Sound Sation LBM-300 User manual

Product Instruction
LBM-300
300W Large Bubble Machine
PLEASE READ OVER THIS MANUAL BEFORE OPERATION THE MACHINE

Introduction
Thank you for choosing this Bubble Machine. You now own a rugged and powerful
state-of-the-art machine. Prior to use, we suggest that you carefully read all of the
instructions. By following the suggestions found in this user manual, you can look
forward to exceptional performance from your Bubble Machine for years to come.
Please follow these operation, safety and maintenance instructions to ensure along
and safe life for your Bubble Machine.
Specifications
Rrmote Control
High of Blow: 10m-15m
Weight: 14kg
Voltage: 220-250v 50/60Hz
Power: 300W
Size: 45*39*41cm
Unpacking & Inspection
Open the shipping carton and check that all equipment necessary to
operate the system has arrived intact. In addition to the Bubble Machine,
you should receive the following items:
1. 1.This user manual.
2. 2.Power cord and plug.
Before beginning initial setup of your Bubble Machine, make sure that
there is no evident damage caused by transportation.
In the event that the unit’s housing or cable is damaged, do not plug it in
and do not attempt to use it until after contacting your dealer for assistance.

Set up
1. 1.Remove all packing materials from the bubble machine.
2. 2.Place buble machine on a flat surface.
3. 3.Loosen the side screws and lift the housing upwards. You will see a
liquid tank.
4. 4.Pour bubble liquid into the liquid tank, being creful not to exceed the
maximum fluid level. DO NOT OVERFILL.
5. 5.When the container is full, Lower the housing and tighten the screws.
Important Safety Notice
Ensure your bubble machine is unplugged from the mains electricalsupply
before attempting to open the housing.
To help avoid accidental exposure to dangerous live AC mains voltage,
two safety screws are fitted that require a screwdriver to remove. Once
these are removed, the screws are removed; the finger screws can e undone
by nand.
Once the screws are removed, the lid of the housing can be carefully
swung upwards, as shown above. Take care not to spill any of the bubble
fluid inside the unit.
The fluid tank is designed to fit only one way around. Make sure you insert
it corredtly, as shown above, Take care not to spill any of the bubble fluid
inside the unit.
Never aim the output at open flames.
Position output of bubbles away from persons
Operation
Turn on the power switch located on the back of the bubble machine. You will
notice that the intemal bubble drum and fan are activated. Bubbles are now
produced.