Serta SOFA User manual

SOFA
TOLL FREE 1-877-693-8866 LIFESTYLE SOLUTIONS
12 of 12 Rev.050415

PARTS AND HARDWARE
Avoid using sharp objects such as a knife to open packaging as you may accidentally damage the upholstery.
2 of 12
M5 Allen Key
1x
M8 Nut
4x
14mm Mini Spanner
x1
M8 x 16mm Bolt
22x
Left Sofa Body
1x
Leg
4x
Metal Cap
4x
Plastic Cap
4x
Sofa Cover
1x
Center Leg
1x
Connecting Bar
2x
Right Sofa Body
1x
11 of 12
Sofa with Armrest
ADJUSTING ARMREST POSITIONS
1. Standing in front of the unit, lift the armrest to the desired position and secure it in
place by releasing to the sound of a click.
To return to a flat position, lift the armrest all the way up to the end, releasing the
locking mechanism and carefully return to a flat position.
IMPORTANT
During conversion, ensure lifting is done on bottom of armrest.
2.

ASSEMBLY INSTRUCTIONS
CAUTION: At least two adults are required to safely performing this task.
Other lifting attempts may risk back injury due to large and heavy part(s).
Carefully place all components and hardware on a flat surface.
Place sofa legs as shown below, align metal cap and plastic cap onto the bottom of
metal legs, use Allen key to secure the metal cap, plastic cap and leg with a bolt.
1
10 of 12 3 of 12
Converting to Bed
From sofa or lounge position, lift backrest all the way upwards until the last click is heard
which unlocks the mechanism. Carefully return to a flat position.
Splitback

4 of 12 9 of 12
Place sofa body as shown below.
Insert both connecting bars to bottom metal frame (left sofa body), until pre-drilled
holes are aligned. Next secure the metal frame and connecting bar with two bolts at
each side. Do not tighten them yet.
Repeat Step 2 on the right sofa body as shown below.
2
3
Converting to Sofa
Standing at the side of the unit (from bed position), lift backrest to the desired position
and secure in place by releasing to the sound of a click.
OPERATING YOUR UNIT
Converting to Lounger
In bed position, lift backrest upwards with each click sound until the desired lounge
position is reached.

8 of 12 5 of 12
4Align the center leg onto the pre-drilled holes located on the metal frams and
secure with two bolts using the Allen key provided. Tighten all bolts completely.
Repeat Step 7 for locating the pegs on the seat of sofa.
9
Finally, stretch and pull down the rear, seat body, and front cover
evenly before securing the velcro strip to the bottom of the backrest
and seat base. Repeat if necessary for a better fit.
10

6 of 12 7 of 12
Carefully lift and turn assembled unit onto its legs. Lift backrest to sofa position as
shown below (refer page 9 “Operating Your Unit” ).
6
Begin to place the cover onto the back of the sofa.
Slip the cover onto both sides of the backrest at the same time.
Secure the inside of the cover with the elastic loops and pegs
located on the sofa body. Ensure all pegs on the backrest and
center of the sofa are secured.
7
5Align the front legs in the correct direction and secure two bolts with the Allen
key. Next, Align the back legs in the correct direct direction and secure two
bolts and two nuts again using the Allen key provided.
Lift the armrest to the desired position as shwon below (refer page 9 “Operating Your
Unit”). Now start to slip on the armrest cover as shown below.
8