SMARCYCLE X 2022 User manual
1
3
Display
Brake-lever
4
5Stem
6Stem folding quick-release
7Front light
8Front fork
9Tire
10 Wheel hub
11 Brake disk
12 Brake
13 Front mudguard
14 Battery(Inside)
15 Frame folding release
16
17 Folding pedal
18 Chain wheel
19 Chain
20
21 Frame rear part
22 Rear mudguard
23
24 Seat post quick-release
25 Seat post
26
27 Saddle
Charging port
Motor
Suspension
Rear reflector
Stem quick-release
Instructions Manual Model:X
Green light indicates fully charged
Battery can be charged separately after removal
External charging port
Red light on charger indicates charging
Charging
1: Open the bike stem lock and fold the stem
downwards..
2Release the stem quick-release
to adjust the height of the stem
:
4Release the seat post
quick-release to adjust
the seat post height
:
3:Push button to release fold clamp
Frame folded
A-direction
Battery lock socket:
turn left to release; turn right to lock
5Press the pedal inward and turn upwards to fold:
Press inward
Pedal folded
Folding
A-direction view figure
PLEASE NOTE: Please do not exceed the
maximum height limit when adjusting
the seat post (Height dash line printed
on the rear side of the seat post)
Optional Thumb Throttle Plug-in
location for off-road used only
(intersection of the black cable
bundle), remove the lid on the
socket and then plug in the throttle.
Specifications
820*380*640mm
50km
10.5 AH
3 hours
Digitech Coloured LCD
Hydraulic Disc Brakes
Cruise Thumb throttle –
OFF ROAD USE ONLY
Disclaimer: Statistical data may vary based on environment.
General Installation Notes
1.Pedals are required to install. Please note there are ‘LEFT’ and ‘RIGHT’ labels
on the side of the pedals, put the pedals on the left and right side of the bike cranks
respectively.
2.When installthe seat post, please be aware that there is a maximum height limit
measuring lines printed on the seat post. Do not exceed the maximum height when
adjusting the seat height. Make sure the clamp is in a reasonable tightness to hold
the seat post.
3.Left and Right brake levers are required to tighten up into a fixed position.
4.Recommended tyre pressure is 30 PSI, use hand pump is preferred.
5.Thumb throttle is included in the accessories box, you might wish to connect and
use it ONLY in off-road condition. The connector is located at cable bundle inside
the black strap near the top section of the front bike stem.
6.Please check the battery if it is in unlock position before you pull or remove the
battery out, forcing to pull or remove the battery out in locked position might break
the battery handlebar.
7.The black rubber pads on the battery case are to reduce the movement and act
as an shock absorber in the battery chamber. If you cannot fold the bike smoothly,
it might be due to the battery location is not correct inside the battery chamber
(Either too up or too down). Try to relocate the black rubber until you can fold the
bike seamlessly.
8.After riding, please place the bike where is free from sunlight and rain.
9. Please do not ride the bike in extreme weather or heavy rain condition.
If you have any further questions, please visit our website and feel free contact us.
www.smarcycle.com.au
CAUTION
Y
X
Y
Y
Y
SMAR CYCLE
Table of contents
Other SMARCYCLE Bicycle manuals
