Snugpak JOURNEY SOLO User manual

JOURNEY SOLO
ONE PERSON TENT
Assembly Instructions
Lay out the footprint before erecting
the tent.
Unroll the tent, locate the pole bag,
separate the poles, clip the sections
together making continuous poles. The
poles are held together by elastic.
Pole Placement
1. Insert the orange tipped pole with
orange section to orange trim edging.
2. Insert the silver tipped pole into
pole channel sleeve 2.
3.Insert the pole ends into the
grommets in the corresponding
webbing straps.
4. When all the pole ends are
inserted into the grommets take the
ultralight alloy stakes included
with the Journey Solo, stake down
the corners through the webbing
straps and elasticated loops. Add
additional stakes to other stake
points as required.
5. At this stage the Journey Solo can
be used as a stand-alone insect
shelter.
1Curved Silver
Tipped Pole
1Curved Orange
Tipped Pole 19 Alloy Stakes
1
2
3
43

Assembly Instructions
Snugpak®products are exclusively
distributed in North & South America by:
Proforce Equipment, Inc.
3230 Executive Way - Miramar, FL 33025
Ph: 305.436.7984 / 800.259.5962
www.ProforceEquipment.com
Snugpak
Waterloo Mills, Howden Road
Silsden, West Yorkshire
BD20 0HA, England
Tel: [phone] Fax: [phone]
www.SNUGPAKUSA.com
www.SNUGPAK.com
6.Take out the fly (Outer Tent)unfold and lay out.
Drape the fly over the main body matching up the
door and foot area, connect the two with the velcro
loops.
7. When the inner tent is connected with the fly click
all the side release buckles together.
8. To gain access unzip the fly and inner tent zips.
9. When happy with the set-up, further stabilisation
is achieved by pegging out the guy lines. This is
essential in windy conditions.
JOURNEY SOLO
ONE PERSON TENT
THIS TENT MEETS THE FLAMMABILITY REQUIREMENTS OF ISO6941 / (EN5912).
7
8
7
Ltd
6