Snugpak JOURNEY QUAD User manual

JOURNEY QUAD
FOUR PERSON TENT
Assembly Instructions
x1 Large Orange
Tip
x2Silver Tip
x20 Alloy Stakes
Lay the footprint down before
erecting the tent.
First unroll the outer shelter
and locate the pole bag and
separate the poles, clip the
sections together to make a
continuous pole, the poles are
held together by elastic to help.
Pole Placement
1. Insert the Silver Tip Pole
with Silver section to
Silver trim edging.
2.Insert the other Silver Tip
Pole with Silver section to
Silver trim edging.
3.Insert the Large Orange Tip
Pole with Silver section to
Silver trim edging.
2
3
1
4.Insert the tent pole ends
into the grommets in the
corresponding webbing
straps.
5. Once all the pole ends are
inserted into the grommets
then take the Ultralight
Alloy Stakes that came
with the Journey Quad and
stake down the corners and
the webbing straps with
grommets. Add additional
stakes to other stake
points as needed.
45

Assembly Instructions
Snugpak®products are exclusively
distributed in North & South America by:
Proforce Equipment, Inc.
3230 Executive Way - Miramar, FL 33025
Ph: 305.436.7984 / 800.259.5962
www.ProforceEquipment.com
Snugpak LTD
Waterloo Mills, Howden Road
Silsden, West Yorkshire
BD20 0HA, England
Tel: [phone] Fax: [phone]
www.SNUGPAKUSA.com
www.SNUGPAK.com
6.Take out the Inner Tent and unfold and spread it
out. Then line up the Fly to the main body matching
up the door area and foot area and then connect the
two with the toggle and ring attachments.
7. Once the Inner Tent is connected with the Fly by
all the Toggle and Ring attachments (Red to the
front and Yellow to the back), then click all the
side release buckles together
8. To gain access now simply unzip the fly access
zipper and also the inner tent access zippers.
9. Once you are happy with set up of the tent you can
further stabilise the tent by pegging out the guy
lines, these are essential in windy conditions.
THIS TENT MEETS THE FLAMMABILITY REQUIREMENTS OF ISO6941 / (EN5912).
6
7
JOURNEY QUAD
FOUR PERSON TENT
7