1. Plug your Socket Shelf™ device into a standard 120V AC grounded outlet.
This 6 outlet Socket Shelf™ Outlet is rated at 15 amps at 125VAC total. Six devices may be plugged
into the tap, but their combined load must be less than 15 amps at 125V AC or 1875 watts.
Slide the shelf along the grooves until the shelf is flush with the rear of the unit.
OPTIONAL: Use included screw to secure the middle of the Socket Shelf™ to the outlet.
© 2019 APG
All Rights Reserved.
Socket Shelf is a Trademark of APG
Made In China
Patent Pending
IM3
Model: 00609
Socket Shelf
FOR TIPS AND INSTRUCTIONAL VIDEOS, PLEASE VISIT
WWW.SOCKETSHELFTIPS.COM
INSTALLING THE SHELF
This device features an internal protection circuit that will disconnect the surge protective
component in the event of a power surge that exceeds the load of the circuit. Once the surge
protective circuit has been disconnected, the product will no longer protect against power
surges, although it will still function as a power strip. In this situation, the LED will no longer
illuminate, indicating that the device is no longer protected from power surges. If this situation is
undesirable for the application, follow the manufacturer’s instructions for replacing the device.
Plug 2-Prong or 3-Prong cords
into the desired sockets.
USING THE SOCKETS Warning: Changes or modications to this unit not expressly
approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interfer-
ence to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment o and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
This Class B digital apparatus complies with Canadian ICES-003.
GROUND SIDE
UP OUTLETS:
The Socket Shelf™ can be installed
with ground side up outlets, with
the shelf installed on the lower
slots of the main unit.
