SMARDY HWF 200 User manual

1
Pre Filtre
Instruction manual EN
Contents
1. Unpacking
2. Scope of supply
3. Insertion of the filter
4. Installation
5. Commissioning
6. Technical Data

1. Unpacking
Remove all packaging material. Make sure that the filtration system does not show
any external damage.
2. Scope
of supply
1. smardy HWF 100
2. PP 5 Micron Filter
3. Key for filter housing
3.
Insertion of the filter
1. The housing is unscrewed clockwisewith the key .
2. Remove packaging film of the filter
3. Now insert the filter into the housing.
4. Screw down the housing counterclockwise. Attention! When closing, the housing
seal must not cant

4. Installation
•Caution! Please check the flow direction before installation
5.
First commissioning
•Before you open the water supply, check again that the filter housing is screwed.
•The unit have to be checked for possible leaks. If required, the connectionscan be
retightened.
• Never override safety devices.
• You are responsible for security in the workspace.
• The filter must be necessarily emptied before frost damage, to prevent damage
of system.
6.
Technical data
•Nominal pressure (max.) 10 bar
•Working pressure (max.) 5 bar (0.5 Mpa)
•Water temperature 55 °C
•Water flow 850 l/h
•Connections Input: 1" internal thread and Output : 1" internal thread .
Facilities:
Vent (1)
brass internal thread (2)
Filter housing (3)

smardy©
Robert-Bosch-Str. 6b
86830 Schwabmünchen
Germany
[e-mail]
Link for accessories:
https://www.amazon.co.uk/dp/B07FF3GYPS