Sound Sation LEDBM-300 User manual

Product Instruction
LEDBM-300
LED Bubble Machine

PLEASE READ OVER THIS MANUAL BEFORE OPERATION THE
MACHINE
Introduction
Thank you for choosing this LED Bubble Machine. You now own a
rugged and powerful state-of-the-art machine. Prior to use, we suggest
that you carefully read all of the instructions. By following the
suggestions found in this user manual, you can look forward to
exceptional performance from your Bubble Machine for years to come.
Please follow these operation, safety and maintenance instructions to
ensure along and safe life for your Bubble Machine.
Specifications
Remote Control and DMX 512
Voltage: AC110V 220-250V, 50/60Hz
Light source: 20 pieces 3W RGB (three in one) high brightness
Unpacking & Inspection
Open the shipping carton and check that all equipment
necessary to operate the system has arrived intact. In addition to
the Bubble Machine, you should receive the following items:
1. This user manual.
2. Power cord and plug.
Before beginning initial setup of your Bubble Machine, make
sure that there is no evident damage caused by transportation.
In the event that the unit’s housing or cable is damaged, do not

plug it in and do not attempt to use it until after contacting your
dealer for assistance.
Set up
1. Remove all packing materials from the bubble machine.
2. Place bubble machine on a flat surface.
3. Loosen the side screws and lift the housing upwards. You will
see a liquid tank.
4. Pour bubble liquid into the liquid tank, being creful not to
exceed the maximum fluid level. DO NOT OVERFILL.
5. When the container is full, Lower the housing and tighten the
screws.
Important Safety Notice
Ensure your bubble machine is unplugged from the mains
electrical supply before attempting to open the housing.
To help avoid accidental exposure to dangerous live AC mains
voltage, two safety screws are fitted that require a screwdriver
to remove. Once these are removed, the screws are removed; the
finger screws can e undone by nand.
Once the screws are removed, the lid of the housing can be
carefully swung upwards, as shown above. Take care not to spill
any of the bubble fluid inside the unit.
The fluid tank is designed to fit only one way around. Make
sure you insert it corredtly, as shown above, Take care not to
spill any of the bubble fluid inside the unit.
Never aim the output at open flames.
Position output of bubbles away from persons

Operation
Turn on the power switch located on the back of the bubble machine.
You will notice that the intemal bubble drum and fan are activated.
Bubbles are now produced.
Display Control
d001
d512
3CH
A001
A512
7CH
FF01
FF99
Color change model 1
CC01
CC99
Color change model 2
r000
UP key: select color
Select color
G000
DOWN key: select LED brightness
b000
MANU key: ESC/SHIFT
V000
ENTER key: save
SoUd
SoUd
SOUND CONTROL
SLAv
SLAv
SLAVE CONTROL
7 Channels
Channel
Function
CH1
0--255
Dimmer
CH2
1--255
Red
CH3
1--255
Green
CH4
1--255
Blue
CH5
0--255
Strobe (from slow to fast)
CH6
0--255
Auto model speed

CH7
0--49
Empty
50--100
Auto Function 1
101--150
Auto Function 2
151--200
Auto Function 3
201--255
Sound control
3 Channels
Channel
Function
CH1
1--255
Red
CH2
1--255
Green
CH3
1--255
Blue