Sense New Vision SNS 1t NV Installation guide

Locating system
SNS 1t NV
Quick manual
• transmitter SNS MSt2;
• adapter for transmitter;
• receiver SNS 1t;
• manual;
• WiFi R-Box;
• SNS 1t bag;
• receiver Li-Ion battery with
power cable.
Equipment:
22/14 Oktyabr`skaya str. Ulyanovsk. Russia.
[phone], [email protected], www.sense-hdd.ru

3m calibration
2
Preparations
1. Turn ONReceiver by pushing and holding Power button until sound signal
and turning ONthe screen.
2. Put AA battery into transmitter, close thecap and wait for appearing data
onthe screen.
3. Put thetransmitter into thedrill head (use adapter if needed) with orienting
on“12o`clock” position. Put drill head in3meters from left (right) side of
theReceiver like onthe picture below.
4. Press and hold button to start calibration process. Keep holding button
press button until 3.00 m numbers will appear. Unleash both buttons.
5. CALIBRATION ISDONE

3
6. Clock position correction– correction clock face position of thedrill head
onthe screen. To make it– turn ONReceiver and transmitter, put drill head
with thetransmitter inneeded clock position, press and hold button and
then press button to confirm. New correction can be done after canceling
previous one. To cancel correction– turn OFF thetransmitter and make
correction again. Position will back to 12o`clock.
Location screen
Navigation buttons
Quality of
transmitter
signal
Power of
transmitter
signal
Transmitter
battery level
Receiver
battery level
Transmitter
temperature
Predicted
depth in
front (F)
point
Depth
Transmitter
angle
Horizontal
distance to
the probe
1. 3m calibration
2. Switching telemetry
channel
3. Switching locating
points
4. Clock correction
5. Power ON/OFF and
lighting
Around FRONT locting point
Around Locating Line
1 2 3 4 5

4
F
WIFI R-Box
Displaying information onthe screen
of theAndroid device using WiFi R-Box
1
34
76
5
2
1. Device ON/OFF button with light indicator
2. WiFi module ON/OFF button with light indicator
3. Telemetry level scale
4. Device battery scale
5. Plug for the antenna
6. MicroUSB plug for direct connection to Android device and for power charging.
7. USB – MicroUSB cable
Hardware and software complex Wi-Fi R-Box is designed for duplication
information from the Receiver to control device with OS Android version 4.4 and
higher.

5
IMPORTANT: In the case of a wired connection, the Android control device
must support USB-OTG or USB-Host function.
IMPORTANT: Starting with Android version 9 and higher, to work snsvision©
App with the device via Wi-Fi, it is necessary enable «Geolocation»; Starting
with Android version 6, permissions are needed to be set each time, when
snsvision installing or App update.
Wireless connection:
a. Torn On Wi-Fi module on Android control device;
b. Connect the Android control device to Wi-Fi network R-Box;
c. Make sure you have the required permissions are allowed. To do this, go
to the section «Apps» in device settings → find and select an application
snsvision© –> in the «Permissions» subsection, enable all required
permissions;
d. Launch the SnsVision© App.
Wi-Fi R-Box connection
Install the application SnsVision© from GooglePlay to an Android device if it is
not installed.
Wired connection:
a. Connect Wi-Fi R-Box via USB-OTG cable, turn On Wi-Fi R-Box (switch-on
indicator should be lit);
b. Launch snsvision© App SnsVision©.