SII 99800088 User manual

6940 O Street, Suite 100, Lincoln, NE 68510
Tools Needed:
• 1/2” wrench or crescent wrench
• 9/16” wrench or crescent wrench
• Ulity knife
• Flat head screwdriver
• Channel lock pliers
Cubetainer Stackable Tanks - Gravity Feed System
Assembly Instrucons P/N 99800088
1. Screw threaded end of each pipe leg into couplers on the under-side of stand base.
2a. Aach drip tray holder to front legs of stand. Leave ample space for your container below the drain
valve.
2b. If the Cubetainer Gravity Feed System is ordered with containment tank #1032500N97801, then the
drip tray kit does not need to be used because the containment has a drip tray shelf pre-built in. In that
case the assembled stand (without drip tray kit) can be placed inside the containment and connue on
to step 4.
NOTE: If you have a 260 gallon Cubetainer it requires containment tank # 1007900N97801 and it does
not have a pre-built in drip tray shelf, so the drip tray kit should be installed on the stand and then
lowered into the containment, then proceed to step 4.

4. Aach elbow kit(s) to front lip of the stand base, using 1/2” wrench. Repeat as necessary.
5. Stack all tanks vercally on stand. Tanks will interlock snugly, resisng any pressure front-to-back, or
side-to-side.
3. NOTE: Handle drip tray screens with care, outside edges are sharp. Snyder recommends wearing gloves
when handling drip tray screens.
Place drip tray insert pans w/ screen into the drip tray holder spaces.

6. NOTE: Openings on drain port and elbow kits are 1” NPT. All threaded ngs must be coated with
sucient pipe thread sealant to prevent leakage. Snyder recommends Tru-Blu Thread Sealant with
Teon for all applicaons.
Install valve directly into boom tank drain port. Install addional valves into elbow kits on stand.
7. Install poly elbow(s) into stacked tank drain port(s). Angle poly elbows at a 5 o’clock posion, aiming to
its corresponding stand elbow kit. Repeat as necessary.
NOTE: Suciently coat all threaded ngs with pipe thread sealant to prevent leakage.
8. Install poly union(s) into stand elbow kit(s). The stand elbow kits are naturally angled at an 11 o’clock
posion. This allows a naturally straight path for the poly tubing to follow, thus prevenng potenal
kink. Repeat as necessary.
NOTE: Suciently coat all threaded ngs with pipe thread sealant to prevent leakage.

6940 O Street, Suite 100 | Lincoln, Nebraska 68510 | 402-467-5221 | FAX: [phone] | www.snydernet.com | [e-mail]
10. Fill each tank. Be sure to double check each ng for leaks. Snyder is not responsible for uid loss or
clean-up costs.
www.snydernet.com
9. Cut to length and aach clear poly tubing to barbed ends of the poly elbow(s) and poly union(s). Snyder
recommends using a hose clamp on each end to secure each connecon.
shown with oponal
containment tank