Snugpak JOURNEY SOLO User manual

JOURNEY SOLO
ONE PERSON TENT
Assembly Instructions
Lay the footprint down before erecting
the tent.
First unroll the shelter and locate
the pole bag and separate the poles,
clip the sections together to make a
continuous pole, the poles are held
together by elastic to help.
Pole Placement
1. Insert the Orange Tipped Pole with
Orange section to Orange trim edging.
2. Insert the Siver Tip Pole into Pole
Channel Sleeve 2.
3.Insert the tent pole ends into
the grommets in the corresponding
webbing straps.
4. Once all the pole ends are inserted
into the grommets then take the
Ultralight Alloy Stakes that came
with the Journey Solo and stake
down the corners through the
webbing straps and elasticated
loops. Add additional stakes to
other stake points as needed.
5. At this stage the Journey Solo can
be used as a stand alone insect
shelter, if so desired.
x1 Small curved
Silver Tip
x1Large curved
Orange Tip x19 Alloy Stakes
1
2
3
4

Assembly Instructions
Snugpak®products are exclusively
distributed in North & South America by:
Proforce Equipment, Inc.
3230 Executive Way - Miramar, FL 33025
Ph: 305.436.7984 / 800.259.5962
www.ProforceEquipment.com
Snugpak LTD
Waterloo Mills, Howden Road
Silsden, West Yorkshire
BD20 0HA, England
Tel: [phone] Fax: [phone]
www.SNUGPAKUSA.com
www.SNUGPAK.com
6.Take out the Fly (Outer Tent)and unfold and spread
it out. Then drape the Fly over the main body
matching up the door area and foot area and then
connect the two.
7. Once the Inner Tent is connected with the Fly by
all the velcro loops, then click all the side
release buckles together
8. To gain access now simply unzip the fly access
zipper and also the inner tent access zippers.
9. Once you are happy with set up of the tent you can
further stabilise the tent by pegging out the guy
lines, these are essential in windy conditions.
JOURNEY SOLO
ONE PERSON TENT
THIS TENT MEETS THE FLAMMABILITY REQUIREMENTS OF ISO6941 / (EN5912).
6
7
8
7