SprintRay ProCure2 User manual

Touchscreen
Curing Drawer
Power Port
Power Switch
Level
Surface
USB Cable
With USB type C adapter
Power Cable
Curing Tray
Refer to section 5
ProCure 2 Onboarding Card
High-Speed Post Curing System Designed for Digital Dentistry
Quick Start Guide
Congratulations!
In this brief guide, you’ll learn how to set up and use your
ProCure 2 post-curing system.
Please follow the instructions carefully and visit our
webiste for tips & tricks.
We’re so excited to see what you make!
Training and Support
Contact our team of support technicians
with questions.
In the Box
Situate ProCure 2 in a well-ventilated
area on a flat, level surface. Keep it away
from extreme temperatures, windows,
and direct sunlight.
Hot air exhausts through ventilation
located on the back and bottom of
ProCure 2. Do not obstruct.
Where to Set Up
Plug in ProCure 2
Use the provided power cable to plug ProCure 2
into a surge protector or uninterrupted power
supply. Turn it on by flipping the power switch
located on the back of the unit.
To perform a reset, use the power switch or
disconnect ProCure 2 from its power source.
Recommended
Operating Temperature
Min 21 °C
70 °F
Max 29 °C
85 °F
Uneven Surface
Warm Environment
1
2
3

USB Type C Port
For Manual Updates
A B A B
How to Operate
Pull on the handle to open the curing drawer. Place models on the
curing tray and close the drawer. Select desired material from the
touchscreen to begin the process.
Understanding Zone Selection
ProCure 2 can selectively cure the model tray to reduce time when
fewer models are being processed. You can select which zones to
cure from the touchscreen.
Zone A Only
If all your models fit
into Zone A, select
this to save time.
Zones A and B
If you are processing
a large number of models,
select Zone A and B.
Install Curing Tray
Using ProCure 2
Maintenance
Software Updates
ProCure 2 will periodically receive updates over the air via wireless network.
Ensure ProCure 2 is connected to the internet to receive updates.
Troubleshooting
Please call customer support to perform advanced troubleshooting. A USB cable
with a type C adapter is provided to connect ProCure 2 to your computer if needed.
WARNING
ProCure 2 may become warm to the touch during post-curing.
Do not obstruct the ventilation located on the rear and bottom of the unit.
Place Tray Inside Curing Drawer
Open the UV drawer by pulling on the handle.
Set the Curing Tray in the drawer so that it rests
inside the frame. Close the drawer slowly to ensure
the tray is properly in place.
Connect to a Wireless Network
Press the wireless connection icon using the touchscreen and follow
the steps to connect to your network. Firewall or antivirus software may
prevent ProCure 2 from establishing a reliable connection. Consult
SprintRay customer support if you need help connecting to a network.
Height Limit is 75 mm
Models inserted into ProCure 2 cannot exceed 75 mm in
height. Refer to the height limit indicator on the Curing
Tray to ensure optimal performance.
Height Limit
vs.
Do not try to close the curing drawer if
models exceed the height limit; this may
permanently damage ProCure 2.
Search for Materials
SprintRay Die and Model
SprintRay NightGuard Flex
SprintRay Surgical Guide 2
4
5
6
7