Soleus Air MS-10R User manual

© 2007 Soleus Air International
MS-10R Reflective Heater w/ Remote
Operating Instructions
Model No. MS-10R
3033119

2
Thank you for choosing a Soleus Air personal heater. This owner’s manual will provi e you with
valuable information necessary for the proper care an maintenance of your new pro uct. Please take
a few moments to thoroughly rea the instructions an familiarize yourself with all the operational
aspects of your new Soleus Air personal heater.
For your own recor s, please attach a copy of your sales receipt to this manual. Also, write the store
name/location, ate purchase , an serial number below:
Store Name: ____________________________________________________
Location: ______________________________________________________
Date Purchase : _________________________________________________
Serial Number (locate on back of unit): ______________________________
IMPORTANT INSTRUCTIONS
Before using your Soleus Air personal heater, please read this owner’s manual carefully. Store this manual in a
safe place for future reference.
1. Rea ALL instructions before using this unit.
2. CAUTION: Risk of Electric Shock. DO NOT open or try to repair the heater yourself.
3. This heater is hot when in use. To avoi burns, DO NOT let bare skin touch hot surfaces. If provi e ,
use han les when moving this heater.
4. Keep combustible materials, such as furniture, pillows, be ing, paper, clothes, an curtains at least 3
ft from the front of the heater an keep them away from the si es an rear. DO NOT place towels or
other objects on the heater.
5. Extreme caution is necessary when any heater is use by or near chil ren or the isable , or when the
heater is left operating an unatten e .
6. DO NOT operate any heater with a amage cor or after the heater malfunctions, has been roppe
or amage in any manner. Return heater to authorize service facility for examination, electrical or
mechanical a justment, or repair.
7. This heater is not inten e for use in bathrooms, laun ry areas an similar in oor locations. NEVER
locate heater where it may fall into a bathtub or other water container. To protect against electrical
hazar s, DO NOT immerse in water or other liqui s.
8. DO NOT touch the control panel or plug with a wet han .
9. DO NOT run cor un er carpeting. DO NOT cover cor with throw rugs, runners, or similar cover-
ings. Arrange cor away from traffic area an where it will not be trippe over.
10. DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause
an electric shock or fire, or amage the heater.
11. To prevent a possible fire, DO NOT block air intakes or exhaust in any manner. DO NOT use on soft
surfaces, like a be , where openings may become blocke .

3
PRODUCT INFORMATION & SPECIFICATIONS
Reflective heating technology replicates the sun’s healthy rays, irectly warming the object or person in front
of the heater. As the temperature of the heate surface rises, the warming effect is felt throughout the air an
surroun ing areas. Reflective heaters are great for open or large rooms, an actually save you energy by warm-
ing objects an not the entire room.
Reflective heating is both safe an healthy– it pro uces no o ors, chemicals, or fumes, an oesn’t stir up ust.
As a safety feature, the heater’s exterior oes not get as warm to re uce the risk of burns from anyone or any-
thing touching the heater while in use. Remarkably efficient, our heater uses less power to create the same
amount of heat as tra itional heaters. Equippe with safety tip-over switch an overheat auto-off, our heater is
safe an reliable.
DISCLAIMER
ALL INFORMATION AND THE TECHNICAL SPECIFICATIONS PRESENTED IN THIS USER’S MANUAL ARE THE
PRESENTATION OF THE MANUFACTURER. SOLEUS INTERNATIONAL HAS NOT CONDUCTED INDEPENDENT
TEST TO THE INFORMATION AND THE SPECIFICATIONS PRESENTED HEREWITHIN.
12. A heater has hot an arcing or sparking parts insi e. DO NOT use in areas where gasoline, paint, explosive an /or
flammble liqui s are use or store . Keep unit away from heate surfaces an open flames.
13. Avoi the use of an extension cor because the extension cor may overheat an cause a risk of fire.
However, if you have to use an extension cor , the cor shall be No16.AWG minimum size an rate
not less than 1500W.
14. To avoi fire or shock hazar , plug the unit irectly into a 120 V AC electrical outlet.
15. To isconnect heater, turn controls to OFF, then remove plug from outlet. Pull firmly on the plug, DO
NOT unplug by pulling on the cor .
16. Always unplug the unit before moving or cleaning, or whenever the heater is not in use.
17. Use only for inten e househol use as escribe in this manual. Any other use not recommen e by
the manufacturer may cause fire, electric shock, or injury to persons. The use of attachments not rec-
ommen e or sol by unauthorize ealers may cause hazar s.
18. Always use on a ry, level surface.
19. DO NOT use out oors.
20. WARNING: To re uce the risk of fire or electric shock, DO NOT use this unit with any soli -state
spee control evice.
21. DO NOT attempt to repair or a just any electrical or mechanical functions on this unit. Doing so will
voi your warranty. The insi e of the unit contains no user serviceable parts. Qualifie personnel
shoul perform all servicing only.
22. Connect to properly groun e outlets only.
23. SAVE THESE INSTRUCTIONS.
Voltage Rating 120 V (60Hz)
Power Consumption 800W on High, 400W on Low
Unit Size 14.5 in. (W) x 13.5 in. (D) x 34 in. (H)
Unit Weight 6.5 lbs

4
PRODUCT DIAGRAM
Tip-Ove Safety Switch
This heater is equippe with a tip-over safety switch locate un erneath the base of the heater. This switch
must be presse inwar for the heater to function properly. Some soft surfaces such as carpet may not be able
to fully press in this switch. For some soft surfaces, a har flat object will nee to be place un erneath the
heater for it to function properly. PLEASE DO NOT TAPE OR GLUE THIS SWITCH.
SAFETY FEATURES
SAFETY SWITCH
BOTTOM OF THE
HEATER
WARNING: This heater is for use on 120 volts. The
cor has a plug as shown in A. An a apter as shown in
C is available for connecting three-bla e groun ing-
type plugs to two-slot receptacles. The groun ing lug
exten ing from the a apter must be connecte to a
permanent groun such as a properly groun e outlet
box. The a apter shoul not be use if a three-slot
groun e receptacle is available.
DO NOT DEFEAT THE SAFETY PURPOSE OF
THE GROUNDED PLUG.

5
ASSEMBLY
Remove the heater body and base from the
box. Remove the packaging materials and
keep for future storage.
Slide the neck of the heater head into the
column connected by the cord so that the
holes in the neck align with the holes in the col-
umn.
Insert and tighten the screws with a Philips
screwdriver.
Slide the cord through the opening in the back
of the base.
Insert the lip near the control panel into the
opening in the front of the base. Push the body
and base together. The tip-over safety switch
should protrude out the bottom of the base.
Attach the base to the heater body by screwing
on the fastening screw.

6
OPERATING INSTRUCTIONS
CONTROL PANEL OPERATION
Place the heater on a firm, level surface an plug into a groun e 120V 60Hz power outlet.
Press the POWER button to turn on the heater.
Press the EAT button to choose the esire heat setting.
• LOW: heating up to 400W
• IG : heating up to 800W
TIMER: The heater is equippe with a 0.5 to 7.5 hour timer. To select the esire length of operation, press
the TIMER button repeate ly. A up the lit in icator lights for the total number of hours. The heater will
automatically shut off after the set time has elapse .
• 0.5H: 30 minutes
• 1H: 1 hour
• 2H: 2 hours
• 3H: 3 hours
• 4H: 4 hours
Swing: Press the SWING button an the heater hea will oscillate 90º
from right to left. The in icator light will turn on. Press the SWING button
again to stop oscillation. The in icator light will turn off.
CONTROL PANEL

7
OPERATING INSTRUCTIONS
REMOTE CONTROL OPERATION
The remote control can be use to perform all the operations that can be
performe from the control panel.
HEIGHT ADJUSTMENT: Press in the height a justment button an simultaneously pull the sli ing
column up to the esire height. Release the height a justment button to set. To re uce the height, press
in the height a justment button an simultaneously push the sli ing column own. Release the button to
set.
HEATER HEAD ADJUSTMENT: Grasp the reflection hoo an gently tilt forwar or backwar s. The
unit will click into the ifferent positions. (Notice: When a justing the heater hea , the heater must be
turne off to ensure safety.)
NOTE: A tip-over safety protection switch is installe at the bottom of the heater. When the heater is
place horizontally, lai own or lifte up, it stops operating to ensure safety. After placing the heater
upright it will resume operation.
NOTE: For safety, if the heater’s internal temperature rises above a certain point, the heater is esigne
to automatically shut off. To restart the heater in this situation:
1. Push the power button to OFF.
2. Unplug the power cor from the outlet an allow the heater to cool for at least 10 minutes.
3. Plug the power cor back into the outlet. Use the control panel to select the esire settings.
WARNING: It is normal for the power cor to feel warm to the touch;
however, a loose fit between the outlet an the plug may cause overheating
of the plug. If this occurs, try inserting the plug into a ifferent outlet. Con-
tact a qualifie electrician to inspect the original outlet for amage.
REMOTE CONTROL

8
MAINTENANCE
1. Unplug the unit an let it cool completely.
2. To keep the heater clean, the outer shell may be cleane with a soft, amp cloth. You may use a mil
etergent if necessary. After cleaning, ry the unit with a soft cloth. CAUTION: DO NOT let liqui
enter the heater.
3. DO NOT use alcohol, gasoline, abrasive pow ers, furniture polish, or rough brushes to clean the
heater. This may cause amage or eterioration to the surface of the heater.
4. DO NOT immerse the heater in water.
5. Wait until the unit is completely ry before use.
STORAGE
Store the heater in a cool, ry location when not in use. Preferably, to prevent ust an irt buil -up, use the
ol packaging to repack the unit.
TROUBLESHOOTING
If the heater will not operate, please check the following before seeking repair of service:
1. Check if the power cor is plugge into an electrical outlet, if not, plug in.
2. Check if electricity to the main fuse is working.
3. Check if the heater is set to ON by confirming the light on the control panel is lit. If not, press the
POWER button to turn on the unit.
4. Check if the heater is on a level surface. If the tip-over safety switch is not pushe in, the heater will
not run.

9
WARRANTY
One Year Limited Warranty
Soleus International Inc. warrants the accompanying Soleus Air heater to be free of efects in material an workman-
ship for the applications specifie in its operation instruction for a perio of ONE (1) year from the ate of original re-
tail purchase in the Unite States.
If the unit exhibits a efect in normal use, Soleus International Inc. will, at its option, either repair or replace it, free of
charge within a reasonable time after the unit is returne uring the warranty perio .
As a con ition to any warranty service obligation, the consumer must present this Warranty Certificate along with a
copy of the original purchase invoice.
T IS WARRANTY DOES NOT COVER:
• Damage, acci ental or otherwise, to the unit while in the possession of a consumer not cause by a efect in
material or workmanship.
• Damage cause by consumer misuse, tampering, or failure to follow the care an special han ling provisions
in the instructions.
• Damage to the finish of the case, or other appearance parts cause by wear.
• Damage cause by repairs or alterations of the unit by anyone other than those authorize by Soleus Interna-
tional Inc.
• Freight an Insurance cost for the warranty service.
ALL WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANT ABILITY ARE LIMITED TO
ONE-YEAR DURATION OF THIS EXPRESS LIMITED WARRANTY. SOLEUS INTERNATIONAL INC.
DISCLAIMS ANY LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES AND IN NO EVENT
SHALL SOLEUS INTERNATIONAL INC’S LIABILITY EXCEED THE RETAIL VALUE OF THE UNIT FOR
BREACH OF ANY WRITTEN OR IMPLIED WARRANTY WITH RESPECT TO THIS UNIT.
This warranty covers only new pro ucts purchase from our authorize ealers or retailers. It oes not cover use , sal-
vage , or refurbishe pro ucts.
As some states o not allow the limitation or exclusion of inci ental or consequential amages, or o not allow
limitation on implie warranties, the above limitations an exclusions may not apply to you. This warranty gives you
specific legal rights, an you may also have other rights that vary from state to state.
For Technical Support and Warranty Service
Please Call [phone]
Or Write To:
Soleus International Inc.
9451 Telstar Ave.
El Monte, CA 91731 USA
www.soleusair.com