4-467-661-02(1)
HD Digital Triax CCU Adaptor
HD Digital Triax Camera Adaptor
Operation Guide
HDFX200
HDTX200
© 2013 Sony Corporation Printed in Japan
WARNING
To reduce the risk of fire or electric shock, do not
expose this apparatus to rain or moisture.
To avoid electrical shock, do not open the cabinet.
Refer servicing to qualified personnel only.
Caution
Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
Caution
The use of optical instruments with this product will increase eye hazard.
For the customers in the U.S.A.
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the
interference at his own expense.
You are cautioned that any changes or modifications not expressly approved in
this manual could void your authority to operate this equipment.
All interface cables used to connect peripherals must be shielded in order to
comply with the limits for a digital device pursuant to Subpart B of part 15 of FCC
Rules.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
For the customers in Canada
CAN ICES-3 (A)/NMB-3(A)
HDFX200
WARNING
THIS APPARATUS MUST BE EARTHED.
This symbol is intended to alert the user to the presence of
important operating and maintenance (servicing)
instructions in the literature accompanying the appliance.
WARNING: THIS WARNING IS APPLICABLE FOR USA ONLY.
If used in USA, use the UL LISTED power cord specified below.
DO NOT USE ANY OTHER POWER CORD.
Plug Cap Parallel blade with ground pin (NEMA 5-15P Configuration)
Cord Type SJT, three 16 or 18 AWG wires
Length Minimum 1.5 m (4 ft 11 in), Less than 2.5 m (8 ft 3 in)
Rating Minimum 10A, 125V
Using this unit at a voltage other than 120V may require the use of a different
line cord or attachment plug, or both. To reduce the risk of fire or electric
shock, refer servicing to qualified service personnel.
WARNING: THIS WARNING IS APPLICABLE FOR OTHER COUNTRIES.
1. Use the approved Power Cord (3-core mains lead) / Appliance Connector
/ Plug with earthing-contacts that conforms to the safety regulations of
each country if applicable.
2. Use the Power Cord (3-core mains lead) / Appliance Connector / Plug
conforming to the proper ratings (Voltage, Ampere).
If you have questions on the use of the above Power Cord / Appliance
Connector / Plug, please consult a qualified service personnel.
For kundene i Norge
Dette utstyret kan kobles til et IT-strømfordelingssystem.
This HD Digital Triax CCU Adaptor is classified as a CLASS 1 LASER PRODUCT.
IEC60825-1(2007) & IEC60825-1(2014)
Tämä HD Digital Triax CCU -adapteri on luokiteltu 1. LUOKAN
LASERTUOTTEEKSI.
IEC60825-1(2007) & IEC60825-1(2014)
Den här digitala HD-Triax-CCU-adapter klassificeras som en LASERPRODUKT
AV KLASS 1.
IEC60825-1(2007) & IEC60825-1(2014)
For the customers in Europe
This product is intended for use in the following Electromagnetic
Environment: E4 (controlled EMC environment, ex. TV studio).
For the customers in Europe, Australia and New Zealand
WARNING
This equipment is compliant with Class A of CISPR 32. In a residential
environment this equipment may cause radio interference.
This apparatus shall not be used in the residential area.
HDTX200
This HD Digital Triax Camera Adaptor is classified as a CLASS 1 LASER
PRODUCT.
IEC60825-1(2007) & IEC60825-1(2014)
Tämä HD Digital Triax kamera-adapteri on luokiteltu 1. LUOKAN
LASERTUOTTEEKSI.
IEC60825-1(2007) & IEC60825-1(2014)
Den här digitala HD-Triax-kameraadaptern klassificeras som en
LASERPRODUKT AV KLASS 1.
IEC60825-1(2007) & IEC60825-1(2014)
For the customers in Europe
This product is intended for use in the following Electromagnetic
Environments: E1 (residential), E2 (commercial and light industrial), E3 (urban
outdoors), E4 (controlled EMC environment, ex. TV studio).
Overview
The HD Digital Triax CCU Adaptor HDFX200 and HD Triax Camera Adaptor
HDTX200 are designed for connecting a camera to a camera control unit and
converting the link format between them from optical fiber to Triax.
The HDFX200 can be connected by optical fiber and Triax, and switched
remotely between them for the useful function of Outdoor Broadcasting.
The HDTX200 links the optical fiber connector of the HD camera to the Triax
connector of the HD Digital Triax CCU Adaptor HDFX200, providing the required
conversion.
Using the CD-ROM manual
The manual can be read on a computer with Adobe Reader installed.
You can download Adobe Reader free from the Adobe website.
1 Open the index.html file in the CD-ROM.
2 Select and click on the manual that you want to read.
Note
If you have lost or damaged the CD-ROM, you can purchase a new one from your
Sony dealer or Sony service counter.
