Spinmaster Monster Jam Megalodon Storm User manual

INDOOR / OUTDOOR
CAUTION:
HAIR ENTANGLEMENT —
Tie back and cover hair and secure
loose clothing prior to play.
!
Frequency Band(s): 2.411−2.472GHz Maximum radio frequency power transmitted: <10dBm
Spin Master International SARL hereby declares that the radio
equipment type MEGALODON STORM™ is in compliance with
Directive 2014/53/EU. The full text of the EU declaration of
conformity is available at the following internet address:
http://doc.spinmaster.com
• Do not change or modify anything on the toy.
Before first use: Read the user's information together with your child.
SPIN MASTER LTD., 225 KING STREET WEST, TORONTO, ON M5V 3M2 CANADA
Imported into EU by SPIN MASTER INTERNATIONAL, B.V., Kingsfordweg 151, 1043 GR Amsterdam, The Netherlands
Spin Master logo & © Spin Master Ltd. All rights reserved. Retain this information, addresses and phone numbers for future reference. Content may vary from
pictures. Keep away from obstacles and electrical hazards.
Spin Master Ltd. reserves the right to discontinue the www.monsterjamrc.com website at any time. MADE IN CHINA
Imported by Spin Master Australia Pty Ltd, Suite 101, Level 1, 18-24 Chandos Street, St Leonards, NSW 2065; 1800 316 982
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
WWW.MONSTERJAMRC.COMWWW.SPINMASTER.COM
MONSTERJAMRC.COM
For in-depth video instructions go to
Not Included
xAAA(LR03)
1.5 V
1,5 V
2
T66807_0001_20122967_GEN_IS_R3
a WARNING: CHOKING HAZARD – Small parts.
Not for children under 3 years.
Battery requirement for toy
Power Supply:
Rating: 6.4V 700mAh
Battery: 1 x 6.4V 700mAh LiFePO4
Rechargeable Battery Pack
Requires: 1 x 6.4V 700mAh LiFePO4
Rechargeable Battery Pack
Battery requirement for controller
Power Supply:
Rating: DC 3 V, 0.45 W
Batteries: 2 x 1.5 V AAA (R03)
Requires 2 x 1.5 V AAA size batteries
(not included)
NOTE: If normal function of the product is disturbed or interrupted, strong electromagnetic interference may be causing the issue. To reset product, turn it completely off, then turn it back on. If normal operation
does not resume, move the product to another location and try again. To ensure normal performance, change the batteries, as low batteries may not allow full function.
SAFETY PRECAUTIONS: - Keep hands, hair and loose clothing away from the motor/ wheels when power switch is turned ON. - Remove battery(s) from controller when not in use. - Parental guidance is
recommended for the play. - Keep your toy in your sight so that you can supervise it all the time. - New alkaline batteries are recommended for use in controller to obtain maximum performance. - Users should
keep stric
t accordance with the instruction manual while operating the product.- Your controller/charger is tailor-made for the LiFeP04 rechargeable battery used in your vehicle. Do not use it to charge any battery
other than that in the toy. Note: Parental guidance is recommended when installing or replacing batteries. Under the environment with electrostatic discharge, the toy may malfunction and require user to reset the toy.
SPECIAL NOTE TO ADULTS: Regularly examine for damage to the plug, enclosure and other parts. In the event of any damage, the toy must not be used with the charger until the damage has been repaired. This
toy is not intended for children under 3 years old. This toy must only be used with the recommended charger.
CONTAINS 1 X 6.4V 700mAH LiFe BATTERY PACK (included) AND REQUIRES 2 x 1.5V AAA (LR03) BATTERIES (Not Included).
Batteries or battery packs must be recycled or disposed of properly. When this product has reached the end of its useful life, it should not be disposed of with other household waste. The
Waste Electrical and Electronic Equipment Regulations require it to be separately collected so that it can be treated using the best available recovery and recycling techniques. This will
minimize the impact on the environment and human health from soil and water contamination by any hazardous substances, decrease the resources required to make new products and avoid
using up landfill space. Please do your part by keeping this product out of the municipal waste stream! The “wheelie bin” symbol means that it should be collected as “waste electrical and
electronic equipment”. You can return an old product to your retailer when you buy a similar new one. For other options, please contact your local council.
PRODUCT BATTERY REMOVAL INSTRUCTIONS: Internal battery is factory installed and non-replaceable. Product disassembly and battery removal must be performed by an adult. Do not puncture, cut, tear,
compress or deform product during disassembly. Ensure product is turned off, then use a screw driver to remove screw. Lift end of battery compartment and slide out battery. Dispose of battery in accordance
with your local battery recycling or disposal laws.
NOTE: Opening of product will render product inoperative and voids manufacturer warranties. Dispose of remaining product components in accordance with local laws.
This toy is equipped with a Lithium ion battery.
SPECIAL LIFE BATTERY INSTRUCTIONS: Never charge battery unattended. - Charge battery in an isolated area. Keep away from flammable materials. - Do not expose to direct sunlight. There is a risk of the
batteries exploding, overheating, or igniting. - Do not disassemble, modify, heat, or short-circuit the batteries. Do not place them in fires or leave them in hot places. - Do not drop or subject to strong impacts. - Do
not allow the batteries to get wet. - Only charge the batteries with the specified Spin Master™ battery charger. - Only use the batteries in the device specified by Spin Master™. - Carefully read the instruction guide
and use the batteries correctly. - In the unlikely event of leakage or explosion use sand or a chemical fire extinguisher for the battery. - Batteries must be recycled or disposed of properly.
CARE AND MAINTENANCE: Always remove batteries from the toy when it is not being used for a long period of time (controller only). Wipe the toy gently with a clean damp cloth. Keep the toy away from direct
heat. Do not submerge the toy in water. This can damage the electronic assemblies.
BATTERY SAFETY INFORMATION: Requires 2 x 1.5 V AAA (LR03) batteries. Batteries are small objects. Replacement of batteries must be done by adults. Follow the polarity (+/-) diagram in the battery
compartment. Promptly remove dead batteries from the toy. Dispose of used batteries properly. Remove batteries for prolonged storage. Only batteries of the same or equivalent type as recommended are to be
used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (i.e. alkaline/standard/rechargeable). Using
rechargeable batteries is not recommended due to possible reduced performance. Rechargeable batteries are only to be charged under adult supervision. Replaceable-rechargeable batteries are to be removed
from the toy before being charged. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.
FCC STATEMENT: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for Class B digital devices pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference to radio communications. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this toy does cause
interference to radio or television reception (you can check this by turning the toy off and on while listening for the interference), one or more of the following measures may be useful:
• Reorient or relocate the receiving antenna.
• Increase the separation between the toy and the radio or the TV.
• Consult the dealer or an experienced TV-radio technician for help.
• Shielded cables must be used with this unit to ensure compliance with the Class B FCC limits.
NOTE: Changes, adjustments or modifications to this unit, including but not limited to, replacement of any transmitter component (crystal, semiconductor, etc) could result in a violation of FCC rules under part 15
and/or 95 and must be expressly approved by Spin Master Ltd or they could void the user’s authority to operate the equipment. Spin Master Inc., PMB #10053, 300 International Drive, Suite 100, Williamsville, NY
14221. To contact the responsible party please visit fcc.spinmaster.com
-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
© 2020 Feld Motor Sports, Inc. MONSTER JAM®, UNITED STATES HOT ROD ASSOCIATION, MEGALODON STORM are trademarks of and used under license by FMS. All rights reserved.
NORTH AMERICA – 1-800-622-8339
[e-mail]
UK – 0800 206 1191, [e-mail]
IRELAND – 1800 992 249
AUSTRALIA –1800 316 982, [e-mail]
WWW.SPINMASTER.COM
YRS
4+
POWER SWITCH
CHARGING CABLE
COMPARTMENT
CONTENTS
1 x Megalodon
Storm™ 1 x Controller
1:15
TH
Scale
INDOOR / OUTDOOR
CAUTION:
HAIR ENTANGLEMENT —
Tie back and cover hair and secure
loose clothing prior to play.
!
TM
WWW.MONSTERJAMRC.COMWWW.SPINMASTER.COM
Included
x
AAA (R03)
1.5V
1,5V
2
1:15
TH
Scale
TM
TM
NORTH AMERICA – 1-80 0-622-8339
[email protected]
UK– 0800 206 1191,[email protected]
IRELAND – 1800 992 2 49
AUSTRALIA –1800 316 982, [email protected]
WWW.SPI NMASTER.CO M
YRS
4+
DRIFTADJUSTER
POWERSWITCH
CHARGINGCABLE COMPARTMENT
1 x Instruction Guide
CAUTION: CARE SHOULD BE USED WHEN OPERATING VEHICLE IN WATER. ADULT SUPERVISION ADVISED.
TM

23
HOW TO INSTALL BATTERIES
HOW TO CHARGE
HOW TO DRIVE
DRIVING ON WATER
HOW TO FIX DRIFTING
12 3
1. Open the battery door with a screwdriver.
(A). If used batteries are present, remove
these batteries from the unit by pulling up on
one end of each battery. DO NOT remove or
install batteries using sharp or metal tools.
2. Install new batteries as shown in the
polarity diagram (+/-) inside the battery
compartment.
3. Replace battery door securely. Check your
local laws and regulations for correct recycling
and/or battery disposal.
1. Turn the vehicle off. 2. Remove the cover by turning the screw or
flipping the latch to the left.
3. Plug the charging cable into a 5VDC
computer outlet.
4. Charging LED indicates charging. Flashing for
charging and ON when fully charged.
5. ALWAYS REMEMBER to return charging
cable and close cover by turning screw or
flipping latch to the right.
1 2 3
4 5
NOTE: If your truck does not connect to the controller the first time, turn the truck off, turn the controller off and repeat
the HOW TO DRIVE instructions.
CONTROLLER NOT CONNECTING
OUT OF RANGE / LOW BATTERY
CONNECTING THE CONTROLLER
1. Turn on the vehicle and place on a flat
surface.
2. Hold the controller near your truck, press
the power button wait until power light
stops flashing.
3. You are ready to drive.
4. Use the remote control to drive.
1 2 3
A
2
NOTE:
THE CHARGING CABLE
STORAGE
COMPARTMENT MUST
BE FIRMLY CLOSED
BEFORE PLAY TO
ENSURE WATER TIGHT
SEAL.
NOTE:
Before driving on water ENSURE THE CHARGING CABLE STORAGE
COMPARTMENT IS FIRMLY CLOSED.
There is no additional preperation required to drive on water.
Fully submerging the vehicle in water is not recommended.
1. Controller will beep when you are close to driving out of
range.
2. Turn and return to you until beeping stops.
3. If beeping continues this indicates low battery.
4. Return and immediately fully charge the vehicle.