11GB/IE/NI
To switch off the record player 14 , press the
POWER button 16 again.
Handling records
Only touch record players with clean hands,
and by their edges. Touching the surface of a
record causes the sound quality to deteriorate.
Do not touch the grooves.
To clean records, use a soft anti-static cloth
and a vinyl/shellack record cleaning agent
(available at specialty retailers) to carefully
wipe the surface.
Store records in a dark, cool place and in their
protective sleeves when they are not in use.
Always store records upright.
Do not expose records to direct sunlight; do
not place them near heat sources (radiators,
ovens, etc.), or in places that are affected by
vibrations, too much dust, heat, cold or damp.
Playing records
Remove the head-shell 9by gently pushing if
forwards on the pickup needle 8.
Pick up the record by the edges and place
it carefully over the centre spindle 11 on the
turntable 12 .
If you are playing a single with a large hole in
the centre, place the single adaptor 15 on the
centre spindle 11 first.
Select the desired playback speed using the
speed selector switch 6(the correct setting is
indicated on the record).
Records may have the following speeds:
33 rpm = long-playing record (LP)
45 rpm = singles and 12 maxi singles
78 rpm = for shellac records
Release the tonearm 3from the tonearm rest
7by pushing the safety lever 5gently to
the side.
Raise the tonearm 3by carefully pushing the
cue lever 4back.
Swing the tonearm 3to the song you wish
to listen to . Pull the the cue lever 4slowly
forward to lower the pickup needle 8onto
the record. The record player switches on
automatically as soon as the tonearm 3is
moved from its rest 7towards the left.
As soon as the tonearm 3has reached the
middle of the record and therefore the end of
the recording, it will lift up and position itself on
the rest 7.
The record player then turns off.
NOTE: After use – Always secure the
tonearm 3by allowing the safety lever 5to
lock into place.
Press the POWER button 16 to turn off the
record player 14 .
NOTE: Always ensure that the tonearm 3is
secured before transporting the product.
Operating the product during
playback
Briefly interrupt playback: Push back the cue
lever 4. Playback stops; the record player
continues to operate.
Stop playback: Swing the tonearm 3back on
the rest 7. The record player then turns off.
ATTENTION! Do not turn the record player
off while the pickup needle 8is still resting on
the record. This may damage the record.
Always lift the tonearm 3with the cue
lever 4. Position it on the rest 7before
removing the record.
