Sensit CO Programming manual

Quick-Start Instructions
HINT: As you approach the source of the
leak continue adjusting the wheel without
moving the sensor head to a uniform tick
sound until you locate the exact location of
the leak.
IMPORTANT: When replacing the
gooseneck into the clip on the right side,
wrap the gooseneck in a wide circular
manner counter-clockwise around the back
of the instrument. Bending in the opposite
direction may cause damage over the life of
the product.
WARNINGS:
To prevent ignition of ammable or combustible
atmospheres, disconnect power before servicing.
To reduce the risk of ignition of a ammable
atmosphere, batteries must only be changed in
an area known to be nonammable.
Do not mix batteries of different age or type.
This is not a substitute for the
instruction manual. It is for
reference only.
Read and understand the
instruction manual before use.
MADE IN USA
Distributed by:
851 Transport Drive
Valparaiso, IN 46383-8432
Phone: [phone]
Web: www.gasleaksensors.com
SENSIT®CO
SENSIT®GOLD
SENSIT®GOLD 100
SENSIT®GOLD CGI
SENSIT®GOLD G2
SENSIT®HCN
SENSIT®HXG-2
SENSIT®HXG-2d (2dr)
SENSIT®HXG-3 (3P)
SENSIT®P100
SENSIT®P400
SENSIT®PMD
SENSIT®RLD-2
SENSIT®TKX
TRAK-IT®IIIa
ULTRA-TRAC®MJL
GAS-TRAC®
EX 1000
SMART-CAL
TM
SCAL-100
SCAL-NTM
Innovative Detection Solutions

1. Install the batteries by pushing down
the locking tab and sliding the handle
away from the top of the instrument. When
replacing handle be sure the tab is securely
in place and replace the retaining screw.
2. IMPORTANT: CAREFULLY OBSERVE
POLARITY WHEN CHANGING BATTERIES.
Instrument will not function with improperly
installed batteries.
3. Slide the on/off switch to the right to turn on.
4. Allow unit to go through the warm up
sequence in clean air. The tick will sound
and the leak indication light will ash for a
few moments. This requires up to 60 seconds
to fully warm up.
5. Extend the goose neck (the sensor and
cap is at the tip).
6. You are now ready to use the instrument.
You can now enter the area and detect gases.
7. To locate the source of an odor, rotate the
center wheel until there is a uniform ticking
sound. Increased gas concentration will
cause an increase in the speed of the ticking
sound. As you approach the leak rotate the
wheel counter-clockwise to slow the speed.
Rotate clockwise to increase the speed
(indicating lower gas concentrations).
8. When your investigation is complete slide
the switch to the off position.
SENSIT®TKX
QUICK-START INSTRUCTIONS