Signature Hardware NADIYA 457156 User manual

1
GETTING STARTED
BEFORE YOU BEGIN
We recommend consulting a professional if you are
unfamiliar with installing bathroom hardware. Signature
Hardware accepts no liability for any damage to the
vanity, plumbing, countertop, sink, wall, or for personal
injury during installation.
Observe all local plumbing and building codes.
Unpack and inspect the product for shipping damage. If
any damage is found, contact our Customer Relations
team at 1-866-855-2284.
NADIYA
WALL-MOUNT VANITY
SKU: 950070, 950071, 950072, 950073, 950074, 950075, 950076, 950077, 950078
REVISED 04/06/2020
CODES: 531666, 531667, 531668, 531669
531670, 531671, 531672, 531673, 531674
TOOLS AND MATERIALS:
Pencil Level Drill
Tape Measure Phillips
Screwdriver
Ensure that you have gathered all of the required
materials that are needed for the installation.
Because wall construction and materials vary from
home to home, Signature Hardware does not always
provide mounting hardware. The appropriate
mounting hardware can be purchased from your local
hardware store.
The vanity must be fastened to studs behind the
�nished wall. If the studs do not align with the vanity,
proper wood blocking must be installed between the
studs where the vanity will mount.
For Warranty information, please visit: signaturehardware.com/services/warranty
Lag Bolts

2
INSTALLATION
3. Drill pilot holes at marked mounting points. Insert
wall anchors into the mounting holes for reinforce-
ment. Align mounting bracket with pilot holes and
secure with provided hardware.
Note: Installation can vary depending on wall material,
be sure to use the appropriate hardware for your
installation. We recommend consulting a professional
if you are unfamiliar with this type of installation
1. To determine height of included mounting bracket.
Measure to desired height of vanity top, measure 5”
below desired location of vanity and mark measure-
ment.
2. Place top edge of mounting bracket at marked
location. Mark through mounting points on bracket.
Use level to ensure leveled installation of mounting
bracket.
Vanity top line
-5”
Position of mounting bracket
NADIYA
WALL-MOUNT VANITY
SKU: 950070, 950071, 950072, 950073, 950074, 950075, 950076, 950077, 950078

3
4. Rest vanity on mounting bracket. From the under-
side of the vanity mark through the 3 mounting holes
on the back of the vanity.
Note: A skinny pointed tool, such as a screw or
screwdriver can be used to mark mounting points
through the vanity.
Important: If the studs in your bathroom do not line
up to the mounting location for your vanity, wood
blocking can be installed between the studs using
standard 2 x 4’s. If the wood blocking needs to be
installed behind the �nished wall, we recommend
consulting a professional if you are unfamiliar with
this type of installation.
Mounting holes
NADIYA
WALL-MOUNT VANITY
SKU: 950070, 950071, 950072, 950073, 950074, 950075, 950076, 950077, 950078
5. Drill pilot holes at marked location. Once pilot
holes are drilled, install vanity using lag bolts and
washers.