Speco DD1 Datasheet

DD1
INSTALLATION &
QUICK START GUIDE
Please read this manual carefully before operating the unit and keep it for further reference.
All specifications and design are subject to change without notice.

Important Safeguards and Warnings
1．Electrical safety
•All installation and operation here should conform to local electrical safety codes.
•This device requires PoE 803.3af or higher to function.
•Improper handling and/or installation could run the risk of fire or electrical shock.
2．Environment
•Heavy stress, violent vibration or exposure to water is not allowed during transportation, storage and
installation.
•This product should be installed in a cool, dry place away from direct sunlight and heat sources.
•Do not install the product in extreme temperature conditions.
•Do not expose the camera to electromagnetic radiation or it may result in CMOS sensor failure.
•Do not block any ventilation openings.
•Do not allow water and liquid intrusion into the camera.
3. Operation and Daily Maintenance
•Please shut down the device and then unplug the power cable before you begin any maintenance work.
•Do not touch the CMOS sensor optic component. You can use a blower to clean the dust on the lens
surface.
•Always use the dry soft cloth to clean the device. If there is too much dust, use a cloth dampened with a
small quantity of neutral detergent. Finally use the dry cloth to clean the device.
•Please use a professional optical cleaning method to clean the enclosure. Improper enclosure cleaning
(such as using cloth) may result in poor IR functionality and/or IR reflection.
Warning
•This camera should be installed by qualified personnel only.
•All the examination and repair work should be done by qualified personnel.
•Any unauthorized changes or modifications could void the warranty.
Statement
•This guide is for reference only.
•Product, manuals and specifications may be modified without prior notice. Speco Technologies reserves
the right to modify these without notice and without incurring any obligation.
•Speco Technologies is not liable for any loss caused by improper operation.

Tools needed:
1 Phillips head screwdriver (not included)
4 mounting screws and anchors
Installation steps
1. Remove the 4 cover screws (figure 1)
2. On the back of the cover, you will find a shunt and header pins. Use the shunt to set your
desired audio broadcast (figure 2).
Header 2-“You are currently trespassing, and the authorities have been notified. Please leave the area
immediately!”
Header 0 -“Warning, you are under surveillance”-2x
Header 1 -“You have entered a restricted area. Video surveillance is in use.”

3. Please ensure all connections inside the DD1 box are made:
-RJ45 network connector
-Alarm output cord
-12V/DC power cord
Diagram inside the DD1

4. When mounting the DD1, locate the mounting holes (Please refer to the DD1 diagram if
needed), and use the 4 mounting screws and anchors when mounting the camera to a surface.
Screw the cover plate back on once the camera is mounted.
5. On the outside of the box please pull the rubber enclosure off, and you will see that it’s an RJ45
connection on the box. Go ahead and plug a network cable into the RJ45 connection. Now the installation
of the DD1 should be complete.
Operation
1) Once the camera is connected to a PoE source, you are now able to log into the camera through
a web browser.
2) If you are having an issue connecting to the camera make sure the PC and the IP-camera are
connected on the same local network. The camera is set to DHCP by default, and will be
assigned an IP address by the DHCP server. Make sure that the local network has a DHCP server.
Routers typically have a DHCP server built in. Install the IP scanner from the CD and run it after
installation. The IP scanner tool for discovering the IP cameras on the local network.
*Model numbers may vary.