Shop fox SHOP FOX W1789 User manual

Specifications
Square Drive Size.............................................1⁄2"
Maximum Torque.....................................230 ft/lbs.
No Load Speed........................................7,000 RPM
Air Inlet...................................................1⁄4" NPT
Required PSI................................................90 PSI
Average Air Consumption.................................4 CFM
Weight........................................................6 lbs.
Inventory
A. Air Impact Wrench ........................................1
B. 1⁄4" NPT Quick Connect Fitting (male) .................1
Operation
To improve tool lifespan, use a filter/lubricator/regulator
as shown in Figure 2. Otherwise, lubricate daily with a
couple drops of pneumatic tool oil directly into the air fit-
ting as shown in Figure 3.
CAUTION: Shattering hazard! Standard sockets may
break apart if used on this tool. Use sockets rated for
impact wrench use only.
Figure 3. Lubricating directly into air
fitting.
COPYRIGHT © JUNE, 2007 BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT
THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC. Printed in China#9578JM
Model W1789
1⁄2" Impact Wrench
Instruction Sheet
Phone #: [phone] • Online Tech Support: [e-mail] • Web: www.shopfox.biz
EYE INJURY HAZARD!
Always wear safety glasses during
use to prevent serious personal
injury!
INJURY HAZARD!
Always disconnect tool from air to
prevent unexpected operation dur-
ing service!
INJURY HAZARD!
Never exceed 120 PSI!
Quick
Connector
Quick
Coupler
Air Hose Quick
Coupler
Quick
Connector
Lubricator
Filter
Regulator
Air
Compressor
Your
Tool
Figure 2. Installing your tool.
Figure 1. Model W1789.

-2-
W1789 1⁄2" Impact Wrench Instructions
REF PART�# DESCRIPTION REF PART�# DESCRIPTION
101 X1789101 HOUSING 124 X1789124 ANVIL�
102 X1789102 VALVE�SLEEVE 125 X1789125 HAMMER�CAGE
103 X1789103 ANVIL�BUSHING 126 X1789126 HAMMER�PIN
104 X1789104 EXHAUST�DEFLECTOR 127 X1789127 HAMMER�DOG
105 X1789105 TAPPING�SCREW 128 X1789128 DRIVE�CAM
106 X1789106 TRIGGER 129 X1789129 OIL�SEAL
107 X1789107 SPRING�PIN 130 X1789130 BALL�BEARING
108 X1789108 VALVE�STEM 131 X1789131 FRONT�END�PLATE
109 X1789109 BUSHING 132 X1789132 ROTOR�BLADE
110 X1789110 STEEL�BALL 133 X1789133 ROTOR
111 X1789111 COMPRESSION�SPRING 134 X1789134 SPRING�PIN
112 X1789112 HOSE�ADAPTER 135 X1789135 CYLINDER
113 X1789113 COMPRESSION�SPRING 136 X1789136 REAR�END�PLATE
114 X1789114 O-RING 137 X1789137 REAR�GASKET
115 X1789115 AIR�REGULATOR 138 X1789138 REAR�COVER
116 X1789116 SET�SCREW 139 X1789139 SPRING�WASHER
117 X1789117 REVERSE�VALVE 140 X1789140 CAP�SCREW
118 X1789118 PIN 141 X1789141 NAME�PLATE
119 X1789119 SPRING 142 X1789142 RUBBER
120 X1789120 SET�SCREW 143 X1789143 PROTECTING�RUBBER
121 X1789121 SET�SCREW 144 X1789144 STEEL�BALL
122 X1789122 ANVIL�COLLAR 145 X1789145 1/4�NPT�AIR�FITTING
123 X1789123 O-RING






















 

 


 
















W1789 Parts