Slamtec SDP Mini User manual

1.
2.
3.
4.
SQ103 SLAMWARE SDP Mini Quick Start
On this page, we will introduce how to connect the SDP Mini to our mobile applications and computer. If you are a new comer for SLAMTEC
products, it's fine to start from here.
On this page
Step 1: put batteries in
Step 2: launch SDP Mini
Step 3: control on mobile
application
Step 4: download and use
SLAMWARE SDK
Related pages
Download
Step 1: put batteries in
SDP Mini requires only 8 AA batteries to run well. After receiving the product, please put batteries in the battery holder first. The steps for taking
out the battery holder are as below:
loosen the two thumb screws next to the battery holder anti-clockwise;
remove the protective board;
pull out the battery holder carefully and put batteries in;
push the battery holder and protective board back, and then 󵿎tighten the screws clockwise to fix the battery holder

4.
Step 2: launch SDP Mini
Turn the switch(SW1 interface on the Breakout 3.0 of SDP Mini) on to launch the SDP Mini, then the indicator D1 lights up red and the buzzer
buzzes a few times. The RPLIDAR starts to rotate after 30 seconds which indicates the device launch successfully.
Step 3: control on mobile application
Please scan the following QR code to download the mobile application . After registration and login, open the bluetooth on the phoneRoboHome
and put the phone close to SDP Mini for matching. If matching successfully, you can use the phone connect to the SDP Mini and control it. (The
following screenshots are only for reference. Please refer to the the latest app for details. )
Step 4: download and use SLAMWARE SDK
Please download the latest SLAMWARE SDK from the following link
http://www.slamtec.com/en/Slamware
Check the SSID SLAMWARE-XXXXXX󵿎on the SDP Mini and keep it in mind. Then after launching the SDP Mini successfully,󵿎check the network
adapter on computer to see whether the same wireless SSID SLAMWARE-XXXXXX󵿎appears.

Please connect to the SLAMWARE-XXXXXX via WiFi(you can also connect the SDP Mini to your PC via network cable, in this condition, the
network adapter on the PC should be set as DHCP mode). Then open the tool in the folder of the SDK downloaded above andRobot Studio bin
use the default IP address to connect to the SDP Mini, if successfully. The scanned map will show up 󵿎in the Robot Studio interface.192.168.11.1
Related pages
SM103 SLAMWARE SDP Mini 用户手册;
SR001 SLAMWARE Control Bus 通讯协议;
SA003 基于Slamware解决方案的服务型机器人底盘电机里程计概述及代码示例;
For more help, please contact󵿎 .[email protected]