SNUGSQUARE EDGAR LOUNGE CHAIR User manual

EDGAR LOUNGE CHAIR

Gather Your Eggs...
More Eggs...
2x Legs
8x Long Bolts 6x Short Bolts
Back Panel
Seat Panel
Back Cushion
Seat CushionSupport Shelf
Note: Please retain all boxes until you are certain that your product isn’t damaged and that you
do not wish to return it. Disposal of boxes may prevent/delay our ability to resolve your request.
Drill + Extension
Hex Bit with Ball End

Step 1: Attach the Seat Panel
Step 2: Attach the Back Panel
Place your first leg down
with the holes facing up.
Align the corresponding
holes in the seat panel with
those on the leg.
Use a short bolt in the front
hole, and long bolts for the
other 2 holes. Tighten each
one by hand.
Align the corresponding
holes in the back panel with
those on the upper portion
of the leg.
Use 2 short bolts and tighten
each by hand.

Step 3: Attach the Support Shelf
Align the support shelf with the
corresponding holes on the
leg. Ensure that the shallow
pockets are facing towards
the bottom of the leg.
Use 2 long bolts. Tighten each
by hand.

Step 4: Attach Other Leg
Step 5: Add bolts to Support Shelf
Attach the second leg by
aligning the holes on the
seat and back panels with
the corresponding holes
on the leg.
Insert bolts as in previous
steps.
Repeat step 3 for the other
side of the support slat.
Use the provided drill to go
back and tighten all bolts.

DONE
Step 6: Attach the Cushions
Move your chair onto
its feet.
Attach the back and seat
cushions to their panels.
Velcro pads will hold the
cushions in place.