Sper scientific 840005 User manual

SOUND METER
840005
Instruction Manual
SPER
SCIENTIFIC

- 2 -
Introduction: Use to measure sound
levels in the workplace, environmental
noise pollution, QC inspection of
products, background sounds, traffic
and more. Uses the "A" decibel
frequency weighting. CE Approved.
Operating Procedures:
Sound Measurement: Set the DIAL
to either Lo or Hi and read your
results on the matching scale.
Battery Check: Set the dial to
BATT. If the reading is not in the
B. OK zone, replace the battery
with a new 9V battery.
Internal Calibration: Set the
DIAL to CAL and use a small
screwdriver to turn the CAL ADJ
calibration screw until the
indicator points to CAL 70 dB.
Tips on Measuring Sound:
From Objects: Place the meter 40”
from the source.
Traffic Sounds: Place the meter
40~60” above ground level.
Indoor Sounds: Place the meter in
the center of the room.
Intermittent Sounds: Record the
highest value at each occurrence
and compute the average.
Fluctuating Sound: Record
several measurements and
compute the average.

- 3 -
Panel Description:
1. SENSOR
2. LOW VALUE SCALE 40~80 dB
3. CAL 70 dB
4. BATTERY CHECK
5. HIGH VALUE SCALE 80~120dB
6. DIAL
7. CAL ADJ (calibration screw is located
inside the battery compartment)
OFF
Lo
Hi
CAL
BATT
OFF
1
2
3
4
5
6
7
L
CAL

- 4 -
Rev. 05/11/05
Dimensions 61/4 x 21/2 x 11/2"
16 x 6.4 x 4 cm
Weight
inc. battery 7.1 oz, 202 g
Ranges 40 ~ 80 dB, 80 ~ 120 dB
Microphone Capacitance
Accuracy ±3 dB
Calibration Signal Oscillator
Power One 9V battery
Specifications:
5 YEAR METER WARRANTY
Sper Scientific warrants this product against
defects in materials and workmanship for a
period of five (5) years from the date of
purchase, and agrees to repair or replace any
defective unit without charge. If your model has
since been discontinued, an equivalent Sper
Scientific product will be substituted if available.
This warranty does not cover probes, batteries,
or damage resulting from accident, misuse, or
abuse of the product. In order to obtain
warranty service, simply ship the unit postage
prepaid to:
SPER SCIENTIFIC LTD.
7720 E Redfield, Suite 7, Scottsdale, AZ 85260,
480/948-4448, [e-mail]
www.sperscientific.com
The defective unit must be accompanied by a
description of the problem and your return
address. Register your product online or return
your warranty card within 10 days of purchase.