SNUGSQUARE JORN CONSOLE User manual

JORN CONSOLE

Gather Your Eggs...
13x Bolts2x Mounting Screws
2x Drywall Anchors
Left Leg
Back
Shelves (Large or Small)
Top
Right Leg
Mounting Template
Note: Please retain all boxes until you are certain that your product isn’t damaged and that you
do not wish to return it. Disposal of boxes may prevent/delay our ability to resolve your request.
Drill + Extension
Hex Bit with Ball End

Step 1: Attach Bottom Shelf to Back Panel
Step 2: Attach Top Shelves to Back Panel
Place Bottom Shelf pocket
side down.
Take back panel with
mounting hole facing out.
Align bottom holes and
screw in bottom 3 bolts.
Grab your shelves (Large or
small depending on your
custom order).
Align holes on the shelf with
the holes on the back panel,
attach with 2 bolts.
Repeat on other side.

Step 3: Attach First Leg
Step 4: Attach Second Leg
Rotate unit onto back.
Grab the Right Leg and align the holes on
the interior of the leg with the pocket holes
on the shelf and top. Insert bolts into each
hole and tighten.
Repeat Step 3
for the other leg.
Upper Shelf Table Top

Step 5A: Wall Mount Prep: Measure
With your console out of the
way, use a tape measure
and make a mark 33” from
the floor on the center of
your console location
Using your measured mark as a reference, tape the provided template to the wall. Total template width
is 36 inches. Make sure that each bottom corner is also 33 inches from the floor. Adjust if needed.
First decide where would
like to place your Console
and locate your center.
Next you want to secure your console to wall. It is not advised
to use this product without safely anchoring to the wall.
33 Inches
36 Inches
(Template - Not to Scale)
Floor

Using a 1/4” Drill bit, drill a hole
on the 2 crosshairs and gently
remove our template
Using a hammer, gently insert the
drywall anchor into your drilled hole,
making sure the shoulder of the
anchor is flush with the wall surface.
Step 5B: Wall Mount Prep: Drill
Step 5C: Wall Mount Prep:Hammer
Drill
Step 5D: Wall Mount Prep:
Use the provided screws. Screw into the
anchors taking care not to overdrill and
strip the anchor.

Step 6: Mount to the Wall
Wall Rear of Unit Keyhole Opening Side view
With the back of your console facing the wall, Lift the unit slightly and place the head
of the drywall screws into the bottom opening of the keyholes on the back. Press the
console against the wall and slide it down onto the screw until the feet touch the floor.
DONE!
Your unit is now securely attached
to the wall and ready to use.