SmartLock PREMIER - 2 USERS User manual

PREMIER - 2 USERS TECHNICAL MANUAL
General information
Manager factory code 1-2-3-4-5-6.
A valid entry is followed by a double signal.
An invalid entry is followed by a long signal.
After 5 seconds without entry, current operation will be cancelled.
Penalty
After entry of 4 consecutive invalid codes the lock will be blocked for 5 minutes (penalty).
During penalty the LED flashes every 10 seconds.
During penalty any key pressed causes a long signal.
After penalty, entry of 2 more invalid codes restarts the 5 minutes blocking period.
Low battery signal
A series of signals indicates that the battery is weak and must be replaced.
Only use brand new 9V ALKALINE batteries.
Open the lock
•Enter the code (double signal).
•If time delay has not been set open the lock within 4 seconds.
•If time delay has been set wait for time delay counting: LED flashes every 2 seconds.
•A signal every 2 seconds indicates time delay counting is over and open window started.
•Enter the code (double signal) and open the lock within 4 seconds.
Change code (only change the code with safe door open).
•Press and hold 0 until double signal.
•Enter current user code (double signal).
•Enter new code (double signal) and repeat new code to confirm (double signal).
•Code has been changed: try new code with door open.
In case of any error (long signal) the old code remains valid.
Safety reference:
All codes are to be securely stored.
Do not use personal data (i.e. birthdays, phone numbers, etc.).
Change factory code before you start using the safe.
Install the user
•Press and hold 1 until double signal.
•Enter Manager code (double signal).
•Enter new user code (double signal) and repeat new code to confirm (double signal).
•User code has been installed: try new code with door open.
In case of any error (long signal) user code has not been installed.
Delete the user
•Press and hold 3 until double signal.
•Enter Manager code (double signal).
•User code has been deleted.

of 1 2

Self diagnostic
•Press and hold 5 until double signal.
•Press each key consecutively 1-2-3-4-5-6-7-8-9-0
•Double signal: key properly working.
•Long signal: damaged key.
If no acoustig signal is emitted after pressing and holding 5, the lock is not properly connected to the
keypad or the cable is damaged.
Time delay
•Press and hold 9 until double signal.
•Enter Manager code (double signal).
•Enter time delay and open window values.
•Example: 0205 to set 2 minutes time delay and 5 minutes open window.
•Confirm time delay and open window values.
•Example: 0205 to set 2 minutes time delay and 5 minutes open window.
Important notes:
Time delay accepted values: 00-99min.
Open window accepted values: 01-19min.
Time delay can be increased at any moment, can be decreased only during open window.
To delete time delay set 0001 and confirm 0001.

of 2 2