
Asia
HONG KONG [phone]
SHANGHAI [phone]
SHENZHEN [phone]
[e-mail]
Europe
UK [phone]
ITALY [phone]
POLAND + 48 71 396 36 59
[e-mail]
Asia Pacic
AUSTRALIA [phone]
Sales-Asia-Paci[e-mail]
Japan
TOKYO [phone]
[e-mail]
South America
BRAZIL [phone]
[e-mail]
www.senko.com
Tips
• Always clean both ends (plug & jack) just before mating
for preventing cross contamination.
• If you use canned air dusters in your cleaning regiment,
always hold the cans upright to prevent the moisture
contamination from the air stream.
• Always clean ber end faces after blowing connectors
with canned air dusters to remove dust particles that may
have landed on ferrule surface.
• Remember the SMPTE 304M has electrical contacts so take
precautions when using solvents to avoid shorting the circuit.
• Never look directly at the ber end faces unless you
know the signal is o - the wavelength for the optical signal
wavelength is 1100nm to 1350nm which is beyond visibility
of the human eye.
2.0mm SMART CLEANER Tip
Fiber Optic Ferrule
Low Voltage Electrical Contact
(42V AC or 60V DC with 1A current)
Auxiliary Electrical Contact
(600V AC with 10A current)
View of 2.0mm SMART CLEANER on Plug