SNUGSQUARE HANNA TABLE User manual

HANNA TABLE

Shelf
Table Top
Legs + Dowels
Note: Please retain all boxes until you are certain that your product isn’t damaged and that you
do not wish to return it. Disposal of boxes may prevent/delay our ability to resolve your request.
3x Bolts Hex Key
Hammer required
(not included)
Gather Your Eggs...

Step 1: Insert Dowels Into Table Top
Insert wood dowels into table
top holes. Tap gently with a
hammer, just enough to where
you feel the dowel bottom out.
Repeat for all dowel holes.
Place table top face down on a
soft material to avoid scratching.

Step 2: Attach Legs to Bottom Shelf
Place one of the legs on it’s side with the
notch facing up.
Take your bottom shelf. With pockets
facing towards the tapered end of the leg,
insert the shelf notch into the leg notch.
Then insert a screw in the pocket
and using the rounded end of the
hex key, loosely tighten to leg.
Repeat for all legs.

Step 3: Attach Table Top
Next, attach the legs to the table top.
Align the holes on the legs with the
dowels on the table top.
Press down on legs evenly, making sure
not to seperate legs from bottom shelf.
If needed, flip your table over and press
the table top down to fully engage the
wood dowels.
Flip your table back over to finish
tightening bolts.
Fully tighten bolts on all
legs with the hex-key.
Flip over your table and ta-dah!
Frank Lloyd Wright is in the house.
DONE!