Sister Bay Hudson MHUD-B47B User manual

Do not use
any hand drill
on this product
PHILLIPS SCREWDRIVER
( not included )
1- After laying out all components, position the Seat ( B ) upside-down and align the Back Leg Assembly ( C ) with
the Seat Supports, as shown below. Insert a Screw ( A ) through a Seat Support into a predrilled hole and begin to
tighten the screw with a screwdriver. Once the screw is a few turns tightened, move on to another screw until all 6
have been started. Leaving these loose will allow the Bench to adjust in the next procedure.
Figure 1
Hardware and Parts
C
( Back Leg
Assembly )
B
( Seat )
D
( Front Leg
Assembly )
E
( Stretcher )
With the Seat Supports attached to the Back Leg, the Leg Supports can be attached. Insert a Screw ( A1 ) into
the hole on the bottom side of the Leg Support. Tighten them with a screwdriver. Once all 6 screws have been
tightened, go back and finish tightening the screws from Step 1.
Seat
Support
Leg
Support
C
A
A1
(24)
A
1.50
(12)
A1
2.50
( Back Leg
Assembly )
B
( Seat )
B
( Seat )
C
( Back Leg
Assembly )
Item No: MHUD-B47B
Hudson 47" Bar Height Bench
Assembly Instructions

3 - Finalize the assembly of bench by attaching the 3 Stretchers ( E ). Starting at one end, align the Stretcher with the
predrilled holes on the inside of each Leg (at the same height as the foot rest) and, as we did in the previous steps,
insert a Screw ( A ) in through the hole and tighten it a few turns. Repeat this for all four screws, attaching the Front
and Back Legs. Before tightening, attach all 3 Stretchers. With all 3 Stretchers in place, finish tightening all 12
screws.
Figure 3
2 - Repeat Step 1 for the Front Leg Assembly ( D ). First by starting the Screws ( A ) in the Seat Support. Then, driving
the screws ( A1 ) to hold the Leg Support in place. And finally, tightening the screws in the Seat Support.
Figure 2
E
( Stretcher )
Leg
Footrest
A
A
A1
( Front Leg Assembly )
D
CARE AND MAINTENANCE
To clean your product, use mild soap and water. For heavy soil build-ups use any non-abrasive household cleaners
or ask your Sales Representative about Sister Bay Furniture Cleaner.
Please contact our Customer Service Department for assembly assistance, questions or replacement parts at 1-866-947-7632
or email [email protected]. Our Customer Service Department is available Monday - Friday from 8:30 a.m. to 4:30 p.m. EST