Spa Electrics Atom Use and care manual

BULB REPLACEMENT

1. Push and hold red button with flat head screwdriver.
2. While continuing to hold button, rotate counter-clockwise &
remove bulb from locking ring.
3. Remove plug from light.
Unscrew 3x fasteners
using No. 2 Phillips
head screwdriver.
Rotate and release light
from niche.
There is enough cable in
niche to pull light to pool
surface/deck level.
Hold down button with flat
head screwdriver.
For Vinyl/Fibreglass lights, snap off clear
plastic trim ring and replace onto new bulb.

4. Attach new bulb.
Attach bulb with
same 3 screws using
a No. 2 Phillips head
screwdriver.
1
2
5. Insert bulb back into locking ring and rotate clockwise
until bulb clicks/locks into place.
WINTERIZING: Follow steps 1 - 3 and install enclosed red
winterizing cap to replace bulb. Store bulb indoors to opti-
mize product longevity.
1. Attach terminal cover to plug using No. 2
Phillips head screwdrivier.
2. (Recommended) Store plug within niche
during winter period.
For syncing light with automation please see our Multi Plus Set Up guide
enclosed or visit spaelectrics.ca for tutorials.

www.spaelectrics.ca
ATOMBULBCAP-MANUAL