Signature Hardware LEDA 950612 User manual

1
GETTING STARTED
BEFORE YOU BEGIN
We recommend consulting a professional if you are

Hardware accepts no liability for any damage to the wall,
medicine cabinet, or for personal injury during installa-



any damage is found, contact our Customer Relations

Ensure that you have gathered all the required



This medicine cabinet is heavy; do not lift or install

LEDA




TOOLS AND MATERIALS:
 Level
Drill
Phillips

Hammer Drill Bit
Pencil


2
INSTALLATION

shown, open the cabinet door, and make a mark on the


hole in the wall in the marked position, and place the


check whether the wall is solid, measure the distance
of the mounting holes in the support bar with a tape


and ø8 drill bit, use special ceramic drill if the wall

pilot holes, and then tighten the screws with a screw-


A

LEDA



3
BLUETOOTH INSTRUCTIONS
CABINET DOOR ADJUSTMENT













between the door and the cabinet by adjusting the


make sure that electricity is not on going in to the unit
and connect the three wires reserved on the wall to
the three wire terminal block on the product, and then


performance
A
Reserved power cord
Product power cord
B
c
LEDA

