Solos SD-KStand001-WH User manual

6
Press the decorative cover (6) into the hole of the lower shelf set(2)
STEP2
x4
E
4x4
2
A
E
3
5x5
F
A
x4
B
F
1
4
B
STEP1 Install the supporting metal plate, shelf panel and Supporting cover
Connect the supporting metal plate(3) to the shelf panel(2)
with screw(A), and tighten it with 4*4 allen key(E)
Place the shelf panel (1) on the supporting sheet
metal(3) from top to bottom, and then buckle into
the supporting cover(4), using screw(B) to tighten it
with 5*5 wrench (F)
Install the decorative cover Press into
1.Shelf Set X1 2.Lower Shelf Set X1 3.Supporting
metal plate X2
4.Supporting coverX2
Anti-tip set X1
5.Upper Shelf
Panel X1
6.Decorative
Cover X2
7.Plastic Block X4
A(M5x10mm)
4pcs
B(ST4.2x16mm)
4pcs
C(M4x8mm )
4pcs
D(3x3)
1pc
E (4x4)
1pc
8.Cushion X2 9.Briquetting X2
F(5x5)
1pc
Max:10KG
SOLOS Kids Standing Desk Shelf
Installation Guide
SD-KStand001-WH

9
8
STEP4 Install the Briquetting and Cushion
STEP5 Shelf panel final assembly
Shelf panel final assembly
Applicable tabletop thickness:
15-30mm
Adjust the knob according to the thickness
of the tabletop, then tighten it
STEP6 Connect the anti-tip strap to the shelf panel
Anti-tip strap

7
2
C
F
Cx4
D
5x5
F
5x5
7
2
5
7
7
C
F
7
5
1
2
3
STEP3 Install the plastic block and upper shelf panel
Fix the plastic block(7) on the shelf (2) with screws (C),
and tighten it with a 5x5 wrench (F)
Place the plastic block
slot face up
Insert
Buckle into
Buckle the plastic block (7) into the upper frame (5) and fix it
with screws (C), then to tighten it with a 5x5 wrench (F)
Insert the upper frame (5) into the groove of the
plastic block (7)

37mm
3/10”(8mm)
7Connect the anti-tip strap to the wall
Expansion pipe Nail
Reading rack instruction
reading.
D
STEP
According to the actual use, the reading rack
can be rotated to facilitate comfortable reading.
Open the reading rack to the maximum,
and rotate the reading rack according
to the actual use to facilitate comfortable
Load capacity: 0.5kg
After placing the book, pay attention
to adjusting the screws to avoid
unnecessary injury due to loose
reading rack. 3*3 wrench
Caution