Sentiotec PHONIX-S User manual

1/12
User’s manual
EN
Infrared Cabin
PHÖNIX-S (1-030-313)
2017/04

2/12
EN
PREFACE
Thank you very much for purchasing our product.
Please read this manual carefully before assembling and save it afterwards. Please write down the control box
serial number of the cabin as this number will be required in case of repair or order of spare parts.
ATTENTION

Check power supply rating and make sure the grounded outlet is correctly connected before installation.
Use original parts only. Do not share the outlet with any other appliances.
When not in use, turn off the cabin’s power unit.

DANGER



Do not touch the radiator during and shortly after use as a burning hazard exists due to hot parts.
The light bulb heats in use. If the bulb needs to be changed, unplug the cabin and let the bulb cool down
before changing it.
Should the electrical connection get damaged, it must be replaced-either by the manufacturer or by

WARNING
If you suffer from illness or other health-related problems, especially heart conditions or circulatory
disturbances or if you take medication, you should consult a doctor before using the infrared cabin.
Children and frail persons should never be in the cabin without supervision.
If you feel uncomfortable while using the infrared cabin, stop immediately and consult with your doctor.
Never go to a hot infrared cabin if you have taken alcohol, strong medicines or narcotics.
Technical data
Model 
Cabin material Canadian red cedar
Length 1000 mm
 1020 mm
Height 2000 mm
Voltage 
Radiators Type Halogen radiators with red glass
Total output  
Back panel 
 
Calves 

3/12
EN
Cabin Individual parts (variations possible)
NO NAME Q’TY
1 1
2 1
  1
4 1
  2
  1
7 1
  1
  1
10  1
11  1
12  1
  1
14  2
PARTS LIST

4/12
EN
Hardware parts (variations possible)
Rubber strip    
10m 1x  2x 1x
Assemble tips
Please remove transport packaging and inspect that your infrared cabin has been delivered complete
and intact before beginning assemble.
A least 2 persons are required for assemble of the cabin
Please check the countersink and hole diameter of the drill holes to avoid damaging the wood.
The minimum room height required for installation is 2120 mm
Tools
ASSEMBLE INSTRUCTIONS
Pencil
Spirit level



Cutter
Hammer
Tape measure Electric drill
Stepladder

5/12
EN
Assemble steps
ASSEMBLE INSTRUCTIONS
Note: back panel has ventilation slits
must keep 5 cm away from the next wall

6/12
EN
4-Φ4*45
Assemble steps

heater cable

from the bench panel
ASSEMBLE INSTRUCTIONS

7/12
EN
Assemble steps

ASSEMBLE INSTRUCTIONS
4-Φ4*45
Rubber
Strip
Hex screw
Hinge bottom
Hinge surface


Glass door
Handle
Glass door
Handle
Wood cover

8/12
EN
Plug
Calves
Input Voltage
Power Rating
Current Rating
Safety Grade
Model

Back
Electric control box

Temperature Control
 
Control panel

Antenna
Color light AC12V/7W


CIRCUIT DIAGRAM

9/12
EN

COLOR LIGHT


MAIN POWER 


BACK HEATER
CALVES HEATER

CONTROL PANEL


ANTENNA
SPEAKER
SPEAKER




SPOTLIGHT



TEMP OVERHEAT CONTROL


CIRCUIT DIAGRAM

10/12
EN
OPERATING INTRUCTIONS
Connect the power unit to wall outlet, the LED indicator will start to blink on the display. Now it is possible to
switch on the infrared heaters, the light and the music function.
1) Startup
Press to switch on the cabin and heaters start to work, the length of time

be displayed. Press again switch off the heaters.
Press / / 
calves heaters from 100%-0%.
2) Temperature settings
The upper display refers to the air temperature. Press , you can set
 / keys. When at this

below this temperature, the cabin will start up automatically.
Please note: The maximum air temperature reachable in the cabin
may be lower than the desired temperature. This is dependent on
the temperature outside the cabin.
3) Time settings
The lower display refers to the length of time. Press 
the / keys. After this time, the heaters will shut off automatically.
4) Sky light
Short press  to go into an automatically

5) Fan

switch on. In automatic mode, the fan switches on when the set cabin air temperature is reached.
Press once for manual mode, the fan switches on. Press once more for close mode, it switches off.
6) FM radio
Press 
the /  / keys.
7) Mp3 player
Press 
 
player. Select the preferred mode with brief repeated presses of the


You can select songs by short pressing the / 
the / keys. The key for pause.

Long press 
You can select stations by short pressing the / 
the / keys.
8) Remote control included

11/12
EN
SERVICE
Notes:
Use instructions
Drink plenty of liquids before and after use of the infrared cabin.
Dry yourself off completely.

After a heating period of an hour at the latest, the cabin should be switched off and a heating brake of

It is recommended to take a warm shower and relax after use.
Maintenance instructions
Clean the cabin with a damp cotton towel, dry with a clean dry towel.
Clean the glass with a window/glass cleaner and a soft cloth.


Do not use chemical detergents to clean the cabin.
Please fasten the screws of the bench once every three months, avoid the loose or drop off.

12/12
EN
GUARANTEE CARD
SERVICE
Control unit label

______________________________________________
 _______________________________
 _________________________________
 ______________________________
 ________________________________________
 ________
Please encircle on picture below which heater or which panel
has a fault.
Attach pictures of the problem and send them through email.